Search

This article identifies and validates the use of ultrafast silicon carbide (SiC) junction field effect transistor (JFET)-based self-powered solid-state circuit breakers (SSCBs) as the enabling protective device for a 340 Vdc residential dc community microgrid. These SSCBs will be incorporated into a radial distribution system in order to enhance fault discrimination through autonomous operation. Because of the nature and characteristics of short-circuit fault inception in dc microgrids, the time–current trip characteristics of protective devices must be several orders of magnitude faster than conventional circuit breakers. The proposed SSCBs detect short-circuit faults by sensing the sudden voltage rise between its two power terminals and draw power from the fault condition itself to turn off SiC JFETs and then, coordinate with no-load contacts that can isolate the fault. Depending upon the location of the SSCBs in the microgrid, either unidirectional or bidirectional implementations are incorporated. Cascaded SSCBs are tuned using a simple resistor change to enable fault discrimination between upstream high-current feeds and downstream lower current branches. Operation of one of the SSCBs and three in cascaded arrangements are validated both in simulation and with a hardware test platform. Thermal impact on the SSCB is discussed as well. The target application is a residential dc microgrid that will be installed as part of a revitalization effort of an inner city Milwaukee neighborhood. [ABSTRACT FROM AUTHOR]

This paper identifies the characteristics of a current source inverter operating in discontinuous conduction mode, and proposes a new multiobjective pulse-width modulation (PWM) method to mitigate voltage boosting and harmonic distortion effects. The method takes into account load impedance effects. Controls are also developed to enable transition between the multiobjective PWM method and conventional PWM as the current source inverter operates in discontinuous and continuous modes of operation. The concept is verified experimentally on a 3 kW test bed. [ABSTRACT FROM AUTHOR]

Although the operation of a three-phase current source rectifier (CSR) for ac-to-dc conversion using phase control or low-frequency pulse control is well established in a wide variety of applications, CSR realization using high-frequency pulsewidth-modulation control has been recently studied as a potentially competitive alternative to a voltage source rectifier. In the CSR, reverse blocking gate turn-off switches are realized using series-connected diodes, which prevent any reversal of the dc-link current. A significant consequence of this limitation occurs at light load conditions. The dc-link inductor current enters the discontinuous mode of operation and leads to the loss of the control of the output voltage and a highly distorted input current, which compromise the potential advantages of the approach. This paper characterizes the CSR while operating in the discontinuous conduction mode and proposes a modulation strategy that restores the control of the output voltage and ensures a nearly sinusoidal current at light loads. Simulation and hardware results are provided for a 3-kW laboratory-scale prototype system. [ABSTRACT FROM AUTHOR]