Search

Zinc oxide nanoparticle (ZnO NPs) has been used as a fertilizer alternative, although some applications technique and metal-microbial effects should be studied. This research evaluated the bioefficiency of synthetic ZnO NPs in soybean seedlings combined with different water status and with or without PcO6 bacteria. ZnO NPs performed in sand inhibited growth and fluorescence parameters. Still, when soybean seeds were exposed to ZnO NPs seed priming the root mass was increased, mainly in non-drought conditions. Soybean plants cultivated in drought conditions will have compromised development, although was demonstrate soybeans seed inoculation with PcO6 may decrease undesired effects from drought. Also, PcO6 soybean inoculation mitigate metal ZnO toxicity. Here, one of the first positive report about soybean interaction with PcO6 by drought and metal mitigation of toxicity. In addition, the best way to apply ZnO was through seed priming, while sand application was toxic and foliar application had no effects. [ABSTRACT FROM AUTHOR]

Limestone is the most widely used agricultural input for soil acidity correction and calcium (Ca) and magnesium (Mg) fertilization. However, other materials have the potential to fulfill these purposes, such as steel slags, also known as silicates. Silicates have higher solubility than limestone, serving as agents for increase pH in no‐till, in addition to being a source of Ca, Mg, and silicon (Si). This study aimed to compare the effects of surface application of dolomitic lime and calcium magnesium silicate on soil chemical properties, soybean [Glycine max (L.) Merr.] nutritional status, and grain yield under no‐till. The experiment was installed in the northwest Paraná State, Brazil, on a Rhodic Eutrustox. Lime and silicate rates were applied by broadcasting before the sowing of soybean. Silicate treatment increases soil Ca2+, pH, and base saturation up to a depth of 0.10 m. By contrast, liming effects on soil chemistry were restricted to the 0.05 m top layer after 24 months of application. The acidity correction and Ca2+ supply to greater soil depths and the increased leaf Si as a beneficial element provided by silicate treatment contributed to increasing soybean yield in the 2018/2019 and 2019/2020 seasons. Lime application, regardless of the rate, did not improve soybean yield. Waste from the steel industry can be used as acidity correctives and source of Si, Ca, and Mg, improving the agronomic performance of soybean. Core Ideas: Silicate is more efficient in maintaining soil fertility compared to lime.Changes in soil fertility were observed up to a depth of 0.10 m after 24 months.Silicate increases silicon content in soybean leaf.Surface application of silicate increased soybean yield up to 43%.Soybean yield did not improve with lime. [ABSTRACT FROM AUTHOR]

This study aimed to assess the nutritional status of soybean and wheat and the relationship with grain yield and biometric components after lime and phosphogypsum (GY) reapplication. Treatments consisted of two lime application methods, surface liming and incorporated liming, to different levels of base saturation (BS) (44, 70, and 90%), in addition to surface liming to 70% BS associated with a standard dose (70GY1) or double dose (70GY2) of GY. Treatments were applied in 2012 and reapplied in 2016. The results refer to the 2018/2019 soybean season and the 2019 wheat season. Lime + GY treatment increased leaf area, plant height, leaf dry matter, and stem dry matter in soybean but had no effect on specific leaf area (235.4 cm2 g−1), stem diameter (6.08 mm), number of pods per plant (71.7), grain number per plant (165), or thousand grain weight (117 g). Liming to 90% BS reduced leaf manganese contents in both crops and leaf iron content in soybean. GY application improved the calcium status of both crops and the sulfur status of soybean. However, 70GY2 reduced leaf magnesium contents in soybean and wheat. Soil tillage without lime reduced wheat yield by 12% compared with no-till. Soybean yield correlated positively with leaf nitrogen (0.79), leaf phosphorus (0.91), leaf area (0.62), and thousand grain weight (0.65), whereas wheat yield correlated with leaf phosphorus (0.83), calcium (0.75), and sulfur (0.74). For improved soybean and wheat performance, it is preferable to apply lime and GY to the soil surface (70GY1), permanently maintaining no-till practices. [ABSTRACT FROM AUTHOR]

Nutrient leaf application is complementary to soybean nutritional management, mainly at maturity, when plants present high nutritional demand and high nutrients and photoassimilate translocation rates for seed production. The aim of this research was to evaluate the agronomic performance, physiological quality, and nutritional contents of soybean seeds after application of different rates (0, 0.50, 1.0, 1.5, 2.0, and 2.5 kg ha−1) of foliar fertiliser containing calcium (20%) and boron (4%) at the R3 stage (onset of pod formation). This research was carried out in two sites (Guaragi and Floresta) both in Parana State, Brazil, in randomised complete blocks with 4 replicates. Calcium and boron leaf application increased grain sulphur and nitrogen levels (Guaragi) but reduced phosphorus and magnesium (Floresta). Regarding physiological quality, foliar fertilisation increased the index of germination speed. The yield and number of pods increased up to the rate of 0.6 and 1.2 kg ha−1 of leaf fertiliser in Floresta. Foliar fertilisation with calcium and boron showed advantages, however, results depended on the site, indicating different levels of soil fertility and climatic characteristics. [ABSTRACT FROM AUTHOR]

