Search

The permeability of aromatic hydrocarbons, i.e. BTEX and styrene, through PVC pipes was investigated using a 6-cm pipe-bottle model with direct solid-phase microextraction (SPME) sampling. It was found that an aromatic hydrocarbon with a large molecular size or low polarity may be less permeable through PVC pipes. In addition, the diffusion coefficients of BTEX and styrene in PVC pipes ranged from 4.87 to 7.64 × 10 −8 cm 2 /s. According to the simulation results of a one-dimensional diffusion model, it is speculated that diffusion transport of benzene and toluene in PVC pipes may have non-Fickian behavior. The advantage of using the innovated test model is that SPME provides a nondestructive analytical means to monitor the concentrations of organic compounds in pipe-water. Therefore, the pipe-bottle model developed herein has potential applications in determining the resistance of polymeric pipes to permeation by solvents in the aqueous solution.

Phthalates (PAEs) have high solubility in polymers and are added as plasticisers to increase the flexibility and plasticity of polymeric materials. In this study, methanol, hexane, ethyl ether and acetone were used for the extraction of PAEs from chemical protective gloves at temperatures of 20–80 °C. DEHP (di-2-ethylhexyl phthalate) and DBP (di-n-butyl phthalate) were extracted from neoprene, nitrile and PVC glove samples using the above four solvents. The extraction level of DEHP from the glove samples was proportional to the Log K ow values of the extraction solvents. This result implied that PAEs were more soluble in non-polar solvents and were likely to be extracted from the gloves. Increasing the extraction temperature resulted in a higher extraction of DBP and DEHP from the gloves. In the ASTM F739 permeation method, the aromatic solvents permeated through the glove samples and dissolved DEHP. If the permeant and DEHP had similar solubility parameters, DEHP was likely to be leached from the gloves. The modelling results indicated that the permeation behaviour of the organic solvent in the PVC glove was non-Fickian diffusion. It was speculated that the plasticiser increased the diffusion coefficients of the permeants in the PVC gloves. This study suggested that the potential dissolution and leaching of PAEs from chemical protective gloves should be a concern for workers who handle organic solvents.

Phthalate esters (PAEs) have been widely added as the plasticizer to increase the flexibility and ductility of polymeric materials. In this study, organic solvents, such as methanol, hexane, ethyl ether and acetone, were used for the direct extraction of plasticizers in neoprene, nitrile, and PVC gloves, under a temperature range of 20-80°C. The results showed that DEHP (Di-2-ethylhexyl phthalate) and DBP (Di-n-butyl phthalate) were analyzed in all three glove samples. The extraction capability of PAEs from the PVC gloves was the highest, while that from the neoprene gloves was the lowest. It was found that the extraction capabilities of DEHP from the glove samples were proportional to Log Kow of the extraction solvents. This result implied that PAEs were more soluble in a non-polar solvent and likely to be extracted from the glove samples. In addition, the amount of extracted PAEs increased with the experimental temperatures. As workers wearing the chemical protective gloves, there is a need to understand the dissolution potential of PAEs in the gloves and to assess the skin exposure of PAEs.

The chemical resistance of chlorinated hydrocarbons in starch/polyvinyl alcohol (PVA) blends has been investigated using a permeation cell with an in-cell solid phase microextraction (SPME) sampling device. The chlorinated hydrocarbon with a large molecule size or lower polarity was found to be less permeable through the starch/PVA blends. The tensile strength and chemical resistance of chlorinated hydrocarbons decreased with an increase in the starch content of blends. For the starch/PVA blends, the solubility of chlorinated hydrocarbons was inversely proportional to their molecular weight, molar volume and log Kow. The diffusion coefficients and solubility of permeants were proportional to the content of starch in the starch/PVA blends. It is plausible that the blends will be inclined to the starch characteristics as the plasticizer (i.e. glycerin) disrupts the rigidity arrangements of the starch and PVA. The present work provides information on the extent of organic compound permeation through starch/PVA blends for the practical application.

Polydimethylsiloixane (PDMS) is commonly used as the coated polymer in the solid phase microextraction (SPME) technique. Based on the principle of partitioning, PDMS/SPME can be a fast, economic and solvent-free sampling method to extract volatile organic compounds (VOCs) from gaseous or aqueous samples. This study experimentally investigated the adsorption of benzene and toluene onto PDMS/SPME, and estimated the effective diffusion coefficients of benzene and toluene in the PDMS coating. The results showed that the effective diffusion coefficients of these two compounds did not change with the concentrations of the gaseous or aqueous samples. The effective diffusion coefficients were found to linearly increase with the stirring speeds of the aqueous solution. The empirical model proposed in this study can be used to estimate the effective diffusion coefficients and extraction time at different stirring speeds, which will contribute to the practical applications of the SPME technique.

