Search

Spinopelvic parameters are vital components that must be considered when treating patients with spinal disease. Several finite element (FE) studies have explored spinopelvic parameters such as sacral slope (SS) and the impact on the lumbar spine, although no study has examined the effect on the hip and sacroiliac joint (SIJ) on varying SS angles. Therefore, it is necessary to have a biomechanical understanding of the impact on the spinopelvic complex. An FE lumbar, pelvis, and femur model was created from computed tomography scans of a 55-year-old female patient with no abnormalities. Three models were created: a normal model (SS = 26°), a model with high SS (SS = 30°), and a model with low SS (SS = 20°). These models underwent loading for flexion, extension, lateral bending, and axial rotation. Range of motion (ROM), intradiscal pressures, hip joint, and SIJ contact stresses were analyzed. The high SS model (SS = 30°) indicated the highest ROM in the L5-S1 (slip angle) level and the highest intradiscal pressures. The highest average hip and SIJ contact stresses were present in this model, although the low SS model (SS = 20°) in extension had the largest stresses for the hip and SIJ. The results provide evidence that patients with higher SS may be more prone to increased ROM at the slip angle (L5-S1). In addition, patients with higher SS were shown to have higher contact stresses on the hip joint and SIJ, potentially leading to SIJ dysfunction. Clinically, correcting lumbar lordosis including SS is important; however, a high SS may have a negative impact on the intervertebral disc, SIJ, and hip joint. [ABSTRACT FROM AUTHOR]

This finite element analysis aimed to investigate the effects of surgical procedures for cervical spine injury. A three-dimensional finite element model of the cervical spine (C2-C7) was created from computed tomography. This model contained vertebrae, intervertebral discs, anterior longitudinal ligament, and posterior ligament complex. To create the cervical spine injury model, posterior ligament complex and anterior longitudinal ligament at C3-C4 were resected and the center of the intervertebral disc was resected. We created posterior-only fixation (PF), anterior-only fixation (AF), and combined anterior-posterior fixation (APF) models. A pure moment with a compressive follower load was applied, and range of motion, annular/nucleus stress, instrument stress, and facet forces were analyzed. In all motion except for flexion, range of motion of PF, AF, and APF models decreased by 80%–95%, 85%–93%, and 97%–99% compared with the intact model. C3-C4 annulus stress of PF, AF, and APF models decreased by 28%–72%, 96%–100%, and 99%–100% compared with the intact model. Facet contact forces of PF, AF, and APF models decreased by 77%–79%, 97%–99%, and 77%–86% at C3-C4 compared with the intact model. Screw stress in the PF model was higher than in the APF model, and plate stress in the AF model was lower than in the APF model, but bone graft stress in the AF model was higher than in the APF model. Cervical stabilization was preserved by the APF model. Regarding range of motion, the PF model had an advantage compared with the AF model except for flexion. An understanding of biomechanics provides useful information for the clinician. [ABSTRACT FROM AUTHOR]