Search

A major application of microfluidic paper-based analytical devices (mu PADs) includes the field of point-of-care (POC) diagnostics. It is important for POC diagnostics to possess properties such as ease-of-use and low cost. However, mu PADs need multiple instruments and fabrication steps. In this study, two different chemicals (Hexamethyldisilazane and Tetra-ethylorthosilicate) were used, and three different methods (heating, plasma treatment, and microwave irradiation) were compared to develop mu PADs. Additionally, an inkjet-printing technique was used for generating a hydrophilic channel and printing certain chemical agents on different regions of a modified filter paper. A rapid and effective fabrication method to develop mu PADs within 10 min Was introduced using an inkjet-printing technique in conjunction with a microwave irradiation method. Environmental scanning electron microscope (ESEM) and x-ray photoelectron spectroscopy (XPS) were used for morphology characterization and determining the surface chemical compositions of the modified filter paper, respectively. Contact angle measurements were used to fulfill the hydrophobicity of the treated filter paper. The highest contact angle value (141 degrees +/- 1) was obtained using the microwave irradiation method over a period of 7 min, when the filter paper was modified by TEOS. Furthermore, by using this method, the XPS results of TEOS-modified filter paper revealed Si2p (23%) and Si-O bounds (81.55%) indicating the presence of Si-O-Si bridges and Si(OEt) groups, respectively. The ESEM results revealed changes in the porous structures of the papers and decreases in the pore sizes. Washburn assay measurements tested the efficiency of the generated hydrophilic channels in which similar water penetration rates were observed in the TEOS-modified filter paper and unmodified (plain) filter paper. The validation of the developed mu PADs was performed by utilizing the rapid urease test as a model test system. The detection limit of the developed mu PADs was measured as 1 unit ml(-1) urease enzyme in detection zones within a period of 3 min. The study findings suggested that a combination of microwave irradiation with inkjet-printing technique could improve the fabrication method of mu PADs, enabling faster production of mu PADs that are easy to use and cost-effective with long shelf lives. (C) 2016 Elsevier B.V. All rights reserved.

Microwave irradiation can facilitate the dissolution and delignification of lignocelluloses in ionic liquids compared to simple oil bath heating as demonstrated here where 92.5% of 0.5 g ground southern yellow pine was dissolved in 10 g 1-ethyl-3-methylimidazolium acetate using microwave irradiation in only 4 min. Cellulose-rich material (pulp) regenerated from the wood/ionic liquid solution had a lignin content of ∼10%; significantly lower than the lignin content of the original wood (31.9%) or that of pulp obtained from the same experiment but using 16 h of oil bath heating (16–24%). The 10% lignin content obtained with the microwave method was close to that of pulp obtained from the oil bath heating method when polyoxometalate catalysts were used (5–9%).