Search

Mid-infrared reflectance spectroscopy and laser-induced breakdown spectroscopy are combined to provide the quantitative mineral composition of rocks. Measurement results for kaolinite are presented and a relative error of kaolinite abundance of 0.8 % is obtained., Applied Industrial Spectroscopy, June 22–26, 2020, Washington, DC

A method based on laser induced breakdown spectroscopy (LIBS) for monitoring lead and copper accumulation in edible fish, particularly "tilapia del Nilo" (Oreochromis niloticus) is presented. The capability of this analytical method is compared with results obtained by atomic absorption spectrometry. Detection limits by LIBS are 25 parts per million (ppm) for Pb and 100 ppm for Cu, values that are below the maximum permissible levels of some international standards. Application of LIBS detection allows the development of portable instruments for contamination control of edible fish. Fil: Ponce, L.V.. Puerto Industrial Altamira; México Fil: Flores, T.. Puerto Industrial Altamira; México Fil: Sosa Saldaña, M.. Puerto Industrial Altamira; México Fil: Alvira, Fernando Carlos. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - La Plata. Centro de Investigaciones Ópticas. Provincia de Buenos Aires. Gobernación. Comisión de Investigaciones Científicas. Centro de Investigaciones Ópticas. Universidad Nacional de La Plata. Centro de Investigaciones Ópticas; Argentina Fil: Bilmes, Gabriel Mario. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - La Plata. Centro de Investigaciones Ópticas. Provincia de Buenos Aires. Gobernación. Comisión de Investigaciones Científicas. Centro de Investigaciones Ópticas. Universidad Nacional de La Plata. Centro de Investigaciones Ópticas; Argentina. Universidad Nacional de La Plata. Facultad de Ingeniería; Argentina

International audience; A commercial butane micron troch was used to enhance plasma optical emissions in laser-induced breakdown spectroscopy (LIBS). Fast imaging and spectroscopic analyses were used to observe plasma evolution in the atmospheric pressure for LIBS without and with using a micro torch. Optical emission intensities and signal-to-noise ratios (SNRs) as functions of delay time were studied. Enhanced optical emission and SNRs were obtained by using a micro torch. The effects of laser pulse energy on the emission intensities and SNRs were studied. The same spectral intensity could be obtained using micro torch with much lower laser pulse energy. The investigation of SNR evolution with delay time at different laser pulse energies showed that the SNR enhancement factor is higher for plasmas generated by lower laser pulse energies than those generated by higher laser energies. The calibration curves of emission line intensities with elemental concentrations showed that detection sensitivities of Mn I 404.136 nm and V I 437.923 nm were improved by around 3 times. The limits of detection for both Mn I 404.136 nm and V I 437.923 nm are reduced from 425 and 42 ppm to 139 and 20 ppm, respectively, after using the micro torch. The LIBS system with micro torch was demonstrated to be cost-effective, compact, and capable of sensitivity improvement, especially for LIBS system operating with low laser pulse energy.

To prevent engine failure it is essential to change lubricating oil regularly before it loses its protective properties. It is also necessary to monitor the physical and chemical conditions of the oil to reliably determine the optimum oil-change intervals. The present work focuses on studying evolution of the cyanide (CN) and carbon (C₂) molecular spectral emission lines in the laser induced breakdown spectra of lubricating oil as a function of its consumption. The intensities of these molecular bands have been taken as indicator of engine oil degradation at certain mileage. Furthermore, the percentage of decay of CN and C₂ integral intensity values at the corresponding mileage was calculated in order to relate it to the degree of consumption of the motor oil. Such percentage decay of the CN and C₂ integral intensities have been found to increase gradually with increasing mileage which is accompanied with increasing depletion of engine oil. The results of using LIBS technique in the present measurements proved that it is possible to have a direct, straightforward and easy method for prediction of lubricating oil degree of consumption. This may facilitate scheduling the proper time and/or mileage intervals for changing the oil to avoid any possibility of engine failure.

Direct and fast detection of trace selenium in water, without any form of pre-concentration, is demonstrated. Laser-induced breakdown spectroscopy and laser-ablation-assisted laser-induced fluorescence are used, achieving limits-of-detection down to 56 ppm and 315 ppb, respectively., Optics and Photonics for Sensing the Environment, June 22-26, 2020, Washington, DC