Search

Ge is a candidate for replacing Si, especially for pMOSFETs, because of its high hole mobility. For Si-pMOSFETs, negative-bias temperature instabilities (NBTI) limit their lifetime. There is little information available for the NBTI of Ge-pMOSFETs with Ge/GeO2/Al2O3 stack. The objective of this paper is to provide this information and compare the NBTI of Ge- and Si-pMOSFETs. New findings include: 1) the time exponent varies with stress biases/field when measured by either the conventional slow dc or pulse I-V technique, making the conventional Vg -accelerated method for predicting the lifetime of Si-pMOSFETs inapplicable to Ge-pMOSFETs used in this paper; 2) the NBTI is dominated by positive charges (PCs) in dielectric, rather than generated interface states; 3) the PC in Ge/GeO2/Al2O3 can be fully annealed at 150 ^\circC ; and 4) the defect losses reported for Si sample were not observed. For the first time, we report that the PCs in oxides on Ge and Si behave differently, and to explain the difference, an energy-switching model is proposed for hole traps in Ge-MOSEFTs: their energy levels have a spread below the edge of valence band, i.e., Ev , when neutral, lift well above Ev after charging, and return below Ev following neutralization. [ABSTRACT FROM PUBLISHER]

Defects in gate oxide cause breakdown and shorten device lifetime. Early works mainly focused on generation process that converts a precursor into a charged defect. Although it can be neutralized through “recovery,” the defect is still there and will recharge when resuming stress. Recently, we have shown that this is not always the case and some defects can be lost, but a detailed investigation is missing. The central objective of this work is to accurately define and extract the loss, separate it from slowdown, and evaluate their enhancement of device lifetime. Loss is defined as elimination of defects, while slowdown means that recharging a “hardened” precursor takes longer than charging a fresh one. Clear evidences show that losses originate from permanent components, i.e., generated interface states and antineutralization positive charges, while slowdown occurs to both permanent and recoverable components. Loss is thermally accelerated, but slowdown of recoverable component is not. This improved understanding adds slowdown and losses to the existing framework for defects. For the first time, we report that the losses and slowdown enhance device lifetime by a factor of 2.6–4.3, for an allowed threshold voltage shift of 20–45 mV. [ABSTRACT FROM AUTHOR]

Interface states play an important role in the performance of MOSFETs, and previous works only addressed the states within band gap. The implicit assumption is that the states beyond band gap (SBBs) are negligible, but there is no experimental evidence supporting it. Because of a lack of techniques for characterizing SBBs, there is hardly any information available. The central objective of this paper is to develop a technique for evaluating SBBs and to show the impact of SBBs on mobility evaluation. For the first time, the pulse capacitance–voltage has been used to extract SBBs quantitatively. It is found that SBBs can reach the order of \10^13 \ \cm^-2\cdot\eV^-1 beyond both conduction- and valence-band edges on a fresh MOSFET. The conventional split C– V technique ignores the SBBs, and this can lead to an underestimation of carrier mobility over 30%. Using the newly developed technique as a tool, the impact of nitridation of Hf-based dielectric stacks on carrier mobility is assessed. As nitrogen density increases, the apparent reduction of carrier mobility observed by early works originates from the higher SBBs. Once SBBs are taken into account, nitridation does not degrade carrier mobility. The SBBs are sensitive to process conditions, and this paper opens the way for their minimization. [ABSTRACT FROM AUTHOR]

Characterizing interface states is a key task, and it typically takes seconds when conventional techniques, such as charge pumping (CP), are used. The stress-induced degradation can recover substantially during this time, and there is a need to improve the measurement speed. The central task of this work is to reduce the measurement time for interface states from seconds to microseconds to minimize the recovery. A fast single pulse CP (SPCP) technique is developed. By exploring the differences in the transient currents corresponding to the two edges of the gate pulse, the net charges pumped into devices can be obtained, and their saturation level is used to evaluate interface states. Unlike the conventional CP (CCP) method, the contribution of currents during the plateaus of gate pulse is excluded for SPCP, making it less vulnerable to the interferences of gate leakage and defects within dielectrics. For the first time, the SPCP allows the recovery of interface states being monitored with a time resolution in microseconds. The results show that the recovery of stress-induced interface states is substantial within 100 \mu\s, which would be missed if the CCP were used. [ABSTRACT FROM PUBLISHER]

To predict the negative bias temperature instability (NBTI) toward the end of pMOSFETs’ ten years lifetime, power-law-based extrapolation is the industrial standard method. The prediction accuracy crucially depends on the accuracy of time exponents, n. n reported by early work spreads in a wide range and varies with measurement conditions, which can lead to unacceptable errors when extrapolated to ten years. The objective of this paper is to find how to make n extraction independent of measurement conditions. After removing the contribution from as-grown hole traps, a new method is proposed to capture the generated defects (GDs) in their entirety. n extracted by this method is around 0.2 and insensitive to measurement conditions for the four fabrication processes we tested. The model based on this method is verified by comparing its prediction with measurements. Under ac operation, the model predicts that the GD can contribute to ~90% of NBTI at ten years. [ABSTRACT FROM PUBLISHER]

Poly-Si (p-Si) channel used in 3-D Flash memory devices is the main source of degraded performance, such as the high interface state density. Charge pumping (CP) signals in the 3-D nanoscale vertical device with p-Si channel are analyzed in this paper using the variable amplitude CP technique. For the first time, it has been demonstrated experimentally that the broad CP edge is due to the threshold voltage variation in the p-Si channel caused by both the trapping in interface states and the source/drain p-n junction diffusion, and their impacts can be separately evaluated. Hot carrier stress in the tunneling FET operation modes and statistical analysis are used to provide supporting evidence. [ABSTRACT FROM PUBLISHER]