Search

High voltage direct current (HVDC) grids may be protected from dc faults through the application of HVDC circuit breakers. Recent advances in dc circuit breaker technologies may allow faults in the dc grid to be cleared without a permanent loss of power to the connected ac grids. The requirements for the protection have yet to be fully defined; especially where half-bridge modular multilevel converter (MMC) controls are concerned. This paper investigates integrating dc circuit breakers with half-bridge MMC converters, specifically looking to at how to recover from a pole-to-pole fault. The fault response of the converter to a fault is analyzed in depth. This analysis highlights key stages in the converter response to a dc fault, allowing the MMC fault currents to be predicted. This analysis is then verified in PSCAD simulations and the power flow recovery is shown. The converter controls are investigated, improvements made to the power flow recovery, and the need for arm current controllers highlighted. [ABSTRACT FROM PUBLISHER]

Circuit breakers for high voltage direct current (HVDC) applications are seen as a required technological step in the development of HVDC grids. The development of several new HVDC circuit breaker prototypes indicate that this step may be achieved in the years to come. In order to facilitate the installation of HVDC circuit breakers, appropriate standards and tests need to be developed. These tests and standards must ensure that the technology is capable of functioning as required. In cases where direct testing cannot be carried out, a synthetic test circuit is used to recreate the conditions of the power system. Testing envelopes which encapsulate the fault currents for two types of voltage source converter under fault conditions are analytically derived in this study and compared with simulations. Testing envelopes allow specifications for HVDC breaker test circuits to be defined. Discussion is also given to the worst type of fault and protection operation time estimates. [ABSTRACT FROM AUTHOR]

• Hybrid DC circuit breaker with coupled inductor enables automatic current commutation. • The current commutation is faster when the rate of rise of the fault current is higher. • Flexibility in the design of the coupled inductor for current commutation. • The prototype has successful interrupted 200 A DC current within 4 ms. • Very low operating loss hybrid DC circuit breaker topology. HVDC transmission systems using voltage source converters (VSC-HVDC) have been identified as an attractive solution for bulk power delivery over long distance. However if DC grids are to be built using this technology, fast DC circuit breakers are needed. This work proposes a new hybrid DC circuit breaker utilizing a series connected coupled inductor connected, which enables automatic current commutation from the mechanical switch to the semiconductor switch during a fault. The key advantage of the proposed DC circuit breaker is that the current in the mechanical switch automatically reduces to zero when a fault happens. This paper focuses on comparison of different mechanisms to commutate the current from the mechanical switch to the semiconductor switch and create a zero current for the mechanical switch. Three types of hybrid DC circuit breaker topologies including proactive hybrid DC circuit breaker, hybrid DC circuit breaker with commutation booster, and hybrid DC circuit breaker with coupled inductor for a 500 kV HVDC system are simulated and compared using Matlab/Simulink. A prototype hybrid DC circuit breaker with coupled inductor is designed and built. The prototype is capable of interrupting 200 A direct current within 4 ms. The automatic current commutation compensates for the fault detection and location time in the selective protection scheme, which provides faster fault current interruption. [ABSTRACT FROM AUTHOR]