Search

Hypertensive disorders are common complications during pregnancy (HDP) with substantial public health impact. Acute and chronic particulate matter (PM) exposure during pregnancy increases the risk of HDP, although the underlying molecular mechanisms remain unclear. Extracellular vesicles (EVs) may be the ideal candidates for mediating the effects of PM exposure in pregnancy as they are released in response to environmental stimuli. The INSIDE project aims to investigate this mechanism in pregnancy outcomes. The study population is enrolled at the Fetal Medicine Unit of Fondazione IRCCS Ca'Granda-Ospedale Maggiore Policlinico at 10-14 weeks of gestation. Exposure to PM 10 and PM 2.5 is assessed using the flexible air quality regional model (FARM) and Bayesian geostatistical models. Each woman provides a blood sample for EV analysis and circulating biomarker assessment. Moreover, a subgroup of recruited women (n = 85) is asked to participate in a cardiovascular screening program including a standard clinical evaluation, a non-invasive assessment of right ventricular function, and pulmonary circulation at rest and during exercise. These subjects are also asked to wear a personal particulate sampler, to measure PM 10 , PM 2.5 , and PM 1 . The INSIDE study is expected to identify the health impacts of PM exposure on pregnancy outcomes.

In the frame of the OFFICAIR project, indoor and outdoor PM2.5 samples were collected in office buildings across Europe in two sampling campaigns (summer and winter). The ability of the particles to deplete physiologically relevant antioxidants (ascorbic acid (AA), reduced glutathione (GSH)) in a synthetic respiratory tract lining fluid, i.e., oxidative potential (OP), was assessed. Furthermore, the link between particulate OP and the concentration of the PM constituents was investigated. The mean indoor PM2.5 mass concentration values were substantially lower than the related outdoor values with a mean indoor/outdoor PM2.5 mass concentration ratio of 0.62 and 0.61 for the summer and winter campaigns respectively. The OP of PM2.5 varied markedly across Europe with the highest outdoor OP(AA) m(-3) and OP(GSH) m(-3) (% antioxidant depletion/m(3) air) values obtained for Hungary, while PM2.5 collected in Finland exhibited the lowest values. Seasonal variation could be observed for both indoor and outdoor OP(AA) m(-3) and OP(GSH) m(-3) with higher mean values during winter. The indoor/outdoor OP(AA) m(-3) and OP(GSH) m(-3) ratios were less than one with 4 and 17 exceptions out of the 40 cases respectively. These results indicate that indoor air is generally less oxidatively challenging than outdoors. Correlation analysis revealed that trace elements play an important role in determining OP, in particular, the Cu content. Indoor air chemistry might affect OP since weaker correlations were obtained for indoor PM2.5. Our findings also suggest that office workers may be exposed to health relevant PM constituents to a different extent within the same building., (Copyright © 2016 Elsevier Ltd. All rights reserved.)

This article focuses on air pollution in specific urban microenvironments and conditions characterized by high relative concentration levels and by possible risk to human health. For this reason, monitoring of particle number concentration (PNC) with a wide, size-resolved particle-size range, and CO (an indicator of combustion sources, e.g., traffic), was performed in a variety of microenvironments. Concentrations of ultrafine particles (UFPs), size-fractionated particulate matter (PM), and carbon monoxide (CO) were measured in the central area of Milan over three-week-long periods, one each during summer, autumn, and winter, with three monitoring sessions per day. Experimental data were collected continuously during each monitoring period along an established urban pathway. To assess the relevance of time and spatial factors affecting atmospheric concentrations of UFPs, PM, and CO data were collected while walking or moving by different private and public means of transport. Measurements were divided on the basis of different microenvironments (MEs), seasons, days of the week, and periods of the day. Data analysis shows statistically significant differences across MEs and monitoring periods. The highest measured median concentrations and data variability were observed for busy streets, walking or moving by motorized vehicle (CO, UFP) and in metro trains (PM); the lowest concentrations were observed in park areas and in indoor environments. The highest concentrations were measured during working day morning monitoring sessions. Regarding seasonal variation, UFP, PM, and CO showed different patterns: the highest median concentrations were observed in summer for CO, and in autumn and winter for the UFP and PM. Appreciable differences among all MEs and monitoring periods were observed: concentration patterns and variations appear related to typical sources of urban pollutants (traffic), proximity to sources, and time of day. [Supplementary materials are available for this article. Go to the publisher's online edition of Journal of Occupational and Environmental Hygiene for the following free supplemental resource: a file containing Table VI: Tau b (Kendall) index for non-parametric correlation tau test.].

