Search

Spectral polarization filtering technology is widely used in weather radar clutter suppression, but when ground clutter is mixed with precipitation, these methods will lose precipitation while filtering out clutter. To address this issue, a polarization-Doppler weather radar signal reconstruction method based on spectral continuity is proposed. This method utilizes the characteristic differences between precipitation and clutter on the range-Doppler map to achieve the preservation of precipitation and the filtering of clutter. Specifically, the spatial continuity of Doppler velocity and spectral width of precipitation is utilized to compensate for precipitation using polynomial fitting and Gaussian fitting method. The effectiveness of the proposed method is verified by the measured data of the operational weather radar. [ABSTRACT FROM AUTHOR]

Radio frequency interference (RFI) has become a growing concern for weather radar, distorting radar variable estimation. By simultaneously or alternately transmitting the horizontal and vertical polarized waves, polarimetric weather radar can be referred to as SHV radar or AHV radar. The SHV radar can mimic the AHV radar by discarding either H- or V-channel measurements, which leads to an alternating scheme. In this research, the real RFI measurements from an operational C-band SHV radar are used to characterize the RFI temporal, spectral, and polarimetric features. Then, the RFI is simulated to quantify the performance of the object-orientated spectral polarimetric (OBSPol) filter in RFI mitigation. The OBSPol filter has been previously proposed by the authors to mitigate the narrowband clutter (both stationary and moving) and noise. This work extends the application of the filter to remove the RFI for SHV radar. Specifically, by taking advantage of the low copolar correlation of the RFI signal measured in AHV radar, the RFI mitigation method is designed, and its effectiveness is proven by qualitative and quantitative analyses. In particular, in the case of RFI overlapped to weather echoes in the time domain, the RFI can be mitigated, also when the duty cycle of the RFI is high. However, this work does not provide a full evaluation of the RFI mitigation performance on all radar data outputs but a proof of concept to show the effectiveness of the proposed filter for RFI mitigation. [ABSTRACT FROM AUTHOR]

Weather radar is well recognized as an effective sensor for obtaining the microphysical and dynamical properties of precipitation at high spatial and temporal resolution. Radar calibration is one of the most important prerequisites for achieving accurate observations. In this article, a portable, cost-effective and repeatable radar calibration technique, namely, unmanned aerial vehicle (UAV)-aided radar calibration, is proposed. A UAV serves as the stable aerial platform carrying a metal sphere, flying over the radar illumination areas to complete the calibration process. The flying routine of the UAV can be pre-programmed, and thus, the antenna pattern regarding different elevation and azimuth angles can be retrieved. To obtain the position of the sphere, the real-time single-frequency precise point positioning-type global navigation satellite system solution is developed. In addition, the radar constant is calculated in the range-Doppler domain, and only the data where the metal sphere separates from clutter and other objects are selected. The S-band polarimetric Doppler transportable atmospheric radar (TARA) is used in the calibration campaign. The experiments demonstrate the following results: 1) antenna pointing calibration can be completed and 2) antenna pattern can be retrieved and weather radar constant can be accurately calculated. [ABSTRACT FROM AUTHOR]

Aiming at removing stationary and moving clutter while retaining precipitation for dual-polarization weather radar, a new clutter suppression method, named the object-orientated spectral polarimetric (OBSpol) filter, is put forward in this paper. Based on the spectral polarimetric feature and the range-Doppler continuity of precipitation, the OBSpol filter generates a filtering mask implemented on the raw range-Doppler spectrogram to mitigate the clutter and noise. The procedures are as follows. After the spectral polarimetric filtering and the mathematical morphology method, one binary mask where “1” indicates the precipitation is obtained. Then, the contiguous bins of the same value “1” in the range-Doppler domain are grouped in areas termed as objects. Whether the produced objects are precipitation or not will be further judged based on appropriate weather radar observable. Thus, combining all the filtered separate objects, a filtering mask can be obtained. In this paper, data collected by the polarimetric Doppler IRCTR drizzle radar are used to demonstrate and assess the performance of the proposed technique in the case of ground clutter, narrowband moving clutter, and noise. Two precipitation cases are examined: 1) moderate precipitation with large scale and 2) light precipitation with severe clutter contamination. In the range-Doppler spectrogram, both stationary and narrowband moving clutters are mitigated, while maintaining nonoverlapping precipitation signal. This helps to solve the problem when clutter and precipitation overlap in the time domain. In addition, the OBSpol filter is proven to be effective with different Doppler velocity resolutions. This technique can be applied in real-time due to its low computation complexity. Moreover, the spectral polarimetric filtering can be designed using the measurements of dual-polarization radar systems which do not have cross-polar measurements. Hence, the proposed clutter mitigation technique can be implemented for operational dual-polarization weather radar. [ABSTRACT FROM AUTHOR]

In this paper, a new clutter suppression method, named the moving double spectral linear depolarization ratio (MDsLDR) filter, is put forward to mitigate narrow-band clutter in weather radars. The narrow-band clutter observed in the Doppler domain includes: 1) stationary clutter such as ground clutter and 2) nonstationary clutter such as artifacts caused by the radar system itself or external sources. These artifacts are difficult to remove, because they are not confined to specific azimuth and range bins. Based on the difference of the spectral-polarization feature and the spectral continuity of precipitation and clutter, the MDsLDR filter can remove ground clutter, artifacts, and noise. The performance of the newly proposed filter is assessed by data collected by the Doppler-polarimetric IRCTR Drizzle Radar. Three precipitation cases are considered in this paper: moderate/light precipitation, convective precipitation with hook-echo signature, and light precipitation with severe artifact contamination. Furthermore, the implementation of the MDsDLR filter requires relatively low computation complexity, so that the MDsLDR filter can be operated in real time. [ABSTRACT FROM PUBLISHER]