Search

We report on recent experiments at the Soreq Applied Research Accelerator Facility Liquid-Lithium Target (SARAF-LiLiT) laboratory dedicated to the study of s-process neutron capture reactions. The kW-power proton beam at 1.92 MeV (1-2 mA) from SARAF Phase I yields high-intensity 30 keV quasi-Maxwellian neutrons (3-5×1010 n/s). The high neutron intensity enables Maxwellian averaged cross sections (MACS) measurements of low-abundance or radioactive targets. Neutron capture reactions on the important s-process branching points 147Pm and 171Tm were investigated by activation in the LiLiT neutron beam and γ-measurements of their decay products. MACS values at 30 keV extracted from the experimental spectrum-averaged cross sections are obtained and will be discussed. The Kr region, at the border between the so-called weak and strong s-process was also investigated. Atom Trap Trace Analysis (ATTA) was used for the first time for the measurement of a nuclear reaction cross section. After activation in the quasi-Maxwellian neutron flux at SARAF-LiLiT, isotopic ratios were determined for 81Kr(230 ky)/80Kr and 85gKr(10.8 y)/84Kr. The latter ratio was confirmed both by low-level β counting and γ spectrometry. The shorter-lived capture products 79,85m,87Kr were detected by γ -spectrometry and the corresponding neutron-capture MACS of the respective target nuclei 78,84,86Kr were determined. The MACS of the 80Kr(n, γ)81Kr and 84Kr(n, γ)85gKr reactions are still under study. The partial MACS leading to 85mKr(4.5 h) measured in this experiment has interesting implications since this state decays preferentially by γ decay (79%) to 85Rb on a faster time scale than does 85gKr and behaves thus as an s-process branching point. [ABSTRACT FROM AUTHOR]

A compact Liquid Lithium Target (LiLiT) has been operating at SARAF for several years with beam power of several kW (1.9-2.5 MeV, up to 2 mA). When bombarding the lithium with low energy protons neutrons are generated. The neutron source, mainly used for nuclear astrophysics research, was decommissioned in 2016 towards an upgraded model - with possible applications to Boron Neutron Capture Therapy (BNCT) and material-science studies. The improved version has been designed to sustain 50 kW proton beam power (2.5 MeV, ~20 mA) to provide sufficient neutron flux required for clinical BNCT application. The new model has a 50 mm wide lithium jet to enable dissipation of the higher beam power and an improved heat exchanger to remove the power to a secondary cooling loop. A new Annular Linear INduction electro-magnetic pump (ALIN) has been designed and built to provide the required lithium flow rate. Other mechanical improvements facilitate the maintenance of the system and the robustness of operation. Radiological risks due to the 7Be produced in the reaction are reduced by using an integrated lead shielding of the lithium reservoir. An integrated neutron moderator is being designed to adjust the neutron energy to the spectrum best suited to BNCT. A low power (6 kW) model of the new design with a narrower nozzle (18 mm wide) and a rotating-magnet electro-magnetic pump is operating at SARAF to support the ongoing astrophysics and nuclear research program [1], [2]. To fulfill clinical BNCT, the upgraded LiLiT model will require an accelerator of appropriate energy and intensity. The design features of the new system are presented in this paper. [ABSTRACT FROM AUTHOR]