Search

Greenhouse structures are complex buildings that must meet different needs, such as the microclimate control inside the greenhouse, the strength of structural elements, as well as the radiometric and mechanical features of roofing materials. The covering system must allow the transmission of solar radiation for crop needs and guarantee resistance performances in relation to external actions, such as wind and snow loads. Starting from the main characteristics of agricultural commercial greenhouses and tensile structures, the proposal concerns with an innovative tensile supporting structure designed for the covering of protected crop facilities. The innovative tensile structural configuration was first studied by means of the selection of the construction materials and the cross sections of the structural components and afterward calculated using the structural analysis software SOFISTIK. The load analysis on the structure was carried out in accordance with the European standards UNI-EN 13031-1: 2004 and the Italian Technical Construction Code of 2018 related to the Eurocodes. The main results concern the comparison with the current structural types of commercial greenhouses: analysis of the steel weight of the structure and improvement of the structural response to external actions of the innovative tensile structure.

The intrinsic factor of variability of renewable energy sources often limits their broader use. The photovoltaic solar systems can be provided with a power back up based on a combination of an electrolyser and a fuel cell stack. The integration of solar hydrogen power systems with greenhouse heating equipment can provide a possible option for powering stand-alone greenhouses. The aim of the research under development at the experimental farm of Department of Agro-Environmental Sciences of the University of Bari Aldo Moro is to investigate on the suitable solutions of a power system based on photovoltaic energy and on the use of hydrogen as energy vector, integrated with a ground source heat pump for greenhouse heating in a self sustained way. The excess energy produced by a purpose-built array of solar photovoltaic modules supplies an alkaline electrolyser; the produced hydrogen gas is stored in pressured storage tank. When the solar radiation level is insufficient to meet the heat pump power demand, the fuel cell starts converting the chemical energy stored by the hydrogen fuel into electricity. This paper reports on the description of the realised system. Furthermore the efficiency and the operational mode of the electrolyser were evaluated during a trial period characterised by mutable solar radiant energy. Anyway the electrolyser worked continuously in a transient state producing fluctuations of the hydrogen production and without ever reaching the steady-state conditions. The Faradic efficiency, evaluated by means of an empirical mathematic model, highlights that the suitable working range of the electrolyser was 1.5÷2.5 kW and then for hydrogen production more than 0.21 Nm3h–1.

An innovative wireless monitoring system for measuring greenhouse climatic parameters was developed to overcome the problems related to wires cabling such as presence of a dense net of wires hampering the cultivation practices, wires subjected to high temperature and relative humidity, rodents that can damage wires. The system exploits battery-powered environmental sensors, such as air temperature and relative humidity sensors, wind speed and direction, and solar radiation sensors, integrated in the contest of an 802.15.4-based wireless sensors network. Besides, a fruit diameter measurement sensor was integrated into the system. This approach guarantees flexibility, ease of deployment and low power consumption. Data collected from the greenhouse are then sent to a remote server via a general packet radio service link. The proposed solution has been implemented in a real environment. The test of the communication system showed that 0.3% of the sent data packed were lost; the climatic parameters measured with the wireless system were compared with data collected by the wired system showing a mean value of the absolute difference equal to 0.6°C for the value of the greenhouse air temperature. The wireless climate monitoring system showed a good reliability, while the sensor node batteries showed a lifetime of 530 days.

This paper presents a technoeconomic analysis of a solar combined heat and power (S-CHP) system based on hybrid photovoltaic-thermal (PVT) collectors for distributed cogeneration in a greenhouse tomato-farm in Bari, Italy. The thermal and electrical demands of the greenhouse of interest are currently fulfilled by a gas-fired CHP system that features an internal combustion engine (ICE) prime mover, and partially by an auxiliary gas boiler and electricity from the grid. A PVT-water S-CHP system is designed and sized based on a transient model, with hourly weather data and measured demand data given as inputs. Annual simulations are performed to predict the transient behaviour of the S-CHP system and to assess the system’s energy outputs. The economic profitability of such solution is also evaluated by considering the investment costs and cost savings due to the reduced on-site energy consumption. The results show that, with an installation area of 30,000 m2, the PVT S-CHP system is able to cover up to 73% of the annual thermal demand of the greenhouse, while delivering a net electrical output 2.6 times that of the annual electrical demand. This performance is similar to that achieved by the equivalent ICE-CHP system (92% and 2 times, respectively). Furthermore, the total annual cost saving of the PVT S-CHP system is more than 6 times higher than that of the ICE system, due to the much lower fuel cost of the PVT system. Similarly, the potential CO2 emission reduction associated with the PVT system is considerably higher, at 3010 tCO2/year saved (vs. 86 tCO2/year). The payback time of the PVT system is not significantly longer than that of the ICE system (10.4 years vs. 8.4 years), but its levelized cost of energy is much lower (0.076 €/kWh vs. 0.132 €/kWh) due to the higher annual cost savings. These results indicate that such PVT S-CHP systems have an excellent technoeconomic potential in the proposed greenhouse applications and could be competitive over conventional fossil-fuel-based ICE-CHP systems in terms of energetic, economic and also environmental metrics.

