Search

Qualitative and quantitative flow visualizations were performed on a flapping rigid plate to establish a quantitative method for flow observation and evaluation of the force in the near field of a flapping wing. Flow visualization was performed qualitatively with dye visualization and quantitatively with velocity measurements using stereo particle image velocimetry (PIV) on three planes near the tip of the plate along its chord and oriented normally. By ensemble averaging the velocity fields of the same phase angles, they represent a portion of the volume near the tip. Measurements were conducted with two flapping frequencies to compare the flow structure. The second invariant of the deformation tensor visualized the leading edge and mid-chord vortices around the plate appearing due to flow separation behind the plate while other vortical structures were visualized by streamlines. These structures appear to be related to the dynamics of the leading edge vortex. Force analysis by integrating the phase-averaged velocity field within a chosen control volume showed increases in the maxima of the magnitudes of the non-dimensional unsteady force terms on the edge of the plate at the angles after the end of each stroke. The non-dimensional phase-averaged momentum flux was similar for both flapping frequencies. [ABSTRACT FROM AUTHOR]

Cross-flow hydrokinetic turbines have sparked interest among fluid dynamicists for their potential for power enhancement in paired configuration. Following the first part of a laboratory-scaled turbine wake measurement project, this second part presents a monoscopic particle image velocimetry measurement of the near-wake of two cross-flow hydrokinetic turbines in six different counter-rotating configurations. The turbines operated in a small water flume at an average diameter-based Reynolds number of 2 × 10 4 with the incoming streamwise velocity of 0.316 m/s. The six configurations included two turbine separation distances, two turbine phase angles differences, and two different relative incoming flow angles. Similar to the observation of the single turbine configurations in part I, a correlation between flow field structures and the corresponding power output was observed. Effects of each parameter of the counter-rotating configurations are further discussed, which suggest guidelines for setting up multiple devices in a power farm. This article is accompanied by all full numeric data sets and videos of the results. [ABSTRACT FROM AUTHOR]

This article proposes an experimental apparatus design to measure the power of a cross-flow marine hydrokinetic turbine system operating in a laboratory water tunnel. Data, from one Hall sensor output signal, was processed to capture the three types of torque exerted on the turbines: mechanical loss, brake, and hydrodynamic torque. The method was then applied to compare the power of a twin turbine system in different counter-rotating configurations. Controlled by a hysteresis brake, the tip-speed-ratio was varied in a constant freestream velocity of 0.316 m/s. While the braking torque was independent of the speed, the mechanical loss was found to depend on the system rotational speed and the amount of mass mounted on the mechanical support. In a counter-rotating configuration, the turbines were synchronized through a pair of spur gears and timing pulleys. Operating at the average chord based Reynolds number of 8000, each turbine had three NACA0012 blades mounted at 15 ∘ pitch angle. The power coefficient results of 8 turbine configurations showed the tendency of power enhancement of counter-rotating configurations due to blade interaction and increase in blockage ratio. Comparison of the results suggested direct application in a river flow scenario and manipulation of the blade interaction for optimal power production. [ABSTRACT FROM AUTHOR]