Search

A BC Hydro regional system experienced a blackout after multiple 500 kV lines, sharing the same transmission corridor, were subjected to lightning strikes in the time span of about three minutes. These lines connect two large generating stations, regional loads, and five nonutility generators to the rest of the BC Hydro system. The protection scheme on the first line tripped three-phase and initiated autoreclose as designed. However immediately after three-phase opening, high magnitudes of low-frequency (about 9 Hz) currents appeared in the line shunt reactor, causing a protection trip, and aborting the autoreclose. Subsequent lightning strikes coupled with a pre-existing line outage disconnected both generating stations from each other as well as from the integrated system. The larger of two generating stations and almost all regional load formed an islanded subsystem, which eventually collapsed and blacked out. During the restoration of the subsystem, the system operator inadvertently picked up the entire regional system without load, causing steady-state resonant overvoltages higher than 145% and damaging a transmission customer. This paper shares lessons learned from forensic analysis of disturbances leading to regional blackout and describes the risk of unsafe overvoltages from near power frequency resonant condition during the restoration process. [ABSTRACT FROM PUBLISHER]

Power-electronic sources, such as Type 3 wind turbine generators and static synchronous compensators (STATCOM), interface to the grid through, partial- or full-scale, and power converters that have inherently fast switching capability to control their output current during short circuits. The short-circuit current is a function of the specific converter control algorithm and differs significantly from the conventional rotating machine sources without converter interfaces. Therefore, if a transmission-line protection scheme is designed for conventional sources, (not taking into account these differences in short-circuit current characteristics), reliability can be at risk. Using real-life short-circuit currents on lines supplied by sources having a power converter interface, this paper illustrates the reliability risk to conventional line protection schemes, in particular, to those which use negative-sequence quantities for the detection of unbalanced faults. This paper discusses the protection schemes, adopted by BC Hydro–a large Canadian Electric Utility, for transmission lines interconnecting Type 3 wind turbine and STATCOM sources. Their application for ground faults is independent of the converter control algorithm as long as the source is interconnected to the grid via a transformer which is a source of zero-sequence current. [ABSTRACT FROM PUBLISHER]

Traditional connection of a generating station to the transmission grid typically requires either a new transmission line to an existing substation or building a new substation to segment an existing transmission line. Both of these options are capital intensive which often hurts economic viability especially small- or medium-size nonconventional generating stations. The direct connection to an existing transmission line, without the switching station, is the most economical solution to interconnect the generating station but it desensitizes the line protection and poses a risk to the ability of the protection to detect faults, particularly ground faults involving fault resistances. Multifunction relays, combined with communication-assisted schemes, now offer innovative solutions to overcome protection desensitization concerns. This paper describes these solutions which are successfully implemented by a large Canadian electric utility over the last two decades to tap connect numerous generators to the transmission grid. [ABSTRACT FROM PUBLISHER]