The effectiveness of experimental nets in preventing the access of adult meadow spittlebug Philaenus spumarius L., the main vector of Xylella fastidiosa Wells et al. subspecies pauca, sequence type (ST) 53, in olive tree nurseries and orchards was evaluated. To optimize the net design, mesh size, kind of fabric, thread typology, and radiometric properties, six nets with different mesh sizes and kinds of fabric were evaluated in laboratory and in field experiments. Laboratory bioassays evaluating the capability of adult spittlebugs to pass through nets with different mesh sizes (1.2, 1.8, 2.4 mm) showed that all nets with a mesh size equal to or lower than 2.4 mm prevented insect crossing. These results were confirmed in field conditions using an experimental net box apparatus. Further laboratory tests showed a positive correlation between porosity and radiometric properties of the nets. Three prototypes of thermally stabilized flat woven nets made of circular cross-sectional yarns, knitted net with strips, and knitted nets made of yarns were tested after the evaluation of their potential usability in terms of porosity stability. The knitted net features were found to be the most suitable. The net transmissivity of the total and direct component of solar radiation in the photosynthetically active radiation and the infrared ranges increased with the net porosity. A prism-shaped wooden frame with a triangular base covered with the knitted net with a 2.4 mm mesh confirmed the insect’s capability of reaching considerable heights, up to 2.85 m. Hence, based on our results, the monowire knitted net with a 2.4 mm mesh can be used in open field nursery and olive orchards to prevent the access of P. spumarius adults and to shield the openings of greenhouse nurseries.

A greenhouse containing an integrated system of photovoltaic panels, a water electrolyzer, fuel cells and a geothermal heat pump was set up to investigate suitable solutions for a power system based on solar energy and hydrogen, feeding a self-sufficient, geothermal-heated greenhouse. The electricity produced by the photovoltaic source supplies the electrolyzer; the manufactured hydrogen gas is held in a pressure tank. In these systems, the electrolyzer is a crucial component; the technical challenge is to make it work regularly despite the irregularity of the solar source. The focus of this paper is to study the performance and the real energy efficiency of the electrolyzer, analyzing its operational data collected under different operating conditions affected by the changeable solar radiant energy characterizing the site where the experimental plant was located. The analysis of the measured values allowed evaluation of its suitability for the agricultural requirements such as greenhouse heating. On the strength of the obtained result, a new layout of the battery bank has been designed and exemplified to improve the performance of the electrolyzer. The evaluations resulting from this case study may have a genuine value, therefore assisting in further studies to better understand these devices and their associated technologies.

A pilot power system formed by photovoltaic panels, alkaline electrolyser and fuel cell stacks was designed and set up to supply the heating system of an experimental greenhouse. The aim of this paper is to analyse the main safety aspects of this power system connected to the management of the pressured hydrogen, such as the explosion limits of the mixture hydrogen-oxygen, the extension of the danger zone, the protection pressure vessels and the system to make unreactive the plant. The electrolyser unit is the core of this plant and from the safety point of view has been equipped with devices able to highlight the malfunctions before they cause damages. Alarm situations are highlighted and the production process is cut off in safe conditions in the event that the operational parameters have an abnormal deviation from the design values. Also the entire power system has been designed so that any failure to its components does not compromise the workers’ safety even if the risk analysis is in progress because technical operations are being carried out for enhancing the plant functionality, making it more suitable to the designed task of supplying electrically the greenhouse heating system during cold periods. Some experimental data pertinent to the solar radiation and the corresponding hydrogen production rate are also reported. At present it does not exist a well-established safety reference protocol to design the reliability of these types of power plants and then the assumed safety measures even if related to the achieved pilot installation, can represent an original base of reference to set up guidelines for designing the safety of power plants in the future available for agricultural purposes.

