Search

Abstract: Light envelopes are more and more frequently used in modern buildings but they do not present sufficient thermal inertia. A solution to increase this inertia is to incorporate a phase change material (PCM) in this envelope. This paper presents the performance of a test-cell with a new structure of light wallboards containing PCMs submitted to climatic variation and a comparison is made with a test-cell without PCMs. To improve the wallboard efficiency a vacuum insulation panel (VIP) was associated to the PCM panel. This new structure allows the apparent heat capacity of the building to be increased, the solar energy transmitted by windows to be stored without raising the indoor cell temperature, and the thickness of the wallboard to be decreased compared with that of traditional wallboards. An experimental study was carried out by measuring temperature and heat fluxes on and through the wallboards. The indoor temperature, which has a special importance for occupants, was also measured. A numerical simulation with the TRNSYS software was carried out in adding a new module representing the new wallboard. It showed a good agreement with experimental results. This new tool will allow users to simulate the thermal behaviour of buildings having walls with PCMs. [Copyright &y& Elsevier]

Abstract: In the objective to define passive components for the light envelope of buildings, different types of wallboards containing a phase change material (PCM) were studied. The high storage capacity should enable the overall thickness of wallboards to be less than 5cm. To lower the investment costs, the wallboards were made from commercial panels after a first attempt of using gypsum walls. Three types of wallboards were studied: (i) a polycarbonate panel filled with paraffin granulates; (ii) a polycarbonate panel filled with polyethylene glycol PEG 600; (iii) a PVC panel filled with PEG 600 and coupled to a VIP. An experimental set-up was built to determine the thermal response of these wallboards to thermal solicitations. Experimental results were compared to those obtained by a numerical simulation in which an apparent heat capacity method was used. The final results show that the last studied wallboard could be used in the test cells under construction and then validate the concept. [Copyright &y& Elsevier]

Abstract: The present paper deals with the thermal study of honeycomb panels for short-term heat storage. Using honeycomb panels filled with Phase Change Materials (PCMs) allowed us to fulfil two criteria: enhancement of thermal conductivity and containment to avoid possible leaks. Paraffin whose thermal properties have been measured has been chosen as PCM. The response of the PCM panel to temperature variations was studied with a specific test bench. Temperature and flux measurements clearly showed a significant thermal inertia increase compared to samples filled with air and water. Modelling and numerical simulation have been carried out and validated with the experimental results. [ABSTRACT FROM AUTHOR]