Search

• An AP combination suitable for seven minor tobacco alkaloids analysis was first presented. • AP provides an overall improvement in ME correction for solvents and samples. • The quantitative results of samples are accurate in different experimental scenarios. • This method possessed good accuracy, precision, and long-term robustness. Tobacco alkaloids are important precursors of carcinogenic tobacco-specific nitrosamines. Therefore, accurate quantification of tobacco alkaloids is highly important. This study investigates the compensation effects of novel analyte protectants (APs) for matrix effects (MEs) to determine seven minor tobacco alkaloids (nornicotine, myosmine, anabasine, anatabine, nicotyrine, 2,3′-bipyridine, and cotinine) in mainstream cigarette smoke with high accuracy and robustness. By comparing the heights and shapes of the chromatographic peaks before and after the addition of APs to standard solutions prepared in dichloromethane and cigarette smoke solutions, the compensation effects of 12 APs and their combinations on the MEs of seven minor tobacco alkaloids were evaluated, and the best combination of 2-pyridylethylamine (2 mg/mL)+1,2-decanediol (1 mg/mL) was identified. This AP combination could effectively improve the shapes and increase the heights (by 7–371%) of chromatographic peaks for standard solutions prepared in dichloromethane and cigarette smoke solutions. Before the addition of this AP combination, the slope ratios of the calibration curves for two types of standard solutions of the seven target chemicals were 71.4–159.8%, while they were 87.4–105.6% after the addition, indicating that this AP combination reduced the matrix difference between pure solvent and cigarette smoke solution. After adding the AP combination, the standard curves of solutions prepared in dichloromethane showed good linearity (r 2 ≥ 0.999), the spiked recoveries were between 80.9% and 119.6%, and the inter- and intraday precisions were between 1.5–9.5% and 3.1–8.5%, respectively. Three commercial cigarette samples and one mixed standard solution were also tested under four different instrument working conditions to verify the long-term accuracy and ruggedness of the approach in routine real-world analysis of the method. The results showed that the RSD values were higher (3.5–25.4%) without the AP combination than that (<6.7%) with the AP combination. Because of its high accuracy, precision, and robustness, this method has good practical prospects. [ABSTRACT FROM AUTHOR]

• A GC-MS/MS combining with silylation method was developed to determine 171 hydroxyl flavour additives in cigarette smoke. • Silylation in combination with GC-MS/MS has advantages in terms of high selectivity and sensitivity. • The novel use of a fused silica splitter simplified installation of backflushing system and exhibited better performance. • This method possessed good accuracy, satisfactory sensitivity and long-term robustness. • The developed method was applied to 270 practical cigarette smoke samples and meaningful results of HFAs were obtained. Flavour additives with carboxyl and hydroxyl groups (FACHs), the key ingredients in characteristic flavours, are frequently detected in cigarette smoke. They are attracting increasing attention in regulating the flavour additives used in tobacco to curb youth tobacco use and prevent the use of additives that are harmful. In this study, a highly robust, sensitive, and precise method based on silylation and GC-MS/MS with an improved backflushing system was developed for the simultaneous analysis of 171 FACHs in cigarette smoke. Silylation has been shown to have advantages in terms of high selectivity and sensitivity to chemicals with carboxyl and hydroxyl groups, especially when combined with GC-MS/MS. The extraction and silylation conditions were optimised. Dichloromethane was used as the extraction agent. BSTFA in combination with 1% TMCS and 0.2% TMSI was selected as silylating agent for high silylation efficiency, particularly for hindered analytes. The method has been validated. The limit of detection (LOD) ranged from 0.6 to 332.3 ng/mL. 91.1% out of the analytes in QC samples had precisions lower than 10% during one month run. The improved backflushing system with a fused silica splitter was shown to be crucial in the excellent long-term robustness of the method. The developed method was used to determine flavour additives in 270 practical cigarette smoke samples with reliable results. A total of 154 FACHs were identified with wide-range levels among different cigarette brands. [ABSTRACT FROM AUTHOR]