Search

Abstract: We present a new method of integrating Global Positioning System (GPS) and accelerometer data for high‐rate seismogeodesy. This method is based on the GPS variometric approach which can obtain seismic waves in real time using only the readily available broadcast products and a single receiver. Collocated 1‐Hz GPS and 200‐Hz accelerometer data from the 2016 MW 7.8 Kaikōura earthquake were analyzed to verify the effectiveness of this method. Results reveal that this method can provide broadband and more accurate velocities and displacements qualified to detect P wave arrivals. Moreover, this method can effectively avoid the aliasing problem present in the 1‐Hz GPS waveforms. We therefore conclude that this new method can be a powerful tool to capture seismic waves in real time, which is crucial for the purpose of tsunami early warning and earthquake rapid response. [ABSTRACT FROM AUTHOR]

For earthquake and tsunami early warning and emergency response, the earthquake epicenter and magnitude should be determined rapidly and correctly. Using high-rate GPS observations, we can readily obtain precise and high resolution displacement time series and the seismic waveforms during the earthquake. In this paper, a new algorithm is proposed for estimating the earthquake epicenter and magnitude with the seismic waveforms derived from high-rate GPS data during the earthquake. A case study of the 2008 Wenchuan earthquake is conducted from 1 Hz GPS data and the epicenter and magnitude are determined. Compared with the results issued by the China Seismological Bureau, the estimation error of the epicenter and the magnitude is about 12 km and 0.1 magnitude unit, respectively. It has shown that high-rate GPS could be a new tool feasible for estimating the earthquake epicenter and magnitude, independent of or combined with seismometers. [ABSTRACT FROM AUTHOR]

High-rate GPS has been widely used to construct displacement waveforms and to invert for source parameters of earthquakes. Almost all works on internal and external evaluation of high-rate GPS accuracy are based on GPS relative positioning. We build an experimental platform to externally evaluate the accuracy of 50-Hz PPP displacement waveforms. Since the shake table allows motion in any of six degrees of freedom, we install an inertial measurement unit (IMU) to measure the attitude of the platform and transform the IMU displacements into the GPS coordinate system. The experimental results have shown that high-rate PPP can produce absolute horizontal displacement waveforms at the accuracy of 2-4 mm and absolute vertical displacement waveforms at the sub-centimeter level of accuracy within a short period of time. The significance of the experiments indicates that high-rate PPP is capable of detecting absolute seismic displacement waveforms at the same high accuracy as GPS relative positioning techniques, but requires no fixed datum station. We have also found a small scaling error of IMU and a small time offset of misalignment between high-rate PPP and IMU displacement waveforms by comparing the amplitudes of and cross-correlating both the displacement waveforms. [ABSTRACT FROM AUTHOR]