Search

Purpose: The aim of this study was to describe the sagittal geometry of the trochlear groove in patients who underwent primary TKA, based on intraoperative data acquired with a navigation system., Methods: Intraoperative navigation data were collected from 110 patients. All operations were guided by a non-image-based navigation system (BLU-IGS, Orthokey Italia Srl). The trochlear groove has been described on the three anatomical planes; in particular, on the sagittal plane the hypothesis has been verified that the acquired points are referable to a circle. Using the data collected during intraoperative navigation, possible correlation between the radius of the trochlear groove and other femur dimension (length, AP dimension) was analyzed; the orientation of the trochlear sulcus with respect to the mechanical axis and the posterior condyle axis was analyzed too, searching for possible correlation between groove alignment (frontal and axial) or groove radius and the hip-knee-ankle (HKA)., Results: The average radius of curvature of the femoral trochlea was 25.5 ± 5.6 mm; the difference was not statistically significant between the men and women (n.s. p value). No correlation was found between the trochlear groove radius and the femur length (r = - 0.02) or the HKA-phenotypes (r = 0.03) and between the groove alignment and HKA-phenotypes. On axial plane, the trochlear groove was 3.2° ± 4.3° externally rotated, with respect to the posterior condylar axis; on frontal plane, the trochlear groove was 3.9° ± 5.3° externally rotated, with respect to the mechanical axis. In both cases, no statistically significant differences were found between male and female and between left and right limb (p > 0.05)., Conclusion: The present study shows that the sagittal plane geometry of the femoral trochlea in patients affected by osteoarthritis could be described accurately as a circle. The acquisition of the trochlear morphology intraoperatively can lead to more anatomically shape definition, to investigate deeper its radius of curvature and geometry. Trochlear shape could be used as landmarks for femoral component positioning, thus customizing the implant design, optimize the outcomes and improving anterior knee pain after TKA., Level of Evidence: IV.

Purpose: The restoration of the physiological femoro-tibial joint line (JL) is important to obtain a good outcome in revision total knee arthroplasty (RTKA). However, its assessment is challenging. The ratio of the distance between the adductor tubercle (AT) JL (ATJL) and the trans-epicondylar femoral width (FW) was proposed as a reliable method. The purpose of this study was to check whether this ratio is a reliable tool to restore the prosthetic JL height in challenging prosthetic revision cases., Methods: Twenty-one patients (mean age 65.8 years) were recruited. During surgery, FW was measured and ATJL distance was calculated using 0.53 (SD 0.03) as the ratio. After implant positioning, the obtained ATJL line was measured to verify the accuracy of the surgical procedure. Thirteen patients presented a healthy contralateral knee: a comparative radiograph examination was performed to verify the appropriateness of the restored JL height., Results: The intra-operatively calculated ATJL was not significantly different with respect to the measured ATJL obtained after prosthetic component implantation. The comparative analysis between the restored JL and the JL of the contralateral not operated knee was also not statistically significant, thus confirming the appropriateness of the restored JL height., Conclusions: This study shows that the method which uses an AT to JL distance/FW ratio to determine the JL level, previously applied in primary TKA, is valid when using intra-operatively acquired measurements in RTKA. This is clinically relevant since it represents a reliable tool which helps surgeons to restore the JL level in challenging prosthetic revision cases., Level of Evidence: Case series, Level IV.

Purpose: The ratio of femoral width and distance from medial epicondyle to joint line helps estimate the femoral joint line position from femoral width. The approximately radial position of the medial epicondyle on femoral condyle spheres is probably responsible for this relationship, The adductor tubercle approximately lies diametrically opposite to the joint line on condylar sphere. Then, a linear correlation could also exist between the femoral width and distance of adductor tubercle to joint line and is the purpose of the current study., Methods: Femoral width, along with the distance to joint line from the medial epicondyle, the adductor tubercle and fibular pole, was measured on 110 standard antero-posterior knee radiographs. Correlation between femoral width and these measurements was evaluated. The individual ratio of FW with adductor tubercle joint line, medial epicondyle joint line and fibula joint line was calculated using linear regression analysis. Intra-observer and inter-observer reliability was assessed., Results: Linear correlation was found between femoral width and distance of adductor tubercle to joint line (r = 0.83). It was more reliable than the correlation between femoral width and distance from medial epicondyle to joint line (r = 0.52). Inter-observer repeatability was better for distance from adductor tubercle to joint line than for distance from medial epicondyle to joint line., Conclusions: We conclude that adductor tubercle can be used as a morphologic landmark to determine the knee joint line position, because a linear correlation between femoral width and distance from the adductor tubercle to the joint line was found.

