Search

In this work, Si@NC/AP and Si@PVDF/CL-20 composites with different Si contents have been fabricated by spray-drying technique. The flame structure, ignition delay time and combustion process have been investigated. It has been shown that the ignition delay of Si-based fuel with 40 wt% of Si is the shortest. This means that oxygen balance and the catalytic effect of Si on the energetic composites are playing a dominant role during the combustion processes of these composites. The solid composite propellants (SCP, named as SCP-1 and SCP-2) contains two typical Si-based composites Si-80@NC/AP and Si-80@PVDF/CL-20 have been prepared for propellant applications. Their propellants containing the corresponding mechanical mixtures (named as SCP-3 and SCP-4) have been fabricated as a comparison. It has been observed that the cross sections of propellants containing Si-based composites are denser than that of the reference propellants. The burn rate of SCP-1 (with Si-80@NC/AP) and SCP-2 (with Si-80@PVDF/CL-20) are 5.74 and 5.10 mm s−1 at 2.0 MPa, respectively, which are lower than those of the reference samples SCP-3 (6.51 mm s−1) and SCP-4 (5.70 mm s−1). However, the pressure exponent of former is slightly lower than that of the latter. Moreover, the combustion products (CCPs) of SCP-1 and SCP-3 are more fluffy and smaller in particles size than those of SCP-2 and SCP-4. This indicates that the core-shell structured composites have much better combustion performances due to better heat and mass transfer between the oxidizers and Si as fuel. [ABSTRACT FROM AUTHOR]

Owing to the novel insensitive high-energy-density material 2,4,6-triamino-5-nitropyrimidine-1,3-dioxide (ICM-102) has lower sensitivity and higher energy(see in Table S1, Supporting Information), it has great advantages in the application of low-vulnerability propellants. In this paper, the evaluation of ICM-102-containing composite propellants has been carried out, where the decomposition and combustion performances of these propellants have been comprehensively investigated. It has been shown that the main exothermic decomposition peak temperature can be increased from 235 ºC to 350 ºC, when 6 to 10 wt% of ICM-102 was used to replace RDX, but heat release rate was largely increased. Moreover, the burning rate of ICM-102 containing propellants at 3 MPa is in the range of 6.97–7.75 mm• s − 1, depending on its content. The pressure exponent (0.5–3 MPa) is between 0.34–0.44. Compared with the typical propellants with RDX, the burn rate and the flame temperature of ICM-102- containing propellants are higher. In addition, the particle size distributions of condensed combustion products of ICM-102 propellants are narrower and smaller than that of RDX-based one. It also shows that extra products such as aluminum carbide (Al20C) and aluminum oxide nitride (Al5O6N) were produced once ICM-102 was used. [ABSTRACT FROM AUTHOR]