Search

The integration of 2D materials into future applications relies on advances in their quality and production. We here report a synthesis method that achieves ultrahigh optoelectronic performance at unprecedented fabrication scales. A mediator-assisted chemical vapor deposition process yields tungsten-disulfide (WS2) with near-unity photoluminescence quantum yield, superior photosensitivity and improved environmental stability. This enhancement is due to the decrease in the density of lattice defects and charge traps brought about by the self-regulating nature of the growth process. This robustness in the presence of precursor variability enables the high-throughput growth in atomically confined stacks and achieves uniform synthesis of single-layer WS2 on dozens of closely packed wafers. Our approach enhances the scientific and commercial potential of 2D materials as demonstrated in producing large-scale arrays of record-breaking optoelectronic devices.

Pyrochlore titanate (Y2Ti2O7) is a promising material for a wide range of applications in optoelectronics and photocatalysis due to its advantageous chemical, mechanical, and optical properties. To enhance its potential for such uses, however, a high-quality and scalable synthesis method is required. We here investigate the crystallization of sol–gel produced Y2Ti2O7 layers. We observe a transition of the amorphous pyrochlore phase at annealing temperatures below 700 °C. The transmittances of the Y2Ti2O7 thin layers annealed at 400 to 700 °C are approximately 92.3%. The refractive indices and packing densities of Y2Ti2O7 thin layers annealed at 400–700 °C/1 h vary from 1.931 to 1.954 and 0.835 to 0.846, respectively. The optical bandgap energies of Y2Ti2O7 thin layers annealed at 400–700 °C/1 h reduce from 4.356 to 4.319 eV because of the Moss–Burstein effect. These good electronic and optical properties make Y2Ti2O7 thin layers a promising host material for many potential applications.

The success of van-der-Waals electronics, which combine large-scale-deposition capabilities with high device performance, relies on the efficient production of suitable 2D materials. Shear exfoliation of 2D materials’ flakes from bulk sources can generate 2D materials with low amounts of defects, but the production yield has been limited below industry requirements. Here, we introduce additive-assisted exfoliation (AAE) as an approach to significantly increase the efficiency of shear exfoliation and produce an exfoliation yield of 30%. By introducing micrometer-sized particles that do not exfoliate, the gap between rotor and stator was dynamically reduced to increase the achievable shear rate. This enhancement was applied to WS2 and MoS2 production, which represent two of the most promising 2D transition-metal dichalcogenides. Spectroscopic characterization and cascade centrifugation reveal a consistent and significant increase in 2D material concentrations across all thickness ranges. Thus, the produced WS2 films exhibit high thickness uniformity in the nanometer-scale and can open up new routes for 2D materials production towards future applications.