Search

An objective technique based on the time-frequency analysis of otoacoustic emissions is proposed to get fast and stable estimates of cochlear tuning. Time-frequency analysis allows one to get stable measurements of the delay/frequency function, which is theoretically expected to be a function of cochlear tuning. Theoretical considerations and numerical solutions of a nonlinear cochlear model suggest that the average phase-gradient delay of the otoacoustic emission single-reflection components, weighted, for each frequency, by the amplitude of the corresponding wavelet coefficients, approximately scales as the square root of the cochlear quality factor. The application of the method to human stimulus-frequency and transient-evoked otoacoustic emissions shows that tuning decreases approximately by a factor of 2, as the stimulus level increases by 30 dB in a moderate stimulus level range. The results also show a steady increase of tuning with increasing frequency, by a factor of 2 between 1 and 5 kHz. This last result is model-dependent, because it relies on the assumption that cochlear scale-invariance breaking is only due to the frequency dependence of tuning. The application of the method to the reflection component of distortion product otoacoustic emissions, separated using time-frequency filtering, is complicated by the necessity of effectively canceling the distortion component. [ABSTRACT FROM AUTHOR]

In this study, a systematic analysis of the dependence on stimulus level and primary frequency ratio r of the different components of human distortion product otoacoustic emissions has been performed, to check the validity of theoretical models of their generation, as regards the localization of the sources and the relative weight of distortion and reflection generation mechanisms. 2f1 - f2 and 2f2 - f1 distortion product otoacoustic emissions of 12 normal hearing ears from six human subjects have been measured at four different levels, in the range [35, 65] dB sound pressure level, at eight different ratios, in the range [1.1, 1.45]. Time-frequency filtering was used to separate distortion and reflection components. Numerical simulations have also been performed using an active nonlinear cochlear model. Both in the experiment and in the simulations, the behavior of the 2f1 - f2 distortion and reflection components was in agreement with previous measurements and with the predictions of the two-source model. The 2f2 - f1 response showed a rotating-phase component only, whose behavior was in general agreement with that predicted for a component generated and reflected within a region basal to the characteristic place of frequency 2f2 - f1, although alternative interpretations, which are also discussed, cannot be ruled out. [ABSTRACT FROM AUTHOR]