Search

The Hermans orientation factor is a scalar giving a simple assessment of molecular or crystal orientation in a polymer. It is usually determined from X‐ray diffraction measurements. The evaluation of the Hermans orientation factor is proposed from the diffraction analysis of only a single diffracting plane. The estimation relies on (a) the assumption that the polymer crystals possess a cylindrical symmetry with respect to the chain direction and (b) that the processing conditions induce a transverse isotropy of the polymer chains. A practical consequence of the proposed analysis is that the Hermans orientation factor can be computed from a single 1D diffractogram. This enables fast evaluations since even low signal‐to‐noise ratio signals can be processed with optimal noise reduction. An illustration of this method for uniaxially compacted polytetrafluoroethylene (PTFE) powder is presented. The crystalline orientation is followed during in situ crystallization experiments with a fine time resolution. [ABSTRACT FROM AUTHOR]

The influence of the cooling rate after melting on the crystalline weight fraction of pure poly(tetrafluoroethylene) (PTFE) was derived from differential scanning calorimetry tests. Specimens made of pure or filled PTFE were manufactured by isostatic or constrained uniaxial cold pressing, up to different values of the porosity. Dilatometry tests were carried out on these specimens while imposing various heating-cooling treatments. The deformations recorded during these tests strongly depend on the mode and level of compaction. The original procedures presented, herein, made it possible to identify that these macroscopic deformations, which are strongly anisotropic for uniaxially pressed specimens, result from the combination of different independent mechanisms. The mechanisms that were distinguished are reversible thermal expansion, void closure, crystalline to amorphous and vice versa transformations, and recovery, which were not observed for isostatically pressed specimens. It was also shown that, after being subjected to a standard sintering treatment, anisotropically pressed specimens still exhibit anisotropic crystallization strains. POLYM. ENG. SCI., 2011. © 2011 Society of Plastics Engineers [ABSTRACT FROM AUTHOR]

The manufacturing of polytetrafluoroethylene products is usually carried out by cold isostatic and/or uniaxial pressing of the powdered polymer, followed by sintering of the “green” parts. During pressing, the air initially present in the loose powder leads to the formation of defects in the material, but the mechanisms involved are not entirely understood. The aim of this study was to better understand the role played by the entrapped air during the cold pressing of polytetrafluoroethylene powder. Observation of the microstructure and determination of some mechanical properties of green and sintered samples, manufactured with different quantities of entrapped air by the cold isostatic pressing process, were carried out. The analysis indicated that defects are formed when the entrapped air pressure in the pressed part leads to internal stresses exceeding the intergranular cohesion resistance of the green part. These defects remain in the microstructure even after sintering, considerably reducing the mechanical strength. [ABSTRACT FROM AUTHOR]