Search

The InSight (Interior Exploration using Seismic Investigations, Geodesy and Heat Transport) mission landed on the surface of Mars on November 26, 2018. One of the scientific instruments in the payload that is essential to the mission is the SEIS package (Seismic Experiment for Interior Structure) which includes a very broadband and a short period seismometer. More than one year since the landing, SEIS continues to be fully operational and has been collecting an exceptional data set which contains not only the signals of seismic origins, but also noise and artifacts induced by the martian environment, the hardware on the ground that includes the seismic sensors, and the programmed operational activities of the lander. Many of these non-seismic signals will be unfamiliar to the scientific community. In addition, many of these signals have signatures that may resemble seismic events either or both in time and frequency domains. Here, we report our observations of common non-seismic signals as seen during the first 478 sols of the SEIS data, i.e. from landing until the end of March 2020. This manuscript is intended to provide a guide to scientists who use the data recorded on SEIS, detailing the general attributes of the most commonly observed non-seismic features. It will help to clarify the characteristics of the seismic dataset for future research, and to avoid misinterpretations when searching for marsquakes., Physics of the Earth and Planetary Interiors, 310, ISSN:0031-9201, ISSN:1872-7395

The rate of occurrence of High Frequency (HF) marsquakes, as recorded by InSight at Homestead Hollow, Elysium Planitia, increased after about Ls =33°, and ceased almost completely by Ls =187°, following an apparently seasonal variation with a peak rate near aphelion. We define seismic rate models based on the declination of the Sun, annual solar tides, and the annual CO2 cycle as measured by atmospheric pressure. Evaluation of Akaike weights and evidence ratios shows that the declination of the Sun is the most likely, and the CO2 cycle the least likely driver of this seismic activity, although the discrimination is weak, and the occurrence of a few events in August 2020 is in favor for a triggering by CO2 ice load. We also show that no periodicity related to Phobos' orbit is present in the HF event sequence. Event rate forecasts are presented to allow further discrimination of candidate mechanisms from future observations., Earth and Planetary Science Letters, 576, ISSN:0012-821X, ISSN:1385-013X

The instrument package SEIS (Seismic Experiment for Internal Structure) with the three very broadband and three short‐period seismic sensors is installed on the surface on Mars as part of NASA's InSight Discovery mission. When compared to terrestrial installations, SEIS is deployed in a very harsh wind and temperature environment that leads to inevitable degradation of the quality of the recorded data. One ubiquitous artifact in the raw data is an abundance of transient one‐sided pulses often accompanied by high‐frequency spikes. These pulses, which we term “glitches”, can be modeled as the response of the instrument to a step in acceleration, while the spikes can be modeled as the response to a simultaneous step in displacement. We attribute the glitches primarily to SEIS‐internal stress relaxations caused by the large temperature variations to which the instrument is exposed during a Martian day. Only a small fraction of glitches correspond to a motion of the SEIS package as a whole caused by minuscule tilts of either the instrument or the ground. In this study, we focus on the analysis of the glitch+spike phenomenon and present how these signals can be automatically detected and removed from SEIS's raw data. As glitches affect many standard seismological analysis methods such as receiver functions, spectral decomposition and source inversions, we anticipate that studies of the Martian seismicity as well as studies of Mars' internal structure should benefit from deglitched seismic data., Plain Language Summary: The instrument package SEIS (Seismic Experiment for Internal Structure) with two fully equipped seismometers is installed on the surface of Mars as part of NASA's InSight Discovery mission. When compared to terrestrial installations, SEIS is more exposed to wind and daily temperature changes that leads to inevitable degradation of the quality of the recorded data. One consequence is the occurrence of a specific type of transient noise that we term “glitch”. Glitches show up in the recorded data as one‐sided pulses and have strong implications for the typical seismic data analysis. Glitches can be understood as step‐like changes in the acceleration sensed by the seismometers. We attribute them primarily to SEIS‐internal stress relaxations caused by the large temperature variations to which the instrument is exposed during a Martian day. Only a small fraction of glitches correspond to a motion of the whole SEIS instrument. In this study, we focus on the detection and removal of glitches and anticipate that studies of the Martian seismicity as well as studies of Mars's internal structure should benefit from deglitched seismic data., Key Points: Glitches due to steps in acceleration significantly complicate seismic records on Mars. Glitches are mostly due to relaxations of thermal stresses and instrument tilt. We provide a toolbox to automatically detect and remove glitches., Centre National d'Etudes Spatiales (CNES), InSight PSP Program, Agence Nationale de la Recherche http://dx.doi.org/10.13039/501100001665, ANR‐19‐CE31‐0008‐08