Search

We report contrasting pressure–temperature–time (P–T–t) paths of migmatites developed in the highest‐grade metamorphic zone (Grt–Crd zone) and the contact metamorphic zone (Crd–Kfs zone) of the Mikawa area, Ryoke belt, southwest Japan to discuss the complex P–T–D–t evolution of the middle crust that experienced pulsed granitoid intrusions. In the Grt–Crd zone, sillimanite‐grade high‐T metamorphic condition prevailed from ca. 97 to 87 Ma, followed by cooling to ~500 °C, ~4 kbar. The intrusion of gneissose granitoids below the Grt–Crd zone isobarically reheated the Grt–Crd zone rocks again to the sillimanite‐grade high‐T condition at ca. 84 Ma. This was followed by ca. 71–70 Ma contact metamorphism. Ductile deformation that formed and folded the foliation of migmatites started before ca. 89 Ma and continued at least until ca. 84 Ma in the Grt–Crd zone. On the other hand, ca. 74 Ma age of the Crd–Kfs zone migmatite developed around the Inagawa Granodiorite in addition to ca. 70 Ma age of a syn‐tectonic pegmatite vein revealed that the intrusion of "75–69 Ma granitoids" caused partial melting and locally triggered low‐strain ductile deformation in their contact aureoles. Comparison with other areas of the Ryoke belt suggests that plutono‐metamorphic evolution of the Mikawa and Aoyama areas are similar with each other in that ca. 80 Ma reheating events (i.e., contact metamorphism) are observed, while absence of separate reheating event postdating peak metamorphism in the Yanai area is a rather uncommon feature in the Ryoke belt. [ABSTRACT FROM AUTHOR]

Chemical Th-U-total Pb isochron method (CHIME) monazite dating was carried out for pelitic-psammitic migmatites and the Ao granite (one of the Younger Ryoke granites) from the Aoyama area, Ryoke metamorphic belt, Southwest Japan. The Ao granite gives an unequivocal age of 79.8 ± 3.9 Ma. The monazite grains in migmatites yield an age of 96.5 ± 1.9 Ma with rims and patchy domains of 83.5 ± 2.4 Ma. The 83.5 ± 2.4-Ma overprinting on migmatites over the garnet-cordierite zone suggests a wide and combined effect of thermal input and fluid activity on the monazite grains caused by the contact metamorphism by the Younger Ryoke granites including the Ao granite. This contact metamorphism has not been detected from the major metamorphic mineral assemblage previously, possibly because the migmatites already possessed the high-temperature mineral assemblage before the granite intrusions and were immune from contact metamorphism in terms of major metamorphic minerals. However, monazite records contact metamorphism clearly. Therefore, the field mapping of the CHIME monazite age is a powerful tool for recognition of polymetamorphism in high-temperature metamorphic terrains where later thermal effects can not be easily detected by the growth of new major metamorphic minerals. [ABSTRACT FROM AUTHOR]

Abstract: Degree of partial melting of pelitic migmatites from the Aoyama area, Ryoke metamorphic belt, SW Japan is determined utilizing whole-rock trace element compositions. The key samples used in this study were taken from the migmatite front of this area and have interboudin partitions filled with tourmaline-bearing leucosome. These samples are almost perfectly separated into leucosome (melt) and surrounding matrix (solid). This textural feature enables an estimate of the melting degree by a simple mass-balance calculation, giving the result of 5–11 wt.% of partial melting. Similar calculations applied to the migmatite samples, which assume average migmatite compositions to be the residue solid fraction, give degree of melt extraction of 12–14 wt.% from the migmatite zone. The similarity of the estimated melting degree of 5–11 wt.% with that in other tourmaline–leucogranites, such as Harney Peak leucogranite and Himalayan leucogranites, in spite of differences in formation process implies that the production of tourmaline leucogranites is limited to low degrees of partial melting around 10 wt.%, probably controlled by the breakdown of sink minerals for boron such as muscovite and tourmaline at a relatively early stage of partial melting. Because the amount of boron originally available in the pelitic source rock is limited (on average ∼100 ppm), ∼10 wt.% of melting locally requires almost complete breakdown of boron sink mineral(s) in the source rock, in order to provide sufficient boron into the melt to saturate it in tourmaline. This, in turn, means that boron-depleted metapelite regions are important candidates for the source regions of tourmaline leucogranites. [Copyright &y& Elsevier]

The mode of occurrence of borosilicates and the breakdown fronts of prograde tourmaline (tourmaline-out isograd) in three anatectic migmatite regions of the Ryoke metamorphic belt, SW Japan, are reported. The breakdown of tourmaline in the migmatite zones and release of boron into the melts, followed by the extraction of the boron-bearing melts from the migmatite zones occurred throughout the Ryoke metamorphic belt. Retrograde, magmatic tourmaline in interboudin partitions filled with leucosome is useful for calculating the degree of partial melting in the migmatites. Using boron contents in the leucosomes and pelitic schists, the degree of partial melting at the migmatite front of the Aoyama area is estimated to be 12 wt.%. Extraction of the boron-bearing melt is suggested by the boron-depleted nature of the migmatites. Connection of boudinage structures probably supplied the vertical pathways of the segregated melts, and major transport of the melts was accomplished by dyking. Irregularly shaped, amoeboid tourmaline locally occurs on the high-temperature side of the tourmaline-out isograds in the Yanai and Komagane areas, implying incomplete extraction of boron-bearing melts from those areas. Discriminating retrograde from prograde tourmaline enables correct recognition of the tourmaline-out isograd. The amount of retrograde tourmaline in migmatites can potentially be used as an indicator of the degree of melt extraction from them. [ABSTRACT FROM PUBLISHER]