Search

The shock wave dynamics, spontaneous ignition and flame variation during high-pressure hydrogen release through tubes with different cross-section shapes are experimentally studied. Tubes with square, pentagon and circular cross-section shapes are considered in the experiments. The experimental results show that the cross-section shape of the tube has no great difference on the minimum burst pressure for spontaneous ignition in our tests. In the three tubes with length of 300 mm, spontaneous ignition may occur when overpressure of shock wave is 0.9 MPa. When the spontaneous ignition is induced in a non-circular cross-section tube, the possible turbulent flow in the corner of the tube increases can promote the mixing of hydrogen and air, thus producing more amount of the hydrogen/air mixture. As a result, both the peak light signal and flame duration detected in the non-circular cross-section tubes are more intense than those in the circular tube. The smaller angle of the corner leads to a more intensity flame inside tube. When the hydrogen flame propagates to the tube exit from the circular tube, the ball-like flame developed near tube exit is relatively weak. In addition, second flame separation outside the tube is observed for the cases of non-circular cross-section tubes. • The effect of cross-section shapes of tube has been experimentally investigated. • The use of burst disk with cross notching on surface exhibits good repeatability. • The ignition occurs when the overpressure of shock wave is about 0.9 MPa. • The cross-section shape shows a significant influence on the flame intensity. • Twice flame separation are observed for cases of non-circular cross-section tubes. [ABSTRACT FROM AUTHOR]

Due to the high probability of hydrogen leaking from narrow cracks of the vessels, an experimental study is conducted to investigate the spontaneous ignition of high-pressure hydrogen released into a tube through inlets with different narrowness, including circular, square (length-width ratio χ = 1), and two slit shapes of χ = 2 and 3, with the same area. Pressure transducers and photoelectric sensors are used to detect shock wave dynamic variation and ignition occurrence. The results indicate that narrow inlets weaken the shock wave intensity and speed, and the weakening effect increases with narrowness. Moreover, spontaneous ignition is affected. The minimum burst pressure required for spontaneous ignition is higher in the cases with square and slit inlets. Most significantly, when χ is 3 , it is 2.5 times that of circular inlet. Meanwhile, for narrow inlets, the ignition flame intensity and speed are enhanced, and the inlet of χ = 2 has the greatest impact. • The influence of narrow releasing ports on self-ignition hydrogen is investigated. • Narrow ports weaken the shock wave intensity and speed. • It requires higher burst pressure for self-ignition under narrow ports. • The flame intensity is enhanced under narrow ports. • Different narrowness of the ports brings different effects. [ABSTRACT FROM AUTHOR]

Experiments on shock waves propagation, spontaneous ignition, and flame development during high-pressure hydrogen release through tubes with symmetrical obstacles (O 1-1) and asymmetrical obstacles (O 1-2) are conducted. The obstacle's side is triangular with a length of 4 mm, a height of 3.6 mm, and its width is 15 mm. In the experiments, a reflected shock wave generates and propagates both upstream and downstream when the leading shock wave encounters the obstacle. At the same burst pressure, the reflected shock wave intensity in tube O 1-1 is significantly greater than that in tube O 1-2. Moreover, the presence of obstacles in the tube can induce spontaneous ignition. The minimum burst pressures for spontaneous ignition for tubes O 1-1 and O 1-2 are 2.84 MPa and 3.28 MPa respectively, lower than that for the smooth tube. Furthermore, both the initial ignition position and ignition time are greatly advanced in obstruction tubes, mainly affected by obstacle positions and burst pressures. Finally, the flame separation process near the obstacle is observed. After passing the obstacle, the flames grow rapidly in radial and axial directions on the tube sidewalls. And at the same burst pressure, the flame convergence time in tube O 1-2 is usually longer than that in tube O 1-1. • The influence of obstacles arrangements on self-ignition hydrogen is investigated. • Reflected shock wave forms and propagates both upstream and downstream. • The presence of the obstacles can facilitate the occurrence of self-ignition. • Obstacles arrangements have great effects on ignition positions and ignition time. • The flame separation is observed inside both obstruction tubes. [ABSTRACT FROM AUTHOR]

An experimental study of shock wave propagation and its influence on the spontaneous ignition during high-pressure hydrogen release through a tube are measured by pressure transducers and light sensors. Results show that the pressure behind a shock wave first increases, and subsequently remains near constant value with an increase of the propagation distance. That is, a certain propagation distance is required to form a stable shock wave in the tube. In the front of the tube, the minimum value of pressure behind the shock wave (P shock) required for spontaneous ignition decreases with the increase in axial distance to the diaphragm. However, the minimum P shock remains nearly a constant value in the rear part of the tube. Moreover, the critical values of shock Mach number (M S) for spontaneous ignition decrease with the increase in tube length. And the ignition delay time decreases with the increase of the M S. As the ignition kernel grows in size to a flame, it propagates downstream along the tube with velocity greater than the theoretical flow velocity of the hydrogen-air contact surface. The flame propagation velocity relative to tube wall increases with M S. When the self-sustained flame exits from the tube, a rapid non-premixed turbulent combustion is observed in the chamber. The combustion-wave overpressure increases with the increase of the M S. • The influence of shock wave intensity on spontaneous ignition is investigated. • A certain propagation distance is required to form a stable shock wave in the tube. • The minimum P shock for self-ignition decreases with increasing the axial location. • The critical shock Mach number for self-ignition decreases with the tube length. • Flame propagation velocity relative to tube wall increases with shock Mach number. [ABSTRACT FROM AUTHOR]

• Shock wave is temporarily weakened when the shock wave travels through obstacles. • Effects of obstacles in the tube on hydrogen self-ignition is investigated. • The further obstacles away from diaphragm, the more probability of flame enhancement. • Presence of obstacles in tube would only temporarily promote combustion inside tube. The spontaneous ignition and subsequent hydrogen combustion has become a great challenge for the safe use of hydrogen energy at high-pressure. The spontaneous ignition mechanism of high-pressure hydrogen in the tube with obstacles has still not fully understood. In this study, synchronization measurement was performed through simultaneous pressure and flame acquisition, and experiments of pressurized hydrogen sudden release through tubes with obstacles were conducted. Spontaneous ignition and subsequent hydrogen combustion were reproduced through varying initial burst pressure in different obstructed tubes, the presence of obstacles exhibit great influence on shock wave propagation and flame evolution inside the tube. The temporary weaken of shock wave strength caused by obstacles is not conducive for spontaneous ignition onset. At the contrary, the complex dynamic flow induced by obstacles facilitates the occurrence of the spontaneous ignition. The effect of obstacles on the spontaneous ignition onset can be further analyzed by the minimum burst pressure for spontaneous ignition. And it shows the effects of obstacles on spontaneous ignition onset depends on its comprehensive influences on the formation of hydrogen/air mixture and increment of temperature. Furthermore, locations of obstacles also play an essential role on spontaneous ignition onset and hydrogen combustion intensity inside tube. The pressure and flame dynamics evolution show that when increasing the distance between burst disk and obstacles, the obstacles exhibit less influence on the spontaneous ignition onset but temporarily enhance combustion inside tube. [ABSTRACT FROM AUTHOR]