Search

Twelve ITER-like plasma-facing units made of tungsten were exposed in the WEST tokamak divertor, with three plasma-facing units (PFUs) significantly overexposed to plasma heat flux: one sharp-edged PFU (vertical misalignment h = 0.8 mm) and two chamfered PFUs (h =0.6 mm and 0.3 mm, respectively). This paper describes the first temperature analysis obtained with a very high spatial resolution infrared camera (pixel size ∼ 0.1 mm) on the misaligned PFU edges and shows the consistency obtained on the parallel heat flux derived from these measurements. The analysis is focused on the hottest areas of the PFU misaligned leading edges, since the temperature detection threshold of the VHR camera is high (Tthreshold,BB ≈ 370 °C). The heat flux parallel to the magnetic field lines is assessed by matching the toroidal temperature profile in the vicinity of the leading edge with 3D finite element modelling. The tungsten emissivity assumed in this study is 0.6, which is consistent with laboratory measurements for damaged PFUs. For the three PFUs studied (with different vertical misalignments, incident angles, geometries), the derived parallel heat flux is similar, and consistent with independent measurements by a Fiber Bragg grating embedded in a graphite PFU at another toroidal location, giving confidence in future experiments using the same settings. [ABSTRACT FROM AUTHOR]

Measuring the temperature in plasma-facing components (PFCs) provides information both on plasma parameters in the divertor region and on the thermal stress experienced by PFCs. Fiber Bragg gratings (FBGs) are interesting candidates for this application because they are immune to electromagnetic interferences and their ability to be multiplexed allows an extended spatial coverage. Four fibers, each of them including eleven regenerated Bragg gratings, have been embedded in tungsten-coated graphite components and operated up to their signal-collapsing limit at 800 °C. Extending the measurement range towards higher temperatures increases the sensitivity to plasma parameters and allows withstanding higher energy experiments. To overcome thermal limitations, the system is up-graded using femtosecond laser inscribed fibers. In addition to their outstanding thermal stability, femtosecond FBGs benefit from higher signal-to-noise ratios than regenerated FBGs. The paper addresses femtosecond FBGs design and issues relative to their integration inside the actively cooled ITER-like PFCs of the WEST tokamak. The period and length of the gratings are designed to increase the number of measurement spots to fourteen gratings per fiber, regularly distributed over 17 cm, while ensuring robust detection even with strong thermal gradients (no overlapping or deformation of Bragg peaks). The system operates up to 1200 °C with gradients reaching 200 °C/mm perpendicularly and 40 °C/mm in parallel to the fiber. FBGs are inserted in actively cooled ITER-like PFCs through a 2.5 mm deep lateral groove localized at 5 mm beneath the top of bulk tungsten monoblocks. A PFC mock-up machined with a groove has been tested under HHF facility to assess the effect of the groove on monoblocks thermal behavior. The test demonstrates that machined monoblocks behave as expected from simulation and can withstand 20 MW/m2 heat flux (i.e. 1200 °C in the fiber) with 20 % overheating as compared to intact monoblocks. [ABSTRACT FROM AUTHOR]