Unlabelled: The province of Lodi is located in northern Italy on the Po River plain, where high background levels of air pollutants are prevalent. Lodi province is characterized by intensive agriculture, notably animal husbandry. This paper assesses indoor levels of selected airborne pollutants in 60 homes in the province, with special attention to size-fractionated particulate matter (PM). Indoor PM₂.₅ concentrations are frequently higher than current guidelines. PM₁₀ and nitrogen dioxide also exceed the respective guideline recommendations in some cases, noting that 24-h nitrogen dioxide levels were compared with an annual limit value. All other studied pollutant levels are below current international guidelines. Among indoor PM size fractions, PM₀.₅ is predominant in terms of mass concentrations corresponding to 57% of PM₁₀ in summer and 71% in winter. A strong seasonal trend is observed for all studied pollutants, with higher levels in winter corresponding to changes in ambient concentrations. The seasonal variation in PM₁₀ is largely due to PM₀.₅ increase from summer to winter. Summer indoor PM levels are mainly from indoor-generated particles, while particles of outdoor origin represent the main contribution to winter indoor PM levels. On average, indoor concentrations of coarse PM are mostly constituted by indoor-generated particles., Practical Implications: This study presents a comparison between measured indoor concentrations in the study area and indoor air quality guideline criteria. Accordingly, particulate matter (PM) and NO₂ are identified as key pollutants that may pose health concerns. It is also found that indoor PM in residential units is mainly constituted by particles with aerodynamic diameters <0.5 μm, especially in winter. Risk mitigation strategies should be focused on the reduction in indoor levels of NO₂ and ultrafine and fine particles, both infiltrated from outdoors and generated by indoor sources., (© 2011 John Wiley & Sons A/S.)

Background: Latex is a relevant occupational and environmental allergen, strongly related to the extensive use of natural rubber products., Objectives: Threshold Limit Values have to be identified, as well as biocompatible materials in order to avoid sensitization or appearance of allergic symptoms., Methods: In this paper we consider the main methods, which have been used to detecting latex allergens for environmental monitoring of airborne and latex products., Results: We report our experience in such afield, and our approach to the latex problem, suggesting that quantification of allergens, which is currently applicable according to well standardized methods, should be adopted by manufacturers, agency and consumer organization.

The present study was aimed at assessing the carcinogenic risk of occupational exposure to PM10 in electric steel plants. PM10 was collected on cellulose filter respectively outside (site 1) and inside (site 2) the furnace area, was measured, extracted and its metal content was analysed by ICP-MS. Cells were exposed for 30 min, 2 and 4 hours to extract of filter from each site diluted at 0.004, 0.008 and 0.02%. The direct/oxidative DNA damage caused by PM10 was evaluated on A549 cells by Fpg-modified comet assay, analysing Tail moment (TM) and comet percentage. Air samples contained 1.08 mg/m3 of PM10 in site 1 and 5.54 mg/m3in site 2 and different amounts of metals with higher levels of Zn, Al, Ni, Pb, Cd, Cr, Ba in site 2 and of Fe, Mn, Sb in site 1. In cells exposed for 2h to PM10 from both sites, an oxidative DNA damage was found concentrations of 0.008% and 0.02%. For site 2, a direct DNA damage at 0.02% was also found. After 4h a direct/oxidative DNA damage was detected at 0.02% for site 2 and an oxidative DNA damage for site 1. The results indicate a moderate DNA damage induction by used diluitions of PM10 extracts with higher extent for more polluted site 2. These findings show the suitability of this experimental model to evaluate early DNA damage induced by complex mixtures containing metals on target organ, suggesting its use to study biological effects of occupational exposure to such substances.

Occupational exposure of coke oven workers, classified by IARC as human carcinogen, is characterized by the presence of PAHs emitted during pyrolysis of coal. We aimed to clarify the mechanism of action of complex mixtures of PAHs and to identify biomarkers of early biological effect, evaluating on lung epithelial cells (A549) genotoxic and oxidative damage of airborne particulate matter collected in a coke plant. Particulate matter was collected in the oven area on glass filter, extract and analysed by GC/MS. Direct/oxidative DNA damage induced by exposure to extract were evaluated by Fpg comet assay. The cells were exposed for 30 min, 2h and 4h to extract of half filter diluted at 0.004%, 0.008% and 0.02%. We evaluated comet percentage and analysed tail moment values of cells treated with Fpg enzyme (TMenz) and untreated (TM) that indicate respectively oxidative and direct DNA damage. Air sample contained 0.328 microg/m3 of pyrene, 0.33 microg/m3 of benzo(a)anthracene, 1.073 microg/m3 of benzo(b)fluoranthene, 0.22 microg/m3 of benzo(k)fluoranthene, 0.35 microg/m3 of benzo(a)pyrene, 0.079 microg/m3 of dibenzo(a,h)anthracene and 0.40 microg/m3 of benzo(g,h,i)perylene. The dose-dependent increase of TM and TMenz in exposed cells was not significant, indicating only a slight direct and oxidative DNA damage in exposed cells. A small dose-time dependent increase of comet percentage was found. The study shows the high sensitivity of comet assay to measure early DNA damage also at low doses suggesting its use on lung epithelial cells to evaluate the effects of complex mixtures of genotoxic substances on target organ.