Search

Intermodulation products arise as a result of low noise amplifier (LNA) and mixer non-linearities in wideband receivers. In the presence of strong blockers, the intermodulation distortion can deteriorate the spectrum sensing performance by causing false alarms and degrading the detection probability. We theoretically analyze the impact of third-order non-linearities on the detection and false alarm probabilities for both energy detectors and cyclostationary detectors under front-end LNA non-linearities. We show that degradation of the detection performance due to nonlinearities of both energy and cyclostationary detection is strongly dependent on the modulation type of the blockers. We then propose two DSP-enhanced receiver architectures to compensate the impact of nonlinearities. The first approach is a post-processing technique which compensates for nonlinearities effect on the test statistic by adapting the sensing time and detection threshold. The second approach is a pre-processing method that compensates by correcting received samples prior to computing the test statistic. This approach is based on adaptively estimating the intermodulation distortion, weighting it by a scalar constant and subtracting it from the subband of interest. We propose a method to adaptively compute the optimal weighting coefficient and show that it depends on the power and modulation of the blockers. Our results show that the pre-processing sample-based compensation method is more effective and that clear dynamic range extension can be obtained by using intermodulation compensation without resorting to increasing the sensing time. We also study the impact of uncertainties about the knowledge or estimates for nonlinearity parameters. [ABSTRACT FROM PUBLISHER]

In this paper, a novel decorrelation-based concurrent digital predistortion (DPD) solution is proposed for dual-band transmitters (TXs) employing a single wideband power amplifier (PA), and utilizing only a single feedback receiver path. The proposed decorrelation-based parameter learning solution is both flexible and simple, and operates in a closed-loop manner, opposed to the widely applied indirect learning architecture. The proposed decorrelation-based learning and DPD processing can also be effectively applied to more ordinary single carrier/band transmissions, as well as generalized to more than two transmit bands. Through a comprehensive analysis covering both the DPD parameter learning and the main path processing, it is shown that the complexity of the proposed concurrent DPD is substantially lower compared with the other state-of-the-art concurrent DPD methods. Extensive set of simulation and RF measurement results are also presented, using base-station PAs as well as a commercial LTE-Advanced mobile PA, to evaluate and validate the effectiveness of the proposed DPD solution in various real world scenarios, incorporating both single-band and dual-band TX cases. The simulation and RF measurement results demonstrate excellent linearization performance of the proposed concurrent DPD, even outperforming current state-of-the-art methods, despite the significantly lower complexity. [ABSTRACT FROM AUTHOR]

Inband FD operation has great potential in civilian/commercial wireless communications, because it can as much as double transmission links? spectral efficiency by exploiting the newfound capability for STAR that is facilitated by advanced SIC techniques. This article surveys the prospects of exploiting the emerging FD radio technology in military communication applications as well. In addition to enabling high-rate twoway tactical communications, the STAR capability could give a major technical advantage to armed forces by allowing their radio transceivers to conduct electronic warfare at the same time that they are also receiving or transmitting other signals at the same frequency bands. After comprehensively introducing FD transceiver architectures and SIC requirements in military communications, this article outlines and analyzes all the most promising defensive and offensive applications of the STAR capability. It is not out of the question that this disruptive technology could even bring about a paradigm shift in operations at the cyber-electromagnetic battleground. At least, forward-looking innovators in the military communications community would right now have a window of opportunity to engage in original, potentially high-impact scientific research on FD military radio systems, which we would like to spur on by this speculative tutorial article. [ABSTRACT FROM AUTHOR]

In this paper, we provide detailed modeling of the spurious intermodulation distortion products appearing in the own receiver (RX) operating band as a result of coexisting transmitter (TX) and RX nonlinearities with noncontiguous carrier aggregation transmissions. Furthermore, an efficient digital front-end signal processing technique is proposed, which can flexibly mitigate the resulting RX in-band self-interference caused either by individual or simultaneously coexisting TX and RX nonlinearities. The technique is based on accurately estimating the effective leakage channel that models the nonlinearities of the TX and RX chains and the duplexer filters characteristics. In the parameter estimation stage, an observation RX chain is adopted for separately estimating the TX passband leakage response, which facilitates efficient joint estimation and regeneration of the TX- and RX-induced self-interference. In the online digital cancellation, the actual transmit data are used in conjunction with the estimated channel responses to generate a replica of the overall nonlinear self-interference, which is subsequently suppressed by subtracting it from the actual observation. In general, the proposed technique can efficiently estimate and suppress the self-interference at arbitrary spurious sub-bands located at the RX band. The performance evaluations with comprehensive numerical simulations and practical RF measurements indicate highly accurate and efficient operation, with up to 28 dB of measured self-interference suppression. [ABSTRACT FROM PUBLISHER]

