Search

This paper describes a novel method for calibrating dc-precise magnetometers in the low field range ($\pm 100~\mu \text{T}$), which gives acceptable results even in laboratory conditions with significant magnetic interference. By introducing a closely mounted reference magnetometer and a specific calibration procedure, it is possible to compensate for the external magnetic field disturbances caused, e.g., by the local transportation operated with dc power supplies. The field compensation occurs only shortly after the calibrating coils are energized. In this case, the leakage of the coil’s magnetic flux to the reference sensor due to the cancelation of the time-varying compensating field was negligible. When using 60 cm coils and reference sensor in 2.5 m distance, we were able to calculate magnetometer gains with a standard deviation of 91 ppm. We show that an overall uncertainty of 0.1% can be achieved. [ABSTRACT FROM AUTHOR]

Magnetic field sensors based on anisotropic magnetoresistance (AMR) are widely used in many scientific and industrial applications. The AMR sensor sensitivity is superior to Hall probes and size and power consumption is superior to fluxgates. However, the noise properties and the temperature stability of AMR sensors are typically worse than for fluxgates. These properties define the typical applications—less precise vectorial or gradient measurements of the magnetic field within less than ±1 mT range. AMR sensors are typically calibrated for sensitivity, offset, and orthogonality errors. However, there is another important source of error—sensitivity to the magnetic field applied in the perpendicular direction to the measurement axis. This so-called cross-field error is inherent to AMR sensors and can influence the measurements significantly. Flipping (set/reset pulses) and closed-loop operation of the sensor can reduce the cross-field error. In this paper, we present a novel approach using full vectorial compensation of the measured magnetic field resulting in a complete elimination of the cross-field effect. The vectorial compensation provided superior results over alternative approaches that were also evaluated. [ABSTRACT FROM PUBLISHER]

Vector feedback is a concept which can significantly improve linearity and stability of a magnetic field sensor. The feedback coils effectively cancel the measured magnetic field in the inner volume of the triaxial sensor. Thus, in case of fluxgates, it suppresses one possible source of nonlinearity—cross-field sensitivity error. The triaxial sensor axes orthogonality should be primarily defined by the orientation of the feedback coils, while the sensitivities are defined by feedback coil constants. The influence of the homogeneity of the feedback field and the influence of the sensor inner layout on calibration parameters of a vectorially compensated triaxial fluxgate magnetometer are presented. [ABSTRACT FROM PUBLISHER]

METGLAS 2714AZ material has been stress annealed without any applied magnetic field to obtain suitable magnetic properties for use as low-noise fluxgate sensor core. During the development of magnetic cores, we observed an unusual change of the anisotropy direction on Co-based amorphous alloy of METGLAS 2714 AZ. The anisotropy direction moves from its original direction along the ribbon axis to the transverse direction as expected but for short annealing times the process is not monotonous. This occurs when annealing is performed above the Curie temperature. We explain it as a mixture of different anisotropies, which are built and released during the annealing process, since the 2714AZ ribbon has manufacturer-induced anisotropy in ribbon axis. The effect of ribbon cooling on the ribbon properties is also shown as annealing in the radiation furnace was done in different ways. [ABSTRACT FROM AUTHOR]