Search

An in-depth investigation of how various illumination conditions influence microalgal growth in photobioreactors (PBR) has been presented. Effects of both the light emission spectrum (white and red) and the light incident angle (0° and 60°) on the PBR surface were investigated. The experiments were conducted in two fully controlled lab-scale PBRs, a torus PBR and a thin flat-panel PBR for high cell density culture. The results obtained in the torus PBR were used to build the kinetic growth model of Chlorella vulgaris taken as a model species. The PBR model was then applied to the thin flat-panel PBR, which was run with various illumination conditions. Its detailed representation of local rate of photon absorption under various conditions (spectral calculation of light attenuation, incident angle influence) enabled the model to take into account all the tested conditions with no further adjustment. This allowed a detailed investigation of the coupling between radiation field and photosynthetic growth. Effects of all the radiation conditions together with pigment acclimation, which was found to be relevant, were investigated in depth. © 2016 American Institute of Chemical Engineers Biotechnol. Prog., 32:247-261, 2016., (© 2016 American Institute of Chemical Engineers.)

Biomass decay rate (BDR) in the dark was investigated for Chlamydomonas reinhardtii (microalga) and Arthrospira platensis (cyanobacterium). A specific setup based on a torus photobioreactor with online gas analysis was validated, enabling us to follow the time course of the specific BDR using oxygen monitoring and mass balance. Various operating parameters that could limit respiration rates, such as culture temperature and oxygen deprivation, were then investigated. C. reinhardtii was found to present a higher BDR in the dark than A. platensis, illustrating here the difference between eukaryotic and prokaryotic cells. In both cases, temperature proved an influential parameter, and the Arrhenius law was found to efficiently relate specific BDR to culture temperature. The utility of decreasing temperature at night to increase biomass productivity in a solar photobioreactor is also illustrated., (Copyright © 2013 Elsevier Ltd. All rights reserved.)

Photosynthetic hydrogen production under light by the green microalga Chlamydomonas reinhardtii was investigated in a torus-shaped PBR in sulfur-deprived conditions. Culture conditions, represented by the dry biomass concentration of the inoculum, sulfate concentration, and incident photon flux density (PFD), were optimized based on a previously published model (Fouchard et al., 2009. Biotechnol Bioeng 102:232-245). This allowed a strictly autotrophic production, whereas the sulfur-deprived protocol is usually applied in photoheterotrophic conditions. Experimental results combined with additional information from kinetic simulations emphasize effects of sulfur deprivation and light attenuation in the PBR in inducing anoxia and hydrogen production. A broad range of PFD was tested (up to 500 µmol photons m(-2) s(-1) ). Maximum hydrogen productivities were 1.0 ± 0.2 mL H₂ /h/L (or 25 ± 5 mL H₂ /m(2) h) and 3.1 mL ± 0.4 H₂ /h L (or 77.5 ± 10 mL H₂ /m(2) h), at 110 and 500 µmol photons m(-2) s(-1) , respectively. These values approached a maximum specific productivity of approximately 1.9 mL ± 0.4 H₂ /h/g of biomass dry weight, clearly indicative of a limitation in cell capacity to produce hydrogen. The efficiency of the process and further optimizations are discussed., (Copyright © 2011 Wiley Periodicals, Inc.)

The validity of a simple, reliable, and useful recently published formula enabling to calculate the maximum volumetric biomass productivities in photobioreactors (PBRs) was investigated through the cultivation of the microalga Chlamydomonas reinhardtii. Experimental maximum kinetic performances accurately obtained in two different, artificially lightened torus-plane and cylindrical reactors having the same specific illuminated area confirmed the availability, power, and robustness of such formula. The predictive kinetic parameters previously proposed and validated with cyanobacteria were then proved general and robust in case of eukaryotic microalgae, as postulated in the founding article. In this case, an additional criterion requiring rigorous control of the working illuminated fraction gamma = 1 +/- (15%) inside the reactor is demonstrated. For this, the usefulness and reliability of a generalized two-flux model accurately describing the radiation field inside turbid culture media of C. reinhardtii were also established in this article. These important results contribute to identify the main engineering factors governing light-limited PBRs functioning and then to clarify some misinterpretations widely reported in the literature. Together with the referenced previous work, this article gives a framework toward optimal conception of PBRs on a strong physical basis.

