Search

This paper proposes an active radio frequency (RF) cancellation solution to suppress the transmitter (TX) passband leakage signal in radio transceivers supporting simultaneous transmission and reception. The proposed technique is based on creating an opposite-phase baseband equivalent replica of the TX leakage signal in the transceiver digital front-end through adaptive nonlinear filtering of the known transmit data, to facilitate highly accurate cancellation under a nonlinear power amplifier (PA). The active RF cancellation is then accomplished by employing an auxiliary TX chain to generate the actual RF cancellation signal, and combining it with the received signal at the receiver (RX) low-noise amplifier (LNA) input. A closed-loop parameter learning approach, based on the decorrelation learning rule, is also developed to efficiently estimate the coefficients of the nonlinear cancellation filter in the presence of a nonlinear PA with memory, finite passive isolation, and a nonlinear LNA. The performance of the proposed cancellation technique is evaluated through comprehensive RF measurements adopting commercial LTE-Advanced transceiver hardware components. The results show that the proposed technique can provide an additional suppression of up to 54 dB for the TX passband leakage signal at the LNA input, even at very high transmit power levels and with wide transmission bandwidths. Such a novel cancellation solution can, therefore, substantially improve the TX–RX isolation, hence reducing the requirements on passive isolation and RF component linearity, as well as increasing the efficiency and flexibility of the RF spectrum use in the emerging 5G radio networks. [ABSTRACT FROM PUBLISHER]

Spectrally non-contiguous transmissions pose serious transceiver design challenges due to the nonlinear PA. When two or more non-contiguous carriers with close proximity are amplified by the same PA, spurious emissions inside or in the vicinity of the transmitter RF band are created. These spurious emissions may violate emission limits or otherwise compromise network coverage and reliability. Lowering the transmit power is a straightforward remedy, but it will reduce throughput, coverage, and power efficiency of the device. To improve linearity without sacrificing performance, several DPD techniques have recently been proposed to target the spurious emissions explicitly. These techniques are designed to minimize the computational and hardware complexity of DPD, thus making them better suited for mobile terminals and other lowcost devices. In this article, these recent advances in DPD for non-contiguous transmission scenarios are discussed, with a focus on mitigating the spurious emissions in the concrete example case of non-contiguous dual-carrier transmission. The techniques are compared to more traditional DPD approaches in terms of their computational and hardware complexities, as well as linearization performance. [ABSTRACT FROM AUTHOR]

Carrier aggregation transmissions in frequency division duplexing devices reduce the duplexing distance between the transmitter (TX) and receiver (RX) bands. As a consequence, the spurious intermodulation distortion products created by the nonlinear RF front-end of the TX may easily extend over to the RX band, potentially causing own RX desensitization. In this paper, we propose an efficient and computationally feasible adaptive digital identification and cancellation technique to mitigate the RX desensitization. We first show that the spurious leakage signal at own RX band depends on an equivalent leakage channel that models the overall signal leakage path including the TX nonlinearities, duplexer filter responses, and RX path. The parameters of the equivalent leakage channel can be efficiently estimated with the least squares or the recursive least squares algorithm, using the actual digital transmit data as a reference, and then used to regenerate and cancel the leakage interference from the received signal. The performance of the proposed technique is evaluated with extensive computer simulations, as well as with practical real-world RF measurements, demonstrating excellent calibration properties with up to 19-dB improvement in singal-to-interference plus noise ratio of the desired received signal. [ABSTRACT FROM PUBLISHER]

In-band full-duplex relays transmit and receive simultaneously at the same center frequency, hence offering enhanced spectral efficiency for relay deployment. In order to deploy such full-duplex relays, it is necessary to efficiently mitigate the inherent self-interference stemming from the strong transmit signal coupling to the sensitive receive chain. In this article, we present novel state-of-the-art antenna solutions as well as digital self-interference cancellation algorithms for compact MIMO fullduplex relays, specifically targeted for reduced-cost deployments in local area networks. The presented antenna design builds on resonant wavetraps and is shown to provide passive isolations on the order of 60?70 dB. We also discuss and present advanced digital cancellation solutions, beyond classical linear processing, specifically tailored against nonlinear distortion of the power amplifier when operating close to saturation. Measured results from a complete demonstrator system, integrating antennas, RF cancellation, and nonlinear digital cancellation, are also presented, evidencing close to 100 dB of overall self-interference suppression. The reported results indicate that building and deploying compact full-duplex MIMO relays is already technologically feasible. [ABSTRACT FROM PUBLISHER]

This paper addresses the modeling and cancellation of self-interference in full-duplex direct-conversion radio transceivers, operating under practical imperfect radio frequency (RF) components. First, detailed self-interference signal modeling is carried out, taking into account the most important RF imperfections, namely, transmitter power amplifier nonlinear distortion as well as transmitter and receiver IQ mixer amplitude and phase imbalances. The analysis shows that after realistic antenna isolation and RF cancellation, the dominant self-interference waveform at the receiver digital baseband can be modeled through a widely linear transformation of the original transmit data, opposed to classical purely linear models. Such widely linear self-interference waveform is physically stemming from the transmitter and receiver IQ imaging and cannot be efficiently suppressed by classical linear digital cancellation. Motivated by this, novel widely linear digital self-interference cancellation processing is then proposed and formulated, combined with efficient parameter estimation methods. Extensive simulation results demonstrate that the proposed widely linear cancellation processing clearly outperforms the existing linear solutions, hence enabling the use of practical low-cost RF front ends utilizing IQ mixing in full-duplex transceivers. [ABSTRACT FROM PUBLISHER]

In this paper, we present a novel digital predistorter structure for joint mitigation of frequency-dependent power amplifier (PA) and in-phase and quadrature (I/Q) modulator impairments in direct-conversion radio transmitters. The predistorter is based on an extended parallel Hammerstein structure, yielding a predistorter that is fully linear in the parameters. In the parameter estimation stage, the indirect learning architecture is utilized. The proposed technique is the first technique in the literature to consider the joint estimation and mitigation of frequency-dependent PAand I/Q modulator impairments. Extensive simulation and measurement analysis is carried out to verify the operation and efficacy of the proposed predistortion structure. It is shown that the adjacent channel power ratio is increased by more than 20 dB in all experiments when using the proposed method, and that the performance of the reference techniques is clearly exceeded. [ABSTRACT FROM AUTHOR]

In this article, we address the challenges of transmitter-receiver isolation in mobile full-duplex devices, building on shared-antenna-based transceiver architecture. First, self-adaptive analog RF cancellation circuitry is required, since the ability to track time-varying self-interference coupling characteristics is of utmost importance in mobile devices. In addition, novel adaptive nonlinear DSP methods are also required for final self-interference suppression at digital baseband, since mobile-scale devices typically operate under highly nonlinear low-cost RF components. In addition to describing the above kind of advanced circuit and signal processing solutions, comprehensive RF measurement results from a complete demonstrator implementation are also provided, evidencing beyond 40 dB of active RF cancellation over an 80 MHz waveform bandwidth with a highly nonlinear transmitter power amplifier. Measured examples also demonstrate the good self-healing characteristics of the developed control loop against fast changes in the coupling channel. Furthermore, when complemented by nonlinear digital cancellation processing, the residual self-interference level is pushed down to the noise floor of the demonstration system, despite the harsh nonlinear nature of the self-interference. These findings indicate that deploying the full-duplex principle can indeed also be feasible in mobile devices, and thus be one potential technology in, for example, 5G and beyond radio systems. [ABSTRACT FROM PUBLISHER]