Search

Carrier escape and recombination from quantum dot (QD) states reduce the probability of two-step photon absorption (TSPA) by decreasing the available carrier population in the intermediate band (IB). In order to optimize the second photon absorption for future designs of quantum dot embedded intermediate band solar cells, the presented study combined the results of simulations and experiments to quantify the effect of electric field on the barrier height and the carrier escape from the QDs in InAs/GaAs quantum dot solar cells with five-layer QD superlattices. The electric field dependent effective barrier heights for ground state electrons were calculated using eight band k.p theory at short circuit conditions. With an increase in electric field surrounding the QDs from 5 kV/cm to 50 kV/cm, the effective barrier height of the ground state electrons was reduced from 147 meV to 136 meV, respectively. Thus, the increasing electric field not only exponentially enhances the ground state electron tunneling rate (effectively zero at 5 kV/cm and 7.9 × 106 s-1 at 50 kV/cm) but also doubles the thermal escape rate (2.2 × 1011 s-1 at 5 kV/cm and 4.1 × 1011 s-1 at 50 kV/cm). Temperature-dependent external quantum efficiency measurements were performed to verify that the increasing electric field decreases the effective barrier height. Additionally, the electric field dependent radiative lifetimes of the ground state were characterized with time-resolved photoluminescence experiments. This study showed that the increasing electric field extended the radiative recombination lifetime in the ground state of the QDs as a consequence of the reduced wave-function overlap between the electrons and holes. The balance of carrier escape and recombination determines the probability of TSPA. [ABSTRACT FROM AUTHOR]

Intermediate band solar cells promise improved efficiencies beyond the Shockley-Queisser limit by utilizing an intermediate band formed within the bandgap of a single junction solar cell. InP quantum dots (QDs) in an In0.49Ga0.51P host are a promising material system for this application, but two-step photon absorption has not yet been demonstrated. InP QDs were grown via metalorganic chemical vapor deposition, and a density, a diameter, and a height of 0.7 × 1010 cm−2, 56 ± 10 nm, and 18 ± 2.8 nm, respectively, were achieved. Time-resolved photoluminescence measurements show a long carrier lifetime of 240 ns, indicating a type-II band alignment of these InP quantum dots. Several n-i-p In0.49Ga0.51P solar cells were grown with both 3 and 5 layers of InP QDs in the i-region. While the solar cells showed an overall loss in short circuit current compared to reference cells due to emitter degradation, a sub-bandgap enhancement of 0.11 mA/cm2 was clearly observed, due to absorption and collection from the InP QDs. Finally, two-step photon absorption experiments have shown unambiguous photocurrent generation involving an intermediate band within the bandgap at temperatures up to 250 K. [ABSTRACT FROM AUTHOR]

InAs quantum dots (QDs) were grown in an AlAs0.56Sb0.44/GaAs matrix in the unintentionally doped (uid) region of an In0.52Al0.48As solar cell, establishing a variety of optical transitions both into and out of the QDs. The ultimate goal is to demonstrate sequential absorption, where one photon is absorbed, promoting an electron from the valence band into the QD, and a second photon is absorbed in order to promote the trapped electron from a QD state into the host conduction band. In this study, we directly investigate the optical properties of the solar cell using photoreflectance and evaluate the possibility of sequential absorption by measuring spectral responsivity with broadband infrared illumination. [ABSTRACT FROM AUTHOR]

ABSTRACT InAs quantum dots (QDs) have been incorporated to bandgap engineer the (In)GaAs junction of (In)GaAs/Ge double-junction solar cells and InGaP/(In)GaAs/Ge triple-junction solar cells on 4-in. wafers. One sun AM0 current-voltage measurement shows consistent performance across the wafer. Quantum efficiency analysis shows similar aforementioned bandgap performance of baseline and QD solar cells, whereas integrated sub-band gap current of 10 InAs QD layers shows a gain of 0.20 mA/cm2. Comparing QD double-junction solar cells and QD triple-junction solar cells to baseline structures shows that the (In)GaAs junction has a Voc loss of 50 mV and the InGaP 70 mV. Transmission electron microscopy imaging does not reveal defective material and shows a buried QD density of 1011 cm−2, which is consistent with the density of QDs measured on the surface of a test structure. Although slightly lower in efficiency, the QD solar cells have uniform performance across 4-in. wafers. Copyright © 2013 John Wiley & Sons, Ltd. [ABSTRACT FROM AUTHOR]

The effect of the position of InAs quantum dots (QD) within the intrinsic region of pin-GaAs solar cells is reported. Simulations suggest placing the QDs in regions of reduced recombination enables a recovery of open-circuit voltage (VOC). Devices with the QDs placed in the center and near the doped regions of a pin-GaAs solar cell were experimentally investigated.While the VOC of the emitter-shifted device was degraded, the center and base-shifted devices exhibited VOC comparable to the baseline structure. This asymmetry is attributed to background doping which modifies the recombination profile and must be considered when optimizing QD placement. [ABSTRACT FROM AUTHOR]

Nanostructured quantum well and quantum dot III–V solar cells provide a pathway to implement advanced single-junction photovoltaic device designs that can capture energy typically lost in traditional solar cells. To realize such high-efficiency single-junction devices, nanostructured device designs must be developed that maximize the open circuit voltage by minimizing both non-radiative and radiative components of the diode dark current. In this work, a study of the impact of barrier thickness in strained multiple quantum well solar cell structures suggests that apparent radiative efficiency is suppressed, and the collection efficiency is enhanced, at a quantum well barrier thickness of 4 nm or less. The observed changes in measured infrared external quantum efficiency and relative luminescence intensity in these thin barrier structures is attributed to increased wavefunction coupling and enhanced carrier transport across the quantum well region typically associated with the formation of a superlattice under a built-in field. In describing these effects, a high efficiency (>26% AM1.5) single-junction quantum well solar cell is demonstrated in a device structure employing both a strained superlattice and a heterojunction emitter. [ABSTRACT FROM AUTHOR]