Search

In order to satisfy the increasing fabrication quality requirements of micro curved thin wall structures, deformation, burrs height and dimensional errors in micro-milling processes of curved thin walls are studied. At first, the finite element analysis of curved thin wall deformation is carried out, it shows that complex elastic-plastic deformation and recutting occur in each micro-milling layer. Appropriate radial depth of cut, smaller spindle speed and axial depth of cut are beneficial to reduce deformation. Then, the influence of key process parameters in micro-milling as the speed of spindle n, feed engagement fz, radial depth of cut ae and axial depth of cut ap on milling force (Fn), burrs height (H) and dimensional errors (△w) are analyzed using the response surface method (RSM). To facilitate the quantitative analyses, mathematical models of burrs height and dimensional errors are established considering the interactions and quadratic effects of key parameters. It shows that the interactions among key parameters cannot be ignored. Therefore, cutting parameters should be delicately selected. The multi-objective particle swarm optimization (MOPSO) experiments are carried out based on the established prediction model. The results show that the combination of the optimized parameters identified by this method can effectively reduce the burr height and the dimensional error. Finally, under the guidance of this method, high-quality curved thin wall parts are fabricated.

In order to improve the machining quality and reduce the dimensional errors of micro high-aspect-ratio straight thin walls, the on-line cutting parameter compensation device has been introduced and corresponding micromilling processes have been investigated. Layered milling strategies for the micromilling of thin walls have been modeled and simulated for thin walls with different thicknesses based on the finite element method. The radial cutting parameters compensation method is adopted to compensate the thin wall deformation by raising the radial cutting parameters since the thin wall deformation make the actual radial cutting parameters smaller than nominal ones. The experimental results show that the dimensional errors of the thin wall have been significantly reduced after the radial cutting parameter compensation. The average relative dimensional error is reduced from 6.9% to 2.0%. Moreover, the fabricated thin walls keep good shape formation. The reduction of the thin wall dimensional error shows that the simulation results are reliable, which has important guiding significance for the improvement of thin wall machining quality, especially the improvement of dimensional accuracy. The experimental results show that the developed device and the machining strategy can effectively improve the micromilling quality of thin walls.

Polyetheretherketone (PEEK) material has attracted attentions and studies in the medical field due to its excellent properties suitable for orthopedic, dental, and implant applications. In order to acquire the needed geometrical accuracy and surface finish for individual customizations of components made of PEEK material, milling process basics for PEEK material have been studied in this paper. The influences of milling parameters on milling forces and surface roughness are discussed based on single-factor and orthogonal milling experiments. It shows that the effects of cutting parameters on cutting forces are basically in accordance with that in the classical metal cutting theory. But the effects of cutting parameters on the surface roughness are different. Also the significance sequences of the key milling parameters on milling forces and surface roughness are identified. Furthermore, a finite element simulation model to estimate the milling force is established and successfully evaluated for customized applications.