Polydimethylsiloxane (PDMS)-coated devices were employed to remove benzene from an aqueous solution in a batch reactor. Because of significant swelling of the PDMS membrane, the diffusion of benzene in PDMS exhibited pseudo-Fickian behavior. Based on the solution-diffusion model, the diffusion, solubility and permeation coefficients of benzene in PDMS membrane were obtained and found to be dependent on the benzene concentration of the aqueous solution. The sorption isotherm of benzene solution in PDMS membrane was of the Freundlich type and similar to linear partition. A mass transfer model provided good simulations of the results of aqueous benzene sorbed by the PDMS-coated Tellerette packing using the permeability obtained by the separate sorption experiments. The PDMS extraction technique can be applied to remove benzene from industrial wastewater, especially for lower concentrations.

Many volatile organic compounds (VOCs) are emitted during the manufacturing of thin film transistor liquid crystal displays (TFT-LCDs), exposure to some of which has been reported to be associated with kidney dysfunction, but whether such an effect exists in TFT-LCD industry workers is unknown. This cross-sectional study aimed to investigate the association between exposure to VOCs and kidney dysfunction among TFT-LCD workers. The results showed that ethanol (1811.0+/-1740.4 ppb), acetone (669.0+/-561.0 ppb), isopropyl alcohol (187.0+/-205.3 ppb) and propylene glycol monomethyl ether acetate (PGMEA) (102.9+/-102.0 ppb) were the four dominant VOCs present in the workplace. The 63 array workers studied had a risk of kidney dysfunction 3.21-fold and 3.84-fold that of 61 cell workers and 18 module workers, respectively. Workers cumulatively exposed to a total level of isopropyl alcohol, PGMEA and propylene glycol monomethyl ether> or =324 ppb-year had a significantly higher risk of kidney dysfunction (adjusted OR=3.41, 95% CI=1.14-10.17) compared with those exposed to

The permeation resistance of neoprene gloves to N , N -dimethylformamide (DMF) and methyl ethylketone (MEK) was conducted using the ASTM F739 test method. The permeability coefficients and standardized breakthrough time were found to be significantly different ( p

The permeation of binary and ternary mixtures of benzene, toluene, ethyl benzene and p-xylene through nitrile gloves were investigated using the ASTM F739 test cell. The more slowly permeating component of a mixture was accelerated to have a shorter breakthrough time than its pure form. The larger differences in solubility parameter between a solvent mixture and glove resulted in a lower permeation rate. Solubility parameter theory provides a potential approach to interpret the changes of permeation properties for BTEX mixtures through nitrile gloves. Using a one-dimensional diffusion model based on Fick's law, the permeation concentrations of ASTM F739 experiments were appropriately simulated by the estimated diffusion coefficient and solubility. This study will be a fundamental work for the risk assessment of the potential dermal exposure of workers wearing protective gloves.

In this study, the permeation resistance of nitrile and neoprene gloves to benzene and 1,2-dichloroethane was investigated using two permeation cells according to the ISO 6529, ASTM F739, and EN 374-3 standard test methods. The permeability coefficients were found to significantly increase with the flow rate of the collection medium. The appropriate flow rate of nitrogen collection should be higher than 75 and 150 mL/min for the ISO 6529 and ASTM F739 cells, respectively. For an open-loop system, the permeability coefficient of the ISO 6529 cell was obviously greater than that of the ASTM F739 cell, and the difference between these two cells was statistically significant. On the other hand, the breakthrough time was about 20–30 min for either the ISO 6529 or ASTM F739 cell at different flow rates of nitrogen collection. Fick's diffusion coefficient and solubility of permeant in the polymer glove can be specified as alternative test results for standard methods.

Polydimethylsiloxane (PDMS) is commonly used as the coated polymer in the solid phase microextraction (SPME) technique. In this study, the partition coefficients of organic compounds between SPME/PDMS and the aqueous solution were compiled from the literature sources. The correlation analysis for partition coefficients was conducted to interpret the effect of their physicochemical properties and descriptors on the partitioning process. The PDMS-water partition coefficients were significantly correlated to the polarizability of organic compounds (r = 0.977, p &lt, 0.05). An empirical model, consisting of the polarizability, the molecular connectivity index, and an indicator variable, was developed to appropriately predict the partition coefficients of 61 organic compounds for the training set. The predictive ability of the empirical model was demonstrated by using it on a test set of 26 chemicals not included in the training set. The empirical model, applying the straightforward calculated molecular descriptors, for estimating the PDMS-water partition coefficient will contribute to the practical applications of the SPME technique.

Several researchers have studied the diffusion of organic solvents through chemical protective gloves and have estimated the diffusion coefficients by using various models. In this study, permeation experiments of benzene, toluene, and styrene through nitrile and Neoprene gloves were conducted using the ASTM F-739 standard test method. The diffusion coefficients were estimated using several models from the literature. Using a one-dimensional diffusion equation based on Fick's second law and the estimated diffusion coefficients, the permeation concentrations were simulated and compared with the experimental results. The modeling results indicated that the solubility of the solvent in the glove materials obtained by immersion tests was not an appropriate boundary condition for organic solvent permeation through the polymer gloves. The modeling work of this study will assist industrial hygienists to assess exposure of chemicals to workers through the chemical protective gloves.