Search

Five‐phase permanent magnet synchronous machine (PMSM) can operate under open‐circuit faults with the appropriate current regulations. However, the traditional current regulations based on the five‐phase half‐bridge inverter have to satisfy the constraint of zero neutral point current, which limits the fault‐tolerant performance of the machine. Thus, this paper investigates the current regulation based on the five‐phase six‐leg (FPSL) inverter, which relieves the zero‐neutral point current limitation, and both current regulations considering the maximum torque (MT) and minimum copper loss (MC) are derived under different open‐circuit conditions. The cost of the system has increased, but with the new regulations, better fault‐tolerant operation capability of the machine can be obtained under all kinds of open‐circuit faults. Moreover, with the introduction of the neutral point current, the machine can work under triple‐phase open‐circuit faults. In conclusion, the proposed control scheme based on the FPSL inverter expands the fault‐tolerant operation capability of the five‐phase PMSM. The experiment results prove the effectiveness of the proposed current regulation on increasing average torque or reducing copper loss under fault‐tolerant operation. [ABSTRACT FROM AUTHOR]

The new topology of the dual-armature flux-switching permanent magnet machine (DA-FSPM) leads to new characteristics and issues in the control of the machine, of which the mutual inductance of the two sets of armature windings is the most important one. This paper proposes a novel position–sensorless control method based on high-frequency injection (HFI) for DA-FSPM. The high-frequency model of the machine is derived, and the theory of the position estimation method is proposed. Different from the conventional HFI-based position estimation method, the proposed method utilizes the mutual inductance of the DA-FSPM rather than the machine saliency. Meanwhile, because the extracted position information based on the mutual inductance is more obvious, the proposed method also has better steady and dynamic performance. Then, the position observer based on the phase lock loop and the initial position detection method for the DA-FSPM is proposed. The experiments are executed on a DA-FSPM prototype with three-phase stator windings and five-phase rotor windings to prove the effectiveness and superiority of the proposed method. [ABSTRACT FROM AUTHOR]

This paper proposes a torque distributed control strategy for the multiphase machines in the hybrid energy storage system application. Different with the conventional energy current regulation method, the system energy management is researched by the machine torque distribution in different sets of windings. The load power is then afforded by the energy storage devices connected with the windings through the inverters. The principle of the distributed torque operation is explored with a dual three-phase permanent-magnet synchronous machine model and the asymmetrical windings operation is explained with the flux vector diagram. The windings decoupling compensation, flux observer, and parameter identification methods are presented. Based on the proposed strategy, a power frequency dividing coordinated regulation is achieved. The hybrid energy storage devices can directly respond to the average or instantaneous parts in the load torque and power fluctuation. Simulation and experiments are demonstrated with different operation cases. [ABSTRACT FROM AUTHOR]

To improve the performance and integration of the power train of electric vehicles power, a dual three-phase permanent magnet synchronous machine (PMSM) drive is investigated to achieve hybrid energy storage system power management. Two sets of motor windings are connected with ultracapacitors and a battery, respectively, through the inverters. First, the operation modes of the integrated system are studied by modeling and vector diagram analysis. A new control scheme is then established to enhance the regulation for unbalanced winding power distribution. The approach to suppress the motor harmonics current under the unbalanced power operation is also discussed. Finally, a frequency dividing coordinated control is performed for good dynamic response and seamless transient process. Both simulation and experiment results verify the effectiveness of the proposed system and the control strategy. [ABSTRACT FROM PUBLISHER]