Purpose: The purpose of this study was to evaluate the biomechanical results from the in vitro reconstruction of medial patellofemoral ligament (MPFL) using a navigation-assisted technique on a cadaveric model and its effects on patellar stability and kinematics. The authors investigated the hypothesis that patellar kinematics after reconstruction with a tubular graft are not optimal when compared with the original fan-shaped MPFL., Methods: In six fresh-frozen cadaveric knees, lateral loads (25 N) were applied on the patella at 0°, 30°, 60° and 90° of knee flexion in three different MPFL states: intact, cut and reconstructed. The arrangement allowed positional measurements of patellar motion to be tracked in six degrees of freedom. Medial to lateral patellar translation and patellar tilt were recorded. The kinematics after a technique of MPFL reconstruction, performed with a gracilis tendon in a blind femoral tunnel guided by navigation, were compared against kinematics recorded in the MPFL intact state. A temporary fixation of adequate tension to engage the lateral patellar facet in extension was applied to the MPFL and, after graft cycling, the final fixation was done at 70° knee flexion with an interference screw., Results: There was a comparable medial to lateral patellar translation and tilting of the patella in the MPFL-intact and the MPFL-reconstructed state. Static patellar translation in the MPFL-reconstructed state, with and without the application of load, was comparable to patellar translation in the MPFL-intact state. The dynamic patellofemoral shift kinematics recorded an under-constraint in early flexion and over-constraint in late flexion, while an opposite effect was recorded in patellar tilt. However, these differences were not statistically significant., Conclusion: The study confirmed the major role of the MPFL in case of medial loading between 0° and 60°, by focusing on the importance of kinematically identifying the proper femoral point for fixation. While the study demonstrates the importance of kinematic determination of the proper femoral point of fixation, as the anatomical insertion remains difficult to identify. Even in dissected cadavers, the authors recorded a slightly anterior placement than native MPFL. After reconstruction, patellar stability in terms of lateral translation and tilt was similar to the intact MPFL, but patellar kinematics were not optimal with the use of a smaller and tubular graft than the native wider and fan-shaped MPFL.

Purpose: The goal of this study was to compare three types of mobile-bearing posterior cruciate ligament (PCL)-sacrificing TKA. The hypothesis was that the three designs provide differences in flexion stability and femoral rollback and improved clinical score at 2-year follow-up. Methods: Three groups of patients, divided according to implant design, were analysed retrospectively. All operations were guided by a non-image-based navigation system that recorded relative femoral and tibial positions in native and implanted knees during: passive range of motion and anterior drawer test at 90° flexion. WOMAC, KSS and SF36 scores were collected pre-operatively and at 2-year follow-up. Results: There are no differences in kinematic or clinical performance of the three implants, except for the antero-posterior translation during stress test in flexion: only Cohort B had comparable pre- and post-operative laxity test values ( p < 0.001). All three TKA designs allowed to maintain pre-operative tibial rotation pattern through all range of knee flexion. All clinical scores of the three patient cohorts were significantly improved post-operatively compared to the pre-operative values ( p < 0.001). Moreover, we found no differences among post-operative results of the three designs. Conclusion: Despite design variations, mobile-bearing PCL-sacrificing TKA reproduces femoral rollback and screw-home with little or no difference in clinical or functional scores at a follow-up of 2 years. Level of evidence: III. [ABSTRACT FROM AUTHOR]

