Search

A 3D graphene foam made of interconnected multilayer graphene flakes was produced on optical fibres (OF) by laser-induced transformation of a polyimide (PI) film coated on the OF cladding. This material, known as laser-induced graphene (LIG), was explored in the electrochemical detection and quantification of dopamine (DA) at physiologically relevant concentrations in the presence of the most relevant interfering molecules in biological fluids, ascorbic acid (AA) and uric acid (UA). The measured limit of detection is 100 nM, the linear range is 0.1 to 5.0 μM and a maximum sensitivity of 5.0 µA µM−1 cm−2 was obtained for LIG decorated with Pt nanoparticles (NPs). Moreover, immunity to AA and UA interference and to fouling was attained by decorating the LIG electrode with Pt NPs and coating it with Nafion. These figures of merit underline the potential of these sensors for the quantification of physiologically relevant concentrations of DA in biological fluids, paving the way for the development of hybrid electrochemical/optical sensing actuating platforms in a lab-on-fibre configuration, with relevant applications in biomedical engineering. The advantages of this hybrid arrangement include the possibility of in situ counterproofing, extended measuring ranges, photoelectrochemical detection and the probing of inaccessible places. This elegant approach can also provide a simple and cost-effective way to fabricate biomedical devices with extended functionality, such as medical optical probes with added electrochemical capabilities and optogenetics combined with local electrochemical detection, among others. [ABSTRACT FROM AUTHOR]

Laser‐induced graphene (LIG) is inexpensive, fast, and easy to produce when compared to many other forms of graphene. Within the biosensing field, LIG electrodes are most often produced via infrared (IR) laser irradiation of polyimide sheets. Nevertheless, the usage of ultraviolet (UV) laser to produce LIG provides advantages in terms of sensor miniaturization because of its inherently higher scribing resolution. Yet, studies on the electrochemical performance of UV LIG, its relation with morphological and structural aspects as well as its comparison with IR LIG are still lacking. This work shows that both LIGs present swift electron transfer kinetics constituting excellent electrodes for electroanalysis. Extreme sensitivities of 93 and 58 µA µm−1 cm−2 at physiologically relevant dopamine (DA) concentrations are found for IR and UV LIG, respectively. Such sensitivities and good selectivity are achieved in the presence of physiologically relevant concentrations of ascorbic and uric acids, contrasting to the related literature employing IR LIG where such interferents are below the physiological range. Despite providing lower sensitivity, UV LIG is still an excellent material for DA biosensors, with the above‐mentioned advantages in terms of miniaturization. To our knowledge, these are among the highest sensitivities reported for voltammetric measurement of DA using carbon‐based materials. [ABSTRACT FROM AUTHOR]

Zinc oxide (ZnO)/laser-induced graphene (LIG) composites were prepared by mixing ZnO, grown by laser-assisted flow deposition, with LIG produced by laser irradiation of a polyimide, both in ambient conditions. Different ZnO:LIG ratios were used to infer the effect of this combination on the overall composite behavior. The optical properties, assessed by photoluminescence (PL), showed an intensity increase of the excitonic-related recombination with increasing LIG amounts, along with a reduction in the visible emission band. Charge-transfer processes between the two materials are proposed to justify these variations. Cyclic voltammetry (CV) and electrochemical impedance spectroscopy evidenced increased electron transfer kinetics and an electrochemically active area with the amount of LIG incorporated in the composites. As the composites were designed to be used as transducer platforms in biosensing devices, their ability to detect and quantify hydrogen peroxide (H2O2) was assessed by both PL and CV analysis. The results demonstrated that both methods can be employed for sensing, displaying slightly distinct operation ranges that allow extending the detection range by combining both transduction approaches. Moreover, limits of detection as low as 0.11 mM were calculated in a tested concentration range from 0.8 to 32.7 mM, in line with the values required for their potential application in biosensors. [ABSTRACT FROM AUTHOR]