The light attenuation in a photobioreactor is determined using a fully predictive model. The optical properties were first calculated, using a data bank of the literature, from only the knowledge of pigments content, shape, and size distributions of cultivated cells which are a function of the physiology of the current species. The radiative properties of the biological turbid medium were then deduced using the exact Lorenz-Mie theory. This method is experimentally validated using a large-size integrating sphere photometer. The radiative properties are then used in a rectangular, one-dimensional two-flux model to predict radiant light attenuation in a photobioreactor, considering a quasi-collimated field of irradiance. Combination of this radiative model with the predictive determination of optical properties is finally validated by in situ measurement of attenuation profiles in a torus photobioreactor cultivating the microalgae Chlamydomonas reinhardtii, after a complete and proper characterization of the incident light flux provided by the experimental set-up., (Copyright 2005 Wiley Periodicals, Inc)

Light is the main limiting factor in photoautotrophic-intensive production of microorganisms, and improvement of its use is an important concern for photobioreactor design and operation. Swirling flows, which are known to improve mass and photon transfers, were applied to annular light chambers of a photobioreactor and studied by simulation and microalgal culture. Two hydrodynamic conditions were compared: axial flow generating poor radial mixing, and tangential flow generating three-dimensional swirling motion. Batch and continuous cultures of the Rhodophyte Porphyridium cruentum were performed in a 100-L, 1.5-m(2), fully controlled photobioreactor with eight light chambers. The inlet design of these chambers was modified to create the hydrodynamic conditions for comparison. Various intensities of swirling motion were used, characterized by the velocity factor (VF), defined as the ratio between annular chamber flow and inlet aperture sections. Experiments were performed within the range of photon flux densities (PFD) optimizing the yield of light energy transformation into living substance for the species and the temperature used. Culture kinetics with swirling flows generated by apertures of VF = 2, 4, and 9 were compared with pseudoaxial VF = 2 chosen as reference. Batch cultures with VF = 4 swirling flow showed no significant difference, whereas continuous cultures proved more discriminating. Although no significant difference was obtained for VF = 2, a 7% increase of steady-state productivity and a 26% decrease in time required to reach this steady state were obtained with VF = 4 swirling flow. This beneficial effect of swirling flow could have accounted for increased mixing. Conversely, VF = 9 swirling flow resulted in a 9% decrease of steady-state productivity and a 9% increase in the time required to reach this steady state, a negative effect that could have accounted for increased shear stress. CO(2) bioconversion yield at steady state showed a 34% increase for VF = 4. These results suggest that swirling motion makes microalgal cultures more efficient, provided that the resulting adverse effects remain acceptable. Experimental investigation was completed by a theoretical approach in which simulation of continuous cultures of P. cruentum was based on the hydrodynamic conditions achieved in the photobioreactor. Although the results obtained with pseudoaxial flow were correctly predicted, simulations with swirling flow showed a marked enhancement of productivity not observed experimentally. The influence of side effects induced by increased mixing (particularly hydrodynamic shear stress) was considered with respect to modeling assumptions. Comparison of experimental results with theoretical simulation provided a better understanding of the mixing effect, a key factor in improving the efficiency of such bioprocesses., (Copyright 2004 Wiley Periodicals, Inc. Biotechnol Bioeng 84: 544-551, 2003.)

A deterministic Markov process was developed to estimate the efficiency of a fully controlled photobioreactor by calculating the growth of the Rhodophyte Porphyridium cruentum. It was assumed that microalgal growth, in strictly controlled and non-nutrient-limited conditions, is a function of the amount of light energy received. The light sources delivered a continuous 206 microE m(-2) s(-1) average photon flux density to cultures reaching concentrations of 3 g l(-1) in batch and 0.7 g l(-1) in chemostat. The concentration time-courses calculated compared satisfactorily with measured results for both batch and continuous cultures. The quality of simulation in these two cases validated the hypotheses made, especially for the linearity of light bioconversion, and allowed the model to be used for further exploration of the photobioreactor-operating domain. Distribution of the specific growth rate as a function of time and radial position was compared for the two simulated cases. The use of an initial batch of several days prior to the dilution of a continuous culture proved theoretically beneficial for overall production. The influence of the dilution rate and of light-path length on surface productivity and concentration at steady state were demonstrated.