Search

Background: Laparoendoscopic single-site surgery (LESS) is limited by loss of triangulation and internal instruments conflict. To overcome these difficulties, some concepts have been introduced, namely, articulating instruments and cross-handed manipulation, which causes the right hand to control the left instrument tip and vice versa. The aim of this study was to compare task performance with different approaches based on a mechanical evaluation platform., Methods: A LESS mechanical evaluation platform was set up to investigate the performance of 2 tasks (suture pass-through rings and clip-cut) with 3 different settings: uncrossed manipulation with straight instruments (group A, the control group), uncrossed manipulation with articulating instruments (group B), and cross-handed manipulation with articulating instruments (group C). The operation time and average load required for accomplishment of the standard tasks were measured., Results: Group A presented significantly better time scores than group B, and group C consumed the longest time to accomplish the 2 tasks (P < .05). Comparing of average load required to perform the suture pass-through rings task, it differed significantly between dominant and nondominant hand in all groups (P < .01) and was less in group A and group B than group C in dominant hand (P < .01), while it was almost the same in all groups in the nondominant hand. In terms of average load requirement to accomplish clip-cut task, it was almost equal not only between group A and B but also between dominant and nondominant hand while the increase reached statistical significance when comparing group C with other groups (P < .05)., Conclusions: Compared with conventional devices and maneuvering techniques, articulating instruments and cross-handed manipulation are associated with longer operation time and higher workload. Instruments with better maneuverability should be developed in the future for LESS., (© The Author(s) 2013.)

Objective: Analysis of mechanical measurements in laparoendoscopic single-site surgery (LESS) is important for instrument design and surgical simulators. The aim of this study was to develop a measuring system for different instruments and manipulations in LESS using a single-incision laparoscopic surgery (SILS) port., Methods: The loads on the SILS port were applied and recorded by the universal material testing machine by the following method. The handle of the forceps inserted in the SILS port was connected with the machine by a fishing wire and pulled at a constant rate. The surface deformations (displacements and strains) of the SILS port were recorded with digital image correlation (DIC) simultaneously. The correlation between deformation measurements and loads were analyzed. This experiment was repeated 8 times., Results: Strong correlations existed between deformation measurements calculated by DIC and objective criteria "loads" applied and recorded by the universal material testing machine (r>0.98). The correlation coefficients were statistically significant (P<.001). A high repeatability of the results appeared in all repetitions of the experiment., Conclusions: A DIC measurement system has been developed for LESS, and comprehensive mechanical parameters of a SILS port can be obtained precisely by using this system. It is reliable and repeatable for evaluation of instruments and manipulations in LESS.