The objective of the study was to evaluate the effect of foliar application of urea and urea-formaldehyde, triazone-based fertilizers on soybean and corn crops. Four experiments were carried out, two on soybeans, one on first season corn, and the other on second season corn. The experiments were conducted using a randomized block design, with 5 treatments studied: T1—control without application of foliar nitrogen (N); T2—foliar application of conventional urea solution and three treatments with Hexion foliar fertilizers based on urea-formaldehyde and triazone (N-Hexion®), with varying levels of N and slow-release components; T3—Hexion 1; T4—Hexion 2; and T5—Hexion 3. The foliar application of conventional urea showed no statistically significant difference in relation to the control for the yield components and grain yield for the soybean crops in seasons 2018–2019 and 2019–2020. Urea-formaldehyde/triazone treatments showed a significant increase in yield for soybeans in the 2018–2019 season compared to the control and to conventional urea. Nitrogen fertilizers with high percentages of slow-release compounds promote nitrogen release more slowly, which led to no significant increase in yield for Hexion 1. No statistical differences were observed in the corn yield for the first and second crop. [ABSTRACT FROM AUTHOR]

Crop yield gains and improvements in surface and subsurface soil chemical properties are evident when agricultural lime and gypsum are used in high-acidity soils. However, there is scarce information on the effects of lime and gypsum application on no-till tropical soils previously treated with these additives (low-acidity soils). The duration of the effects of lime applied to the soil surface varies according to lime rate, product characteristics, soil conditions, and water and thermal regimes. Such residual effects influence the timing of lime reapplication. This study aimed to investigate the effects of surface application of agricultural lime and gypsum on soil chemical properties, soybean and second-crop corn yields, and lime residual contents. The experiment was conducted on a Red Latosol with a very clayey texture in Floresta, Paraná, Brazil. Four rates of dolomitic lime (0.0, 2.6, 5.4, and 8.1 Mg ha−1) and agricultural gypsum (0, 4, 8, and 12 Mg ha−1) were used. The experimental design was a randomized complete block with subplots and four replications. The experiment lasted for four soybean seasons and three second-crop corn seasons. At 6, 12, 24, and 36 months after treatment, soil samples were collected from the 0.00–0.05, 0.05–0.10, 0.10–0.20, 0.20–0.30, 0.30–0.40, and 0.40–0.60 m layers for chemical analysis. No significant interaction effects were observed on soil chemical properties. Liming resulted in soil alkalization, with a consequent reduction in Al3+ and an increase in Ca, Mg, base saturation, and pH. Residual lime was not detected in layers deeper than 0.05 m, suggesting a lack of physical movement of particles in the soil pore space. Residual lime was detected on surface soil (0.00–0.05 m) up to 36 months after application, demonstrating the low reactivity of lime on no-till soils. At 6 months after gypsum application, there was an increase in Ca2+ levels up to the 0.6 m layer, whereas Mg2+ levels were reduced throughout the soil profile for up to 36 months. In no-till soybean–second-crop corn rotation systems, use of agricultural gypsum alone did not provide consistent effects on crop yield and reduced foliar Mg contents. Under the studied conditions of low acidity, liming did not produce significant differences in crop yield but improved soil chemical properties for plant growth under no-till. • Residual lime was restricted to the 0.05 m layer. • Lime remained on the soil surface for up to 36 months after application. • Agricultural gypsum increased calcium content up to 0.6 m depth for 6 months. • Lime and gypsum application increased corn yield in some seasons. • Soybean yield did not improve with lime and reduced with gypsum in the first season. [ABSTRACT FROM AUTHOR]

Studies on the use of hyperspectral remote sensing for nutrient prediction in soybean (Glycine max L.) leaves are limited, especially regarding the selection of wavelengths. Therefore, the objective of this study was to estimate macro and micronutrients in soybean leaves by employing reflectance data modeled by Partial Least Squares Regression (PLSR) from bands selected by the iPLS (Interval PLS), method with a script developed for MATLAB R2018a. The experimental area was treated with different doses of limestone, with and without incorporation, also with phosphogypsum application in additional treatments. The soybean crops of 2018/2019 and 2019/2020 had the nutritional status evaluated by a random collection of the third fully developed trefoil in the R2 (full flowering) and R5.5 (76–100% grain filling) reproductive phenological stages. The leaf samples were submitted to conventional laboratory analyses. The Ca, Mg, K, P, S, Cu, Fe, Mn, and Zn elements in the leaves were quantified through spectrometry. A field spectroradiometer performed spectral data acquisition in the visible-near infrared, short-wave infrared spectral range of soybean leaves. The spectral curves were subjected to iPLS, and PLSR models were fitted. After iPLS selection, the coefficient of determination (R2) values of PLSR models were on average 15.3% and 16.6% higher in calibration and validation, respectively, compared to classical methods. The PLSR model for Mn, which obtained R2 above 0.90 in the calibration and validation phases, stood out. The Root Mean Square Error (RMSE) decreased, on average, more than 15.0%, both in calibration and validation, after applying the iPLS selection. The models for Ca and Mn stood out with over a 30.0% decrease in RMSE, in calibration and validation. The iPLS selection was efficient in improving the performance and accuracy of the PLSR models, increasing the R2 and decreasing the RMSE, opening new possibilities for the analysis and prediction of macro and micronutrients in plants. [Display omitted] • The wavelengths selection by iPLS was efficient in improving the PLSR models. • R2 increased on average 15% and 17% in calibration and validation, respectively. • RMSE decreased on average 15% after applying the iPLS selection. • The PLSR model for Mn, which obtained R2 above 0.90 stood out. [ABSTRACT FROM AUTHOR]