Search

In this work, a ten-level inverter scheme is presented to extend the linear modulation range (LMR) by using a unique space vector pulsewidth modulation (SVPWM) technique, such that no lower order harmonics (such as 5th, 7th, 11th, and 13th, etc.) are present in the phase voltage as compared to six-step mode operation. The proposed scheme can increase the peak phase fundamental voltage of the inverter from 0.577 to $0.637 V_{dc}$ (maximum possible peak phase fundamental voltage of a conventional hexagonal space vector structure (SVS) voltage source inverters while operating in six-step mode), irrespective of the load power factor (p.f), where $V_{dc}$ is the dc link voltage of the inverter. The ten-level inverter structure is formed using a two-level inverter and an H-bridge (HB) in cascade from one end and a floating capacitor-based two-level inverter cascaded with an HB from the other end to drive an open-end winding induction motor (OEWIM). All the HB capacitor voltages are balanced by using space vector redundancy. The claim of balancing the capacitor voltages throughout the whole modulation range is verified experimentally in this article. Experimental results at different steady-state and transient conditions are shown to validate the proposed inverter scheme’s efficacy in increasing the LMR. [ABSTRACT FROM AUTHOR]

Modulation using a higher sided polygonal space vector structure (SVS) is an elegant method to increase the linear modulation range and to eliminate the undesired lower order harmonics from motor phase voltage. This article presents the generation of a dense 15-concentric 30-sided multilevel SVS using a single dc-link for an open end induction motor (OEIM) drive. The proposed scheme eliminates lower order harmonics till 25th order from motor phase voltage throughout the modulation range. The $dv/dt$ stress in the phase voltage applied to the motor will also be highly reduced owing to the multilevel structure. The pulsewidth modulation scheme employed utilizes the denseness of SVS and avoids iterative searches to find the triangle, which encompasses the tip of reference voltage vector, which are typical in multilevel polygonal SVS. The topology consists of an active dc-link fed three-level primary inverter and a capacitor fed five-level secondary inverter connected to either end of an OEIM. The primary inverter acts as the active power supplier for the drive and the secondary inverter filters out the undesirable lower order harmonics from motor phase voltage. The proposed scheme is experientially validated and the results are included in this article. [ABSTRACT FROM AUTHOR]

In this article, a multilevel inverter scheme to generate a 30-sided space vector structure (SVS) with congruent triangles is proposed. The 30-sided SVS eliminates all the lower order harmonics till 25th order from motor phase voltage throughout the modulation range. The proposed scheme is implemented using a single dc-link on an open-end induction motor (OEIM). The OEIM is fed with primary inverter from one end and secondary inverter from the other end. Primary inverter is fed from an active dc-link and supplies all the required active power for the scheme. Secondary inverter is a capacitor fed inverter, which acts as the switched capacitive filter. In this work, a simple algorithm is proposed, which calculates the timings required for a 2-level 30-sided SVS from sampled reference voltages. The algorithm requires only simple operations such as addition, multiplication, and comparisons. From the obtained timing values, the space vector location of three nearest multilevel 30-sided vectors and its time duration can be identified. The feasibility of the proposed scheme is proved by experimental results. [ABSTRACT FROM AUTHOR]

This article proposes an inverter topology for the first time for suppression of all lower order harmonics (5th, 7th, 11th, 13th, etc.) up to 39th harmonic. The lower order harmonic suppression is achieved by switching the 42-sided polygonal vectors, which eliminates harmonics in phase voltage without using a passive LC filtering technique. The power circuit topology uses a single dc-link supply for the primary inverter. The secondary inverter is fed with a capacitive supply. A novel topology is proposed for the dense six-level secondary inverter. The lower order harmonics in phase voltage are suppressed using the secondary inverter, which acts like a switched-capacitive filter. This article also proposes a novel capacitor voltage-balancing scheme for the first time, which achieves voltage balancing for secondary inverter capacitors. The voltages of secondary inverter capacitors are balanced using the power balance relationship between the primary inverter and the motor load. An experimental study of the topology and the capacitor-balancing scheme is presented for the validation of proposed scheme. [ABSTRACT FROM AUTHOR]