Search

In this study, we analyzed low-frequency drone-borne ground-penetrating radar (GPR) and full-wave inversion for soil electrical conductivity mapping. Indeed, in the lowest GPR frequency ranges, the soil surface reflexion coefficient depends more on the soil electrical conductivity than on its permittivity. Numerical experiments were conducted within the frequency range 15–45 MHz to analyze parameter sensitivities, the well-posedness of the inverse problem as well as the depth of sensitivity. The results show that the soil surface reflexion is significantly more sensitive to the soil electrical conductivity than the soil permittivity. Therefore, the conductivity can be retrieved using full-wave inversion within this frequency range, with a characterization depth varying from 0.5 to 1 m, depending on the soil properties. Yet, the permittivity also affects the results and should be accounted for in the inversion strategy. Field measurements were performed using low-frequency drone-borne radar with a 5-m half-wave dipole antenna, and electromagnetic induction (EMI) measurements with different depth sensitivities were conducted for comparison. Kriging interpolation was used to get maps from measurement points. The soil conductivity maps obtained by the proposed GPR and EMI are compliant in terms of absolute values and spatial patterns. This study demonstrated the capacity of low-frequency drone-borne GPR for fast, field-scale soil electrical conductivity mapping. [ABSTRACT FROM AUTHOR]

Litter is acknowledged to affect microwave remote sensing data over forests, and accurate quantification of litter radiative properties is essential for proper retrieval of forest soil water content and forest canopy biophysical characteristics from satellite or airborne sensors. Furthermore, detailed characterization of forest soil organic horizons is of paramount importance for ecological studies and for carbon cycle and global changerelated studies. Ultrawideband ground-penetrating radar (GPR) data acquired above beech forest litter were used to analyze the effects of litter on the backscattering and investigate the ability of GPR to quantitatively characterize the properties of the forest floor. Radar measurements were performed over different litter configurations (i.e., single layers of recently fallen litter (OL) or of fragmented litter (OF), and combined OL-OF layers) and thicknesses. Radar data were processed through full-wave inversion. Over the considered frequency range (0.8-4.0 GHz), attenuation of the radar signal increased as both frequency and litter thickness increase, due to scattering and dielectric losses. These effects were accounted for in the radar model through frequency dependence of litter apparent electrical conductivity. Good agreement (RMSE = 9.5 × 10-3 m) was observed between estimated and measured litter thicknesses. Radar data inversions provided reliable estimates of litter electromagnetic properties, with relative dielectric permittivity values around 1.2 and 3.9 for OL and OF litters, respectively, and corresponding values of 0.032 and 0.080 Sm-1 for litter apparent electrical conductivity at 4.0 GHz. These results show great promise for the use of GPR for noninvasive characterization of forest litter. [ABSTRACT FROM PUBLISHER]

We present a closed-form equation for intrinsic modeling of near-field electromagnetic induction (EMI) antennas for planar layered media characterization. Resorting to a decomposition of the backscattered EM field into elementary distributions over the antenna aperture, the EMI transmitting and receiving antennas are modeled using infinitesimal magnetic dipoles and field points, and characteristic frequency-dependent global reflection and transmission coefficients. Low-frequency propagation of the EM fields in the medium is described using 3-D planar layered media Green's functions. We performed measurements with a loop antenna situated at different heights, ranging from near-field to far-field conditions, above water of known electrical conductivity to determine its intrinsic properties, and a range of salinity conditions was applied to subsequently validate the proposed model. The EMI system was set up using a vector network analyzer equipped with a prototype EMI antenna specifically designed for this application. The model showed good accuracy for reproducing the observed data, and model inversion provided good estimates of the medium electrical conductivity. Yet, insensitivity of the EMI signal to water electrical conductivity was encountered for low salinity due to the presence of a copper sheet as the bottom boundary condition of the experimental setup. Moreover, the efficiency of the antenna decreased rapidly as antenna height above water surface increases, leading to increasing discrepancies between estimated and measured water electrical conductivity values as the antenna moves away from the water surface. Although some technical improvements are still needed, the proposed approach is promising for quantitative estimation of soil electrical conductivity from EMI data. [ABSTRACT FROM PUBLISHER]

We present validation results of a new ground-penetrating radar (GPR) near-field model for determining the electrical properties and correlated water content of a sand using both frequency- and time-domain radars. The radar antennas are intrinsically characterized using an equivalent set of infinitesimal source/field points and characteristic functions of antennas, which were determined using measurements with the antenna at different distances from a copper plane. The antenna radiation was modeled using six source and field points, which was found to be a good compromise between high modeling accuracy and computing efficiency. We validated our model by inverting GPR data to predict the water content of a sand layer subject to seven levels of saturation. A soil dielectric mixing model was integrated into the full-wave GPR inverse modeling to directly estimate the water content and to account for the frequency dependence of the electrical properties. Although the quality of the fit slightly decreased as the antenna approached the sand surface, the results showed a close agreement between measured and modeled data, resulting in accurate estimation of the water content. The average errors of all water content estimates were 0.012 cm3/cm3 for the frequency domain and 0.016 cm3/cm3 for the time-domain GPR. However, the accuracy reduced when the sand became wet. By performing numerical simulations, we found that it is due to the vertical heterogeneity of soil moisture under the effect of the hydrostatic pressure. We also showed that the GPR inversion with the multilayered soil model could account for this heterogeneity and improved the agreement between the modeled and measured GPR data as well as the accuracy of soil moisture estimation. As for the frequency dependence of the electrical properties, in the frequency ranges of both GPR systems, while the dielectric permittivity was approximately constant, the apparent conductivity exponentially increased with increasing frequency. The success of the calibration and validation in laboratory conditions demonstrates a great potential for practical applications of the radar model, notably for the digital soil mapping and nondestructive testing of materials. [ABSTRACT FROM PUBLISHER]