Search

Under the current trend of power electronics in energy systems, a high percentage of renewable energy transports clean energy to the grid through grid-connected inverters. The pulse-width modulation (PWM) technique brings high-order harmonics near to the switching frequency, and LCL filters with low-pass characteristics become the common choice for grid-connected inverters. However, the low-order harmonics caused by nonideal switching characteristics are difficult to filter out, and the new resonance point introduced by the LCL filter causes a security problem for the energy systems. Firstly, the generation mechanism of the 6 k ± 1 order harmonic and high-frequency resonance from a PV grid-connected inverter is analyzed. Then, a virtual resistor is constructed by the active damping method to absorb the resonant component. Meanwhile, this paper also presents an adaptive modulation voltage compensation method to decrease the low-order harmonics. Finally, the actual measured data of user photovoltaic (PV) and multiple comparative simulations verify these theories. Simulation results show that the proposed coordinated control algorithm reduces the peak of the resonance point, and the rate of low-order harmonics mitigation is more than 50%. The proposed method is suitable for various operating conditions. [ABSTRACT FROM AUTHOR]

This article introduces a new scheme for suburban renewable energies, hydrogen plant, and logistics (SRE-HP-LC) integration scheme and dispatching. The objective of the proposed SRE-HP-LC integration scheme aims at coordinating the operation of renewable energies, hydrogen production, and storage and logistic transportation. In order to take advantages of various energy conversion techniques to enhance the energy utilization rate and improves the financial revenue of the integration scheme, a completed dispatching and operating scheme for the proposed SRE-HP-LC integration scheme is introduced in the scheme stage. A multiple-demand response objective function is developed in the operation stage to coordinate the hydrogen energy usage in the SRE-HP-LC integration scheme. The proposed SRE-HP-LC integration scheme considers the uncertainties of renewable energy output and truck demand so that it improves the revenue of every component in the integration scheme. Case studies on a general integration system verify the effectiveness and economic value of the proposed SRE-HP-LC integration scheme. [ABSTRACT FROM AUTHOR]

• The small-signal stability of current vector control and power synchronization control under different system strengths is studied. • The key factors of disturbance in the process of control mode switching are analyzed. • Based on the principles of current vector control and power synchronization control, a smooth switching control strategy for PV grid-connected converter is proposed. • An advanced smooth switching control strategy with complete process frequency support by the power correction is proposed. The continuous increase in the penetration of renewable energy sources such as photovoltaics (PV) brings operational challenges to the traditional distribution network. With a large-scale PV integration, the power system behaves as a weak grid, which leads to more frequent and wider changes in system strength. In order to improve the system stability, the PV system is required to operate stably while providing necessary system support under different operating conditions. However, there are two issues for the PV system needs to address to satisfy this requirement. Nowadays, there are two types of control strategies for PV systems: the grid-following (GFL) control and the grid-forming (GFM) control. The two control strategies differ in inertia support capability and control stability under different operating conditions. To guarantee the grid connection stability as well as the operating stability under AC systems with different strengths, the smooth switching between the GFL and GFM is an urgent topic. In addition, how to maintain the system frequency support performance during the control switching of the PV system is also a challenge. In this paper, an advanced smooth switching control strategy is proposed to enhance the operational stability and flexibility of the PV system while maintaining the frequency support performance during the switching process. Firstly, the small-signal stability of typical control strategies of GFL and GFM under different system strengths is compared to analyze the necessity of the control switching between the two control modes. Then, a smooth switching control strategy is proposed to realize the smooth switching when AC grid strength changes. More importantly, to improve the system frequency performance and realize continuous frequency support during the switching process, a power correction function is developed on the smooth switching control strategy. The effectiveness and universality of the proposed control strategy are verified by case studies on a modified IEEE 33 bus distribution network with high PV system integration. [ABSTRACT FROM AUTHOR]

As the typical clean and renewable energy, wind energy has witnessed a continuous annual increase in the last few decades. Due to the random and intermittent characteristics, the wind producers in the electric market meet serious financial losses caused by the deviation between the actual power output and forecasting result. It is difficult to increase the accuracy of forecasting in a short time. How to improve the financial income has become a major task to wind producers and academia. Being the backbone network of the offshore wind farms (OWFs), voltage source converter-based multi-terminal HVdc system (VSC-MTdc) has been regarded as one of the effective solutions to transport wind power. In this paper, an optimal distribution method is proposed for VSC-MTdc system integrating OWFs to reduce the financial loss due to wind power output deviation. The proposed method could be divided into two optimizing functions. The first optimizing function of the proposed method is to analyze the onshore external system according to the historical system operation data and adjust the droop coefficient with the analytic hierarchy process. The second optimizing function of the proposed method is to do further adjusting with the regulating price. With the case study, the proposed optimal distribution method has proved that it can bring more benefit to wind producers. [ABSTRACT FROM AUTHOR]

With the development of urban economy and the growing integration of renewable energy, there are increasing challenges on the urban power grid. Due to the transmission stress and short-circuit current limitation, the traditional urban power grid cannot satisfy the new requirements. Multivoltage-level dc grid (MDCG) is an alternative approach to the urban power grid upgrade. This paper presents an MDCG topology, which can be used in a future urban power grid. Three operation modes of an urban MDCG are proposed: auto operation mode, power-limited operation mode, and stand-alone operation mode. The auto operation mode is the normal one for urban MDCG. The power-limited operation mode is designed to keep the capability to support urban high voltage ac transmission grid in emergencies. The stand-alone operation mode is used to keep stability in case the dc–dc converter system outage occurs. The combination control of three operation modes is put forward to enhance the reliability of urban MDCG in various operating conditions. The simulation results show that the proposed operation modes and combination control are effective and have good performance. [ABSTRACT FROM PUBLISHER]

With the increasing penetration of renewable energy into the power system, the voltage source converter (VSC) for integrating renewable energy has become the most common device in the electric network. However, the operating stability of the VSC is strongly dependent on its operating control strategy, which is also highly related to the strength of the AC system. Choosing the control strategy of VSC for different strengths of AC systems becomes an essential issue for maintaining the symmetry between high proportion of renewable energy integration and stable operation of AC system. In order to obtain the operation zones of the control strategies of the VSC under different strengths of AC system, in this paper, the two common VSC control strategies, vector current control (VCC) and power synchronization control (PSC), are compared. Firstly, the principle of VCC and PSC are introduced. Then, based on the short circuit ratio (SCR) and the power limit calculation under steady-state conditions of the VSC, the operation zones of the vector current control and power synchronization control are proposed. Finally, a medium voltage modular multilevel converter (MMC) system was built in PSCAD/EMTDC and the proposed operation zones of the VCC and PSC were tested by changing the SCR of the modified IEEE 33 bus system and analyzed via the critical short circuit ratio (CSCR) analysis, the small-signal stability analysis, and transient stability analysis. The results indicate that, as the SCR decreases, the VSC based on VCC is gradually worked into unstable conditions, while the stability of VSC based on PSC gradually increases. The analysis results provide a criterion for the converter operation strategy change that could significantly improve the operating stability of the VSC in the power system and realize the symmetry of the stability of the converter and the change of the strength of the AC system. [ABSTRACT FROM AUTHOR]