The use of low-impact energy sources for greenhouse cultivations is growing quickly due to environmental demands, constrained by the increased price of fossil energy sources, market demand for low cost greenhouse production, and need for air pollution reduction. This paper demonstrates via environmental analysis the efficiency of a Photovoltaic-Geothermal Heat Pump integrated system (PV-GHP) as a greenhouse heating system, compared to a conventional hot air generator using liquefied petroleum gas (LPG-HG). The tests were carried out in twin experimental greenhouses in the Mediterranean area (Valenzano-Italy). In order to evaluate the environmental performance of a heat pump system with electricity supplied from the national grid, a scenario (GHP Geothermal Heat Pump) was realised. The microclimatic conditions in the two greenhouses, the thermal energy produced, and the electricity consumption were analysed. Furthermore, in order to evaluate the long-term environmental impact, an environmental analysis was conducted using life cycle assessment (LCA) methodology, carried out according to standard UNI EN ISO 14040. The interpretation of the results using method CML2001 (Centre of Environmental Science, Leiden, Netherlands) showed that neither system is more advantageous from an environmental point of view and that the GHP scenario has the higher environmental burdens. Limiting the analysis to the emissions responsible for the greenhouse effect, the plant with the geothermal heat pump and photovoltaic panels reduces carbon emissions by 50%. In order to assess the sustainability of the geothermal heat pump plant, the estimated payback-time for energy and for carbon emissions were 1 year and 2.25 years, respectively.

Current agricultural practices require the use of large quantities of plastics, which contribute to a significant increase of the quantity and quality of agricultural production, but also require high quantities of plastic waste to be disposed in such way that will not have a negative effect on the landscape and the agro-ecosystem. In this paper the results of an experimental investigation of the possibilities of producing new regenerated plastic films through mechanical recycling, from post-consume agricultural plastic films are analysed. Six recycled films, made from agricultural low tunnel and greenhouse covering films as well as from HDPE bags for agrochemical packaging, have been extruded producing films of different thickness. These regenerated films were characterized by means of mechanical and spectrometric tests and SEM + EDS analysis. The obtained results show that without adding any additives into the blends good mechanical and spectral properties can be achieved by mixing the greenhouse and low tunnel recycled plastic film coverings.

At the moment, there is a large number of agricultural net typologies on the market characterised by different texture features such as threads, texture, dimensions of fibres and meshing, physical properties such as weight, colours, shading factor, durability, porosity, air permeability and mechanical characteristics such as stress, strength at break and elongation. Protection from hail, wind, snow, or strong rainfall in fruit-farming and ornamentals, shading nets for greenhouses, or nets for moderately modifying the microenvironment are the most common applications. A systematic review of the current state-of-the-art of structural parameters, standard and regulations, most common agricultural applications of nets and their supporting structures has been developed by means of a literature study, technical investigations, interviews with permeable covering producers, specialised greenhouse builders and growers, who are familiar with permeable cladding applications. The interviews were based on questionnaires concerning characteristics, use and disposal of nets. As a result, the survey highlighted that in many cases different, not even similar, net typologies were adopted for the same application and the same cultivations by various growers. Results show that neither growers nor net producers have clear ideas about the relationship between the net typology optimisation for a specific function and the construction parameters of the net. The choice still depends often on empirical or economic criteria and not on scientific considerations. Moreover, it appears that scientifically justified technical requirements for nets used in specific agricultural applications have not been established yet.

The use of low-density polyethylene plastic films for soil mulching and greenhouse covering has been increasing significantly in the world. In order to overcome the environmental pollution due to the huge consumption of plastics and to the consequent waste production, innovative biodegradable materials have been introduced to replace traditional plastic films. Biodegradable films can be disposed directly in the soil or in composting plant. Biodegradable films are innovative materials, as a consequence their physical properties must be evaluated in order to assess if they meet the agricultural requirements. In the present research the radiometric properties of innovative biodegradable starch based films were tested in laboratory and during experimental field tests. The biodegradable films were used as low tunnel covering and mulching films in a melon cultivation in Southern Italy. Two black biodegradable and one transparent mulching film were used in combination with two biodegradable films for low tunnel covering. Low density polyethylene films were used for comparison too. Radiometric tests carried out by means of spectrophotometers on the biodegradable films for low tunnel covering showed values of the solar transmissivity coefficient between 86 and 87% and values of the long wave infrared coefficient ranging from 10 to 16%. The yield of melon obtained using biodegradable films was comparable with the yield obtained using LDPE films, especially using the black mulching film rather than transparent mulching films.

SummaryTwo photoselective and three photoluminescent greenhouse plastic films were studied for their effects on the spectral distribution of solar radiation and their influence on the growth of cherry and peach trees in the field and in laboratory tests.The two photoselective films modified the ratio of the photon fluence rate in the red to that in the far-red (R/FR), while the three photoluminescent films increased both the blue and red solar radiation by moving energy from the ultra-violet range to the blue and red wavelength range.The photoselective film that reduced the R/FR ratio, from 1.14 (open-field) to 0.93, enhanced shoot growth in peach (46.1 cm) and cherry trees (68.7 cm) compared to trees grown in the open-field (13.5 cm and 39.3 cm for peach and cherry trees, respectively). Trees grown under the red-emitting photoluminescent film showed increases in shoot length of 27.2 cm and 55.8 cm for peach and cherry trees, respectively; while plants grown under the blue-emitting photoluminescent film s...