This paper proposes two digital receiver (RX) linearization and in-phase/quadrature (I/Q) correction solutions, where an additional reference RX (ref-RX) chain is adopted in order to obtain a more linear observation, in particular, of the strong incoming signals. This is accomplished with reduced RF gain in the ref-RX in order to avoid nonlinear distortion therein. In digital domain, the signal observed by the ref-RX is exploited in linearizing the main RX. This allows combining the sensitivity of the main RX and the linearity of the lower gain ref-RX. The proposed digital processing solutions for implementing the linearization are feedforward interference cancelation and nonlinearity inversion, which are both adapted blindly, without a priori information of the received signals or RX nonlinearity characteristics. The linearization solutions enable flexible suppression of nonlinear distortion stemming from both the RF and analog baseband components of different orders. Especially, wideband multicarrier RXs, where significant demands are set for the RX linearity and I/Q matching, are targeted. Using comprehensive RF measurements and realistic base-station scale components, an RX blocker tolerance improvement of 23 dB and a weak carrier signal-to-noise-and-distortion ratio gain of 19 dB are demonstrated with combined linearization and I/Q correction. [ABSTRACT FROM AUTHOR]

Noncontiguous transmission schemes combined with high power-efficiency requirements pose big challenges for radio transmitter and power amplifier (PA) design and implementation. Due to the nonlinear nature of the PA, severe unwanted emissions can occur, which can potentially interfere with neighboring channel signals or even desensitize the own receiver in frequency division duplexing transceivers. In this paper, to suppress such unwanted emissions, a low-complexity subband digital predistortion solution, specifically tailored for spectrally noncontiguous transmission schemes in low-cost devices, is proposed. The proposed technique aims at mitigating only the selected spurious intermodulation distortion components at the PA output, hence allowing for substantially reduced processing complexity compared with classical linearization solutions. Furthermore, novel decorrelation-based parameter learning solutions are also proposed and formulated, which offer reduced computing complexity in parameter estimation as well as the ability to track time-varying features adaptively. Comprehensive simulation and RF measurement results are provided, using a commercial LTE-Advanced mobile PA, to evaluate and validate the effectiveness of the proposed solution in real-world scenarios. The obtained results demonstrate that highly efficient spurious component suppression can be obtained using the proposed solutions. [ABSTRACT FROM PUBLISHER]

In this article, we address the challenges of transmitter-receiver isolation in mobile full-duplex devices, building on shared-antenna-based transceiver architecture. First, self-adaptive analog RF cancellation circuitry is required, since the ability to track time-varying self-interference coupling characteristics is of utmost importance in mobile devices. In addition, novel adaptive nonlinear DSP methods are also required for final self-interference suppression at digital baseband, since mobile-scale devices typically operate under highly nonlinear low-cost RF components. In addition to describing the above kind of advanced circuit and signal processing solutions, comprehensive RF measurement results from a complete demonstrator implementation are also provided, evidencing beyond 40 dB of active RF cancellation over an 80 MHz waveform bandwidth with a highly nonlinear transmitter power amplifier. Measured examples also demonstrate the good self-healing characteristics of the developed control loop against fast changes in the coupling channel. Furthermore, when complemented by nonlinear digital cancellation processing, the residual self-interference level is pushed down to the noise floor of the demonstration system, despite the harsh nonlinear nature of the self-interference. These findings indicate that deploying the full-duplex principle can indeed also be feasible in mobile devices, and thus be one potential technology in, for example, 5G and beyond radio systems. [ABSTRACT FROM PUBLISHER]

In this paper, we present a novel digital predistortion (DPD) solution based on a direct learning approach, which is capable of reducing the unwanted emissions resulting from the power amplifier (PA) at any prespecified frequency located in the transmitter's out-of-band or spurious domain. The proposed scheme is based on evaluating the power spectral density (PSD) of the PA output signal and optimizing the DPD coefficients iteratively in order to minimize the output PSD around the prespecified frequency. To highlight the feasibility of the proposed implementation, the predistortion processing is kept as simple as possible, deploying quasi-memoryless polynomial models. Efficient mitigation of unwanted emissions around the target frequency is demonstrated via simulations and actual RF measurements, in both single- and dual-carrier waveform scenarios, using memoryless and memory-based PAs. The proposed DPD solution could be potentially employed in applications such as mobile devices utilizing noncontiguous multicarrier transmission, where the intermodulation spurs may overlap with the device's own receiver band, or could be potentially violating the spurious emission limits. Another target application is cognitive radio, where the PA may produce unwanted emissions that are interfering with primary-user transmissions. To the best of the authors' knowledge, there does not exist a similar technique in the open literature, and thus, the purpose of this paper is to encourage scientific discussions and technological innovations toward the creation of relatively low-complexity frequency-optimized predistortion techniques employed against selected unwanted emissions produced by the transmitter. [ABSTRACT FROM AUTHOR]