Search

Fingerprint evidence offers great value to criminal investigations since it is an internationally recognized and established means of human identification. With recent advances in modern technology, scientists have started analyzing not only the ridge patterns of fingerprints but also substances which can be found within them. The aim of this work was to determine whether Fourier transform infrared (FTIR) spectromicroscopy could be used to detect contamination in a fingerprint which was dusted with powder (a technique already recognized as an effective and reliable method for developing latent fingerprints) and subsequently lifted off with adhesive tape. Explosive materials (pentaerythritol tetranitrate, C-4, TNT) and noncontrolled substances (sugar, aspirin) were used to prepare contaminated fingerprints on various substrates. Freshly deposited fingermarks with powders which were lifted off with adhesive tapes (provided by Singapore Police Force) were analyzed using a Bruker Hyperion 2000 microscope at the ISMI beamline (Singapore Synchrotron Light Source) with an attenuated total reflection objective. FTIR spectroscopy is a nondestructive technique which requires almost no sample preparation. Further, the fingerprint under analysis remains in pristine condition, allowing subsequent analysis if necessary. All analyzed substances were successfully distinguished using their FTIR spectra in powdered and lifted fingerprints. This method has the potential to significantly impact forensic science by greatly enhancing the information that can be obtained from the study of fingerprints. [ABSTRACT FROM AUTHOR]

Fourier transform-infrared (FF-LR) spectmscopy has gained considerable attention among the forensic scientists because it shows high sensitivity and selectivity and offers near real time detection of analyzed samples. However, the amount of obtained information due to complexity of the measured spectra forces the use of additional data processing. Application of the multivariate statistical techniques for the analysis of the FT-IR data seems to be necessaly in order to enable feature extraction, proper evaluation, and identification of obtained spectra. In this article, an attempt to develop a feasible procedure for characterization of spectroscopic signatures of the explosive materials in the remnants after explosion has been made. All spectra were derived after analysis of samples from debris after especially prepared and performed blasts with the use of three various highly explosive materials: C-4, 2,4,6-trinitrotoluene (TNT), and pentaerythritol tetranitrate (PETN). Two well-known multivariate statistical methods, hierarchical cluster analysis (HCA) and principal component analysis (PCA), were tested in order to classilS' the samples into separate classes using a broad wavelength data range (4000-600 cm-1 on collected spectra sets. After many trials it seems that PCA is the best choice for the mentioned earlier tasks. It was found that only three principal components carry over 99.6% of variance within the sample set. The results show that FT-lR spectroscopy in combination with multivariate methods is well-suited for identification and differentiation purposes even in quite large data sets, and for that reason forensic laboratories could employ these methods for rapid screening analysis. [ABSTRACT FROM AUTHOR]