Search

Experimental tests of cross-laminated timber (CLT)-concrete composite floor panels were conducted. The tests consisted of linear-elastic tests of square CLT-concrete composite panels with a novel shear connector to determine elastic orthotropic plate properties. After the linear-elastic tests, the panels were subjected to a patch load at the center of the panel and tested to failure. To investigate load transfer across longitudinal joints between adjacent panels, nonuniform bending tests were conducted. Results from the experimentally measured orthotropic plate properties showed that the shear connector increased the bending stiffness in the weak direction of the panel compared to prior test results using conventional shear connectors. The tests to failure exhibited larger differences in behavior between the strong and weak orientations of the specimens, with both showing substantial inelastic behavior prior to failure. Numerical finite element models of the patch-load test showed good agreement with experimental results. Analytical formulas using the obtained orthotropic plate properties did not agree with experimental results for the patch-load at linear scales, suggesting the simplified method is currently not suited for CLT-concrete two-way bending. Load-transfer tests found that the reinforced concrete topping is capable of transferring load across the longitudinal joint of two parallel panels to enable two-way bending of composite timber–concrete floors and that the addition of a plywood spline with closely spaced screws enables a higher degree of force transfer. [ABSTRACT FROM AUTHOR]

Over the past decade, cross-laminated timber (CLT) panels have gained popularity worldwide. To achieve larger spans and to increase the resistance to diaphragm seismic and wind forces to be transferred through CLT floor or roof systems, CLT-concrete composite (CCC) floors have been developed as an alternative. While significant testing has been performed under gravity loading, limited experimental data exist on the in-plane performance of CCC systems. This study presents results from an experimental program designed to characterize the in-plane shear behavior of CCC diaphragm connections using different CLT to concrete screw connector orientations in a test setup that simulates the expected seismic load path in diaphragms for platform-type construction. Tested variables include concrete slab thickness, composite screw angle, and single spline connection systems consisting of nails or screws. Experimental results and observed damage progression from cyclic testing are presented and discussed. Results indicate that CCC systems achieved increased stiffness and strength values when compared to bare-CLT systems, but slab thickness did not influence the strength and stiffness of the system for the load paths simulated. Additionally, CCC floor systems with 45° composite screw connectors displayed increased strength but overall similar stiffness values when compared to the CCC systems with 90° composite screws. The results provide useful engineering parameters, such as elastic stiffness, peak load, displacement capacity, and ductility ratios that can be used in the development of codified design parameters or in performance-based designs. [ABSTRACT FROM AUTHOR]

• Twenty in-plane shear tests on CLT surface spline connections were performed. • Splines were constructed using nails and three different screw spacings. • Nail spline connections were more ductile than the screw connections. • An engineering performance model for the CLT splines is presented. Cross-laminated timber (CLT) panels have been used as structural diaphragm elements that form the primary lateral force-resisting system in mass-timber buildings. To better understand the overall performance of CLT diaphragms, an experimental program including monotonic and cyclic in-plane shear panel-to-panel spline connections tests was conducted. The spline connections were constructed using nails and screws with different spacings. Experimental results from the testing program allow for characterization of the performance of the connection systems in terms of elastic stiffness, strength, and ductility. Based on the results of this specific testing program, nailed spline connections displayed similar performance in terms of stiffness and strength and were more 58.7% more ductile than the screw connections, which is partly explained by the larger overstrength factors observed for the screw connections. A simplified performance model is presented to aid designers in determining the elastic, inelastic, and post-peak force parameters of the various spline connections tested. [ABSTRACT FROM AUTHOR]