Search

Abstract: The performance of indirect evaporative cooling system (IEC) to pre-cool air for a conventional mechanical cooling system has been investigated for four cities of Iran. For this purpose, a combined experimental setup consisting of an IEC unit followed by a packaged unit air conditioner (PUA) was designed, constructed and tested. Two air simulators were designed and used to simulate indoor heating load and outdoor design conditions. Using of experimental data and an appropriate analytical method, the performance and energy reduction capability of combined system has been evaluated through the cooling season. The results indicate IEC can reduce cooling load up to 75% during cooling seasons. Also, 55% reduction in electrical energy consumption of PUA can be obtained. [ABSTRACT FROM AUTHOR]

Cooling performance of two-stage indirect/direct evaporative cooling system is experimentally investigated in the various simulated climatic conditions. For this purpose, a two-stage evaporative cooling experimental setup consisting of an indirect evaporative cooling stage (IEC) followed by a direct evaporative cooling stage (DEC) was designed, constructed and tested. Due to the wide variety of climatic conditions in Iran, two air simulators were provided to simulate outdoor design condition of different cities in primary and secondary air streams. Results show that under various outdoor conditions, the effectiveness of IEC stage varies over a range of 55–61% and the effectiveness of IEC/DEC unit varies over a range of 108–111%. Aspects of achieving comfort conditions and power saving have been investigated with related excess water consumption. Considering the evaporative comfort zone, this system can provide comfort condition in a vast region in Iran where direct evaporative alone is not able to provide summer comfort condition. More than 60% power saving could be obtained by this system in comparison with mechanical vapor compression systems with just 55% increase in water consumption with respect to direct evaporative cooling systems. This system can fill the gap between direct evaporative cooling systems and mechanical vapor compression systems as an energy efficient and environmentally clean alternate. [Copyright &y& Elsevier]

Abstract: There are few countries in the world where they have special characteristics including weather conditions, wind direction, and topography. In other words, some countries have multi-climate regions, and needed to be investigated more precisely. Based on these conditions, several cooling systems can be used for each region. In this study, the potential of the direct evaporative cooling (DEC) systems, indirect evaporative cooling (IEC) systems, desiccant wheel (DW) with DEC systems, and combination of theses methods for cooling in the cities of Iran are investigated. In the remaining regions, mechanical cooling systems and absorption systems can be used. According to weather condition and natural resources for water in Iran, DEC can be considered as a serious alternative for cooling. In this paper, based on numerical simulation and long-term meteorological measurements, general set of criteria is obtained. Results show that according to population dispersal DEC systems can provide comfort conditions for 53% of people of Iran. IEC, DW, combination of these systems, and mechanical cooling systems can supply comfort condition in remaining major cities of Iran consequently. Moreover, for showing the uniqueness of weather condition which leads to these varieties of climates, other important cities in the neighboring countries are compared with this numerical simulation code. [Copyright &y& Elsevier]