Search

In this study, the distribution of axial and radial velocities with the use of a PIV laser system was determined and the mixing power in a mixing tank with narrow and wide propeller impellers was measured. The pumping capacity and secondary circulation values in the mixing tank were calculated and on this basis, the energy efficiency of the operation of both types of propeller impellers was determined and compared with the efficiency of turbine impellers with inclined blades. It turned out that propeller impellers with wide blades are most effective as regards the amount of energy that should be supplied to the mixing tank to achieve the required mixing time. It was found that the share of pumping capacity in the total secondary circulation is almost twice as high as the share of induced circulation. Correlation equations for the dependence of the mixing power and dimensionless flow numbers on the pitch of the propeller blade were also formulated. All the results obtained were compared with the works of other authors. The paper also found that propeller impellers with a variable angle of inclination of the blade α depending on the current radius do not meet the theoretical assumption of a constant axial velocity of the liquid flowing out from of the impeller zone. For small radii of the impeller the explanation for this observation is the presence of the hub and shaft in the axis of the mixer and the effect of liquid slip for the steep agitator blades near the hub. For radii close to the radius of the stirrer, the reason is generation of induced circulation as the expense of the kinetic energy of the liquid flowing out of the impeller area. [ABSTRACT FROM AUTHOR]

This paper presents an analysis of hydrodynamics in a tank with a 45° and 60° pitched blade turbine impeller operating while emptying the mixer and with an axial agitator working during axial pumping-down of water at different water levels above the impeller. Measurements made with the PIV method confirmed the change in direction of pumping liquid after the level dropped below the critical value, with an almost unchanged liquid stream flowing through the mixer. It was found that an increase in the value of the tangential velocity in the area of the impeller took place and the quantity of this increase depended on the angle of the blade pitch and the rotational frequency of the impeller. Change in this velocity component increased the mixing power. [ABSTRACT FROM AUTHOR]

Abstract: In the study a 3D/2D hybrid model for ribbon mixers, for a laminar range of mixing was verified. Distributions of the experimental and model values of velocity components and the experimental and model values of mixing power for this type of mixers were compared. Further on, based on the model solutions the optimum parameters of ribbon agitators due to the time of homogenization were established. [Copyright &y& Elsevier]