Search

A 1.5 MW combustion facility burning large bales of soy straw has been built for the purpose of heating 1 ha of vegetable greenhouses located within the complex of Agricultural Plant PKB in Padinska Skela, Serbia. The paper addresses numerical and experimental study of temperature distribution in a cylindrical, 100 m3 (8 m high, 4 m in diameter) hot water storage tank. The water tank optimization, as well as optimization of the heating facility as a whole, were identified as the main goals of the study performed. Water temperature was measured by a temperature probe inserted in the tank. Measurements were conducted in 256 measurement points, both under steady and unsteady water flow conditions. Water tank optimization analysis was carried out utilizing both steady and unsteady state numerical simulation. The results obtained indicated good agreement between the experimental and computational data acquired.

Enhancement of heat transfer over a cylinder shaped thermal energy storage filled by paraffin E53 by use of longitudinal rectangular copper fins was analyzed. The thermo-physical features of the storage material are determined in separate experiments and implemented to FLUENT software over user defined function. Advanced thermal storage geometry comprehension and optimization required introduction of a parameter suitable for the analysis of heat transfer enhancement, so the ratio of heat transfer surfaces as a factor was proposed and applied. It is revealed that increase of the ratio of heat transfer surfaces leads to the decrease of melting time and vice versa. Numerical analysis, employing the 3-D model built in Ansys software, observed storage reservoir geometries with variable number of longitudinal fins. The adjusted set of boundary conditions was carried out and both written in C language and implemented over user defined function in order to define variable heat flux along the height of the heater. The comparison of acquired numerical and experimental results showed a strong correlation. Experimental validation of numerical results was done on the real thermal energy storage apparatus. [ABSTRACT FROM AUTHOR]