Search

The mesomorphic isotactic polypropylene was prepared by rapid compression instead of the common method of temperature quenching, and their phase transition under high pressure was investigated in depth by combining wide‐angle X‐ray diffraction, small‐angle X‐ray scattering, and differential scanning calorimetry techniques. It was found that annealing under pressure can promote the further arrangement of chain segments of the mesophase toward the crossed state in the orthorhombic γ‐phase, and the long period of the mesophase slightly decreased from 8.2 to 7.2 nm. The kinetics of this meso‐γ transition strongly depends on pressure. As annealing pressure increased, the mobility of molecular segments was reduced, and then the onset and finishing time of phase transition were both delayed significantly. A critical annealing pressure was found between 1.6 and 1.75 GPa, which determines whether the phase transition occurs or not. When pressure reaches 1.75 GPa, mesophase did not transform at all within 120 min. Based on the results, a reasonable mechanism was proposed to show the crystallization process of mesophase under high‐pressure annealing. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 651–661 [ABSTRACT FROM AUTHOR]

Isotactic polypropylene filled with 1 wt.% multi-walled carbon nanotubes (iPP/MWCNTs) were prepared, and their crystallization behavior induced by pressurizing to 2.0 GPa with adjustable rates from 2.5 to 1.3 × 104 MPa/s was studied. The obtained samples were characterized by combining wide angle X-ray diffraction, small angle X-ray scattering, differential scanning calorimetry, transmission electron microscopy and atomic force microscopy techniques. It was found that pressurization is a simple way to prepare iPP/MWCNTs composites in mesophase, γ-phase, or their blends. Two threshold pressurization rates marked as R1 and R2 were identified, while R1 corresponds to the onset of mesomorphic iPP formation. When the pressurization rate is lower than R1 only γ-phase generates, with its increasing mesophase begins to generate and coexist with γ-phase, and if it exceeds R2 only mesophase can generate. When iPP/MWCNTs crystallized in γ-phase, compared with the neat iPP, the existence of MWCNTs can promote the nucleation of γ-phase, leading to the formation of γ-crystal with thicker lamellae. If iPP/MWCNTs solidified in mesophase, MWCNTs can decrease the growth rate of the nodular structure, leading to the formation of mesophase with smaller nodular domains (about 9.4 nm). Mechanical tests reveal that, γ-iPP/MWCNTs composites prepared by slow pressurization display high Young's modulus, high yield strength and high elongation at break, and meso-iPP/MWCNTs samples have excellent deformability because of the existence of nodular morphology. In this sense, the pressurization method is proved to be an efficient approach to regulate the crystalline structure and the properties of iPP/MWCNTs composites. [ABSTRACT FROM AUTHOR]