Purpose: The purpose of this study was to compare subjective, objective and radiographic outcome of the lateralized single-bundle bone-patellar tendon-bone autograft with a non-anatomical double-bundle hamstring tendons autograft anterior cruciate ligament (ACL) reconstruction technique at long-term follow-up. Methods: Seventy-nine non-consecutive randomized patients (42 men; 37 women) with unilateral ACL insufficiency were prospectively evaluated, before and after ACL reconstruction by means of the above-mentioned techniques, with a minimum follow-up of 8 years (range 8-10 years; mean 8.6 years). In the double-bundle hamstrings technique, we used one tibial and one femoral tunnel combined with one 'over-the-top' passage, cortical staple's fixation and we left intact hamstrings' tibial insertion. Patients were evaluated subjectively and objectively, using IKDC score, Tegner level, manual maximum displacement test with KT-2000™ arthrometer. Radiographic evaluation was performed according to IKDC grading system, and re-intervention rate for meniscal lesions was also recorded. Results: The subjective and objective IKDC were similar in both groups while double-bundle hamstrings group showed significantly higher Tegner level ( P = 0.0007), higher passive range of motion recovery ( P = 0.0014), faster sport resumption ( P = 0.0052), lower glide pivot-shift phenomenon ( P = 0.0302) and lower re-intervention rate ( P = 0.0116) compared with patellar tendon group. Radiographic evaluation showed significant lower objective degenerative changes in double-bundle hamstrings group at final follow-up ( P = 0.0056). Conclusion: Although both techniques provide satisfactory results, double-bundle ACL reconstruction shows better functional results, with a faster return to sport activity, a lower re-operation rate and lower degenerative knee changes. [ABSTRACT FROM AUTHOR]

We performed a retrospective clinical and radiographic evaluation of 83 nonconsecutive patients operated in our institute between February 1996 and March 2003 with a mean follow-up of 60 months to assess the efficiency of unicompartmental knee replacement (UKR) performed with a minimally invasive technique. The aim of this study was to correlate the clinical outcome with the pre- and post-operative alignment and with implant positioning on coronal and sagittal plane. Eighty-three nonconsecutive patients (60 males, 23 females) underwent cemented UKR (De Puy Preservation Uni with all-poly tibial component), for both medial OA (80 patients) and AVN of the medial femoral condyle (3 patients). All patients were available at final follow-up evaluation, and they all presented an evident varus alignment at pre-operative clinical and radiographic evaluation. At radiographic measurement, we considered a knee with femoro-tibial angle (FTA) > 175° as varus knee, 170° < FTA < 175° as normal knee and a knee with a FTA < 170° as a valgus knee. Moreover, we considered a tibial plateau angle (TPA) > 90° for valgus knee and a TPA < 90° for varus knee. According to Hospital for Special Surgery (HSS) scoring system, at a mean follow-up of 60 months, 61 (74%) cases were excellent (100-85 points), 15 (18%) cases were good (84-70 points) and 7 cases (8%) had fair results (<70 points). In our series, patients with an excellent clinical result presented a mean varus deformity of 7.2° (3.6°–10.8°) pre-operatively. According to literature, we demonstrated that a small amount of undercorrection with a small amount of residual varus deformity of 3°–5° is the goal to be reached in order to avoid both rapid degeneration of the nonreplaced compartment and the premature loosening of the replaced compartment. We performed a mean axial correction of 5° (SD 3.9°), leaving a mean axial varus deformity of 2.2° in the excellent group. In our series, the group with excellent results also showed a post-operative PTS of 7° (2.4°–11.6°), while mean pre-operative PTS was 6.5° (2.7°–10.3°). In this study, results have shown that minimally invasive UKR producing a small amount of varus undercorrection in selected patients with medial tibio-femoral osteoarthritis or moderate avascular necrosis of the medial femoral condyle provides excellent clinical and functional results. Overcorrection of varus malalignment with a UKR may produce both rapid degeneration of the lateral tibio-femoral compartment and the early failure of the replaced compartment. [ABSTRACT FROM AUTHOR]