Search

The Los Alamos Isotope Production Facility (IPF) creates medical isotopes using a proton beam impinged on a target stack. Spallation neutrons are created in the interaction of the beam with target. The use of these spallation neutrons to produce additional radionuclides has been proposed. However, the energy distribution and magnitude of the flux is not well understood. A modified SAND-II spectral adjustment routine has been used with radioactivation foils to determine the differential neutron fluence for these spallation neutrons during a standard IPF production run. [ABSTRACT FROM AUTHOR]

Transmutation reactions in the 237 Np, 238 Pu, and 239 Pu samples were investigated in the neutron field generated inside a massive ( m = 512 kg) natural uranium spallation target. The uranium target assembly QUINTA was irradiated with the deuteron beams of kinetic energy 2, 4, and 8 GeV provided by the Nuclotron accelerator at the Joint Institute for Nuclear Research (JINR) in Dubna. The neutron-induced transmutation of the actinide samples was measured off-line by implementing methods of gamma-ray spectrometry with HPGe detectors. Results of measurement are expressed in the form of both the individual reaction rates and average fission transmutation rates. For the purpose of validation of radiation transport programs, the experimental results were compared with simulations of neutron production and distribution performed by the MCNPX 2.7 and MARS15 codes employing the INCL4-ABLA physics models and LAQGSM event generator, respectively. In general, a good agreement between the experimental and calculated reaction rates was found in the whole interval of provided beam energies. [ABSTRACT FROM AUTHOR]

The Gamma-3 assembly is located at the Joint Institute for Nuclear Research, Dubna, Russia. It consists of a cylindrical lead target (ø = 8 cm, L = 58.8 cm) surrounded by reactor grade graphite (110 × 110 × 60 cm). The target was irradiated with a beam of 1.6 GeV deuterons from the Nuclotron accelerator and CR-39 track detectors coupled to LR-115 2B film were used to measure the slow neutron distribution on the surface of the graphite. The detection efficiency of the CR-39 in the CR-39/LR-115 2B system was measured using a custom made calibration setup and found to be (1.12 ± 0.05) × 10−3 and (6.1 ± 1.2) × 10−4 tracks per neutron, for thermal and epithermal neutrons respectively, under the etching and counting procedures described in this work. The irradiation of the Gamma-3 was also simulated using MCNPX 2.7 Monte Carlo code and good agreement between the experimental and calculated track densities was found. This serves as a good validation for the computational models used to simulate spallation neutron production, transport and moderation. [ABSTRACT FROM AUTHOR]

Abstract: The spallation neutron flux produced from proton irradiation of rubidium chloride and gallium targets at the Los Alamos National Laboratory (LANL) Isotope Production Facility (IPF) was investigated using the activation foil technique and computational simulation. Routine irradiations have been found to produce fluxes as high as 1012 ncm−2 s−1, with approximately 50% of the total flux having energy in excess of 1MeV. Measurements of activation foils are compared with the predicted radionuclide yield using nuclear excitation functions from MCNPX event generators, evaluated nuclear data, and the TALYS nuclear code. Practical application of the secondary neutron flux in the realm of radioisotope production is considered. [Copyright &y& Elsevier]

In the interaction of relativistic protons with heavy and extended targets such as lead, large number of neutrons is produced in the course of the so-called spallation process. These neutrons can be used to drive a sub-critical nuclear assembly for energy generation and/or for the transmutation of the long-lived nuclear waste isotopes to environmentally safer nuclear species. Such nuclear assemblies are referred to as accelerator driven systems (ADS).Knowledge of the neutron yield in the spallation process and an understanding of the behaviour of these neutrons in the desired sub-critical assembly are the most important and determining factors in the design and operation of these systems. Many parameters related to the neutronics of an ADS can be studied qualitatively as well as quantitatively using solid-state nuclear track detectors (SSNTD). In some circumstances SSNTDs provide the best and the most logical detector option for these investigations.In this paper applications of the SSNTDs into research related to ADS are discussed and some experimental and theoretical results presented. [Copyright &y& Elsevier]

Neutron induced nuclear recoils were used to determine the spatial distribution of the weakly moderated spallation neutrons produced in the interaction of 1 GeV protons with lead and uranium–lead targets. CR39 plastic track detectors were used to record neutron-induced recoil tracks. The track density measurements were carried out using a fully automated optical microscope. The experimental results were compared with Monte Carlo simulations using MCNPX-2.1.5 code and an extension code that was written for this purpose. A good agreement was found between the experiment and calculations for normalised results. Applicability of the MCNPX-2.1.5 code for absolute recoil track density determination is discussed. [Copyright &y& Elsevier]

The LAHET code system is used to study the behaviour of the spallation neutrons resulting from the interaction of 2.5 GeV/c protons with a massive lead target within a large (∼32 m3) lead and graphite moderating environments. The spatial and energy distribution of the neutrons with presence and absence of a fissile material in Accelerator Driven Systems (ADS) are investigated.It is shown that the energy spectra of the neutrons in graphite and lead moderators are very different and such difference is expected to result in noticeable differences in the nuclear waste transmutation abilities of the ADSs that use graphite and lead for neutron moderation and storage. [Copyright &y& Elsevier]

Transmutation rates of 239Pu and some minor actinides (237Np, 241Am, 245Cm and 246Cm), in two accelerator-driven systems (ADS) with lead or graphite moderating environments, were calculated using the LAHET code system. The ADS that were used had a large volume (∼32 m3) and contained no fissile material, except for a small amount of fissionable waste nuclei that existed in some cases. Calculations were performed at an incident proton energy of 1.5 GeV and the spallation target was lead. Also breeding rates of 239Pu and 233U as well as the transmutation rates of two long-lived fission products 99Tc and 129I were calculated at different locations in the moderator. It is shown that an ADS with graphite moderator is a much more effective transmuter than that with lead moderator. [Copyright &y& Elsevier]

We summarize here the results of the TARC experiment whose main purpose is to demonstrate the possibility of using Adiabatic Resonance Crossing (ARC) to destroy efficiently Long-Lived Fission Fragments (LLFFs) in accelerator-driven systems and to validate a new simulation developed in the framework of the Energy Amplifier programme. An experimental set-up was installed in a CERN PS proton beam line to study how neutrons produced by spallation at relatively high energy (En⩾1 MeV) slow down quasi-adiabatically with almost flat isolethargic energy distribution and reach the capture resonance energy of an element to be transmuted where they will have a high probability of being captured. Precision measurements of energy and space distributions of spallation neutrons (using 2.5 and 3.5 GeV/c protons) slowing down in a 3.3 m×3.3 m×3 m lead volume and of neutron capture rates on LLFFs 99Tc, 129I, and several other elements were performed. An appropriate formalism and appropriate computational tools necessary for the analysis and understanding of the data were developed and validated in detail. Our direct experimental observation of ARC demonstrates the possibility to destroy, in a parasitic mode, outside the Energy Amplifier core, large amounts of 99Tc or 129I at a rate exceeding the production rate, thereby making it practical to reduce correspondingly the existing stockpile of LLFFs. In addition, TARC opens up new possibilities for radioactive isotope production as an alternative to nuclear reactors, in particular for medical applications, as well as new possibilities for neutron research and industrial applications. [Copyright &y& Elsevier]