Search

The main contribution of this paper is to present a simple algorithm that theoretically and numerically assesses the switching angles of an inverter operated with the SPWM technique. This technique is the most widely used for eliminating harmonics in DC-AC converters for powering motors, renewable energy applications, household appliances, etc. Unlike conventional implementations of the SPWM technique based on the analog or digital comparison of a sinusoidal signal with a triangular signal, this paper mathematically performs this comparison. It proposes a simple solution to solve the transcendental equations arising from the mathematical analysis numerically. The technique is validated by calculating the total harmonic distortion (THD) of the generated signal theoretically and numerically, and the results indicate that the calculated angles produce the same distribution of harmonics calculated analytically and numerically. The algorithm is limited to single-phase inverters with unipolar SPWM. [ABSTRACT FROM AUTHOR]

The study of this article mainly focuses on the assessment and performance of current and voltage inverters in ozone generation, applying power density modulation (PDM) and typical operation. The topologies designed were a voltage-source full-bridge inverter (VSFBI), a current-source full-bridge inverter (CSFBI), and a CSFBI without considers the PDM. The inverters were analyzed and implemented considering an inductor–capacitor–capacitor (LCC) series–parallel resonant tank for the VSFBI and an LC parallel resonant tank for the CSFBI. The duty cycle impact (Dm) of the modulation signal was analyzed, and all inverters were compared. Based on the results, the decrease in Dm allows increasing the ozone generation because of avoiding the dissociation of the ozone molecules. The maximum concentration and efficacy presented by the VSFBI in ozone production were 620 gr/m3 and 0.155 gr/min. Also, the maximum electrical efficiency was 91%; it was presented by the CSFBI without PDM. [ABSTRACT FROM AUTHOR]

This paper presents an igniter circuit for high-intensity-discharge (HID) lamps based on an inverter and a resonant tank that has been adapted to stabilize inductively an HID lamp by means of applying low-frequency quasi-square waveforms to voltage and current in the lamp in order to reduce the presence of the acoustic resonances. With the proposed improvement, the igniter circuit performs three different functions: 1) the lamp ignition; 2) the arc stabilization; and 3) the acoustic resonances reduction. This proposal allows the use of fewer components, and less energy processing is minimized, so the resulting ballast is cheaper and more efficient than other ballast that avoids the acoustic resonances when they are working with square waveforms in the lamp voltage and current. The circuit was validated experimentally by using a 70 W conventional high-pressure sodium lamp, which is operated with a frequency of 2 kHz. The results were an electrical efficiency of 94%, a crest factor in the lamp current of 1.41, and it was not observed the presence of acoustic resonances. [ABSTRACT FROM AUTHOR]

The arrangement of the full-bridge, current-source inverter as a power supply for ozone generators providing high power factor (PF) and high electrical efficiency in a single stage is the main contribution of this paper. The corresponding design, simulation, and experimental results are presented. Also, the use of the current-fed, full-bridge resonant inverter for PF correction in ozone generation applications is discussed. The proposed power supply consists of an ac supply, a single rectifier bridge, an input inductor to the inverter, four switches, an LC parallel resonant tank, a resonant transformer, and a set of ozone generating cells. Experimental results with the proposed topology provided 96% for PF, 91% for electrical efficiency, and ozone production of 614 mgO3/min, satisfying the requirements of the standard 61000-3-2, class A. [ABSTRACT FROM AUTHOR]