Search

Advanced Television Systems Committee (ATSC) 3.0, a recently developed terrestrial broadcasting standard, supports a Single Frequency Network (SFN), which extends service coverage and enhances received field strength without additional frequency resources. In SFN, multiple transmitters emit identical ATSC 3.0 broadcasting signals, which may cause constructive or destructive interference on a receiver side. The worst situation occurs when two signals from different transmitters are received with the opposite phase and similar power within a sample time, causing the cancellation of the received signal. In order to prevent such signal cancellation, ATSC 3.0 adopted transmitter diversity code filter sets (TDCFS), which is a frequency domain pre-distortion scheme to minimize cross-correlation among multiple transmitter signals in SFN. This paper sets up an ATSC 3.0 SFN consisting of two transmitter sites, transmitting high definition (HD) for mobile service and 4K ultra high definition (UHD) for fixed service. Layered division multiplexing (LDM) and time division multiplexing (TDM) are used to simulcast the two services with different robustness in the same radio frequency (RF) channel. Then, performance is evaluated using a threshold of visibility (ToV) and a successful reception rate. The time and frequency channel responses are changed at the same reception area when TDCFS is applied so the results show that reception performance is improved in the worst situation in SFN. [ABSTRACT FROM AUTHOR]

This paper presents Internet protocol (IP)-based convergence of broadcast and broadband networks using Advanced Television Systems Committee (ATSC) 3.0–the next generation terrestrial broadcasting standard. In the broadcast network, the combination of Layered Division Multiplexing (LDM) and Scalable High Efficiency Video Codec (SHVC) is used, enabling efficient use of spectrum when mobile and fixed services are intended in a single radio frequency (RF) channel. The proposed use case of IP-based convergence is that a service is largely consumed through the high power high tower (HPHT) based broadcast network, and then alternative streams are requested via unicast for areas where broadcast signals are not receivable. The implementation details of broadcast and broadband convergence include MPEG Media Transport (MMT)/Real-time Objective delivery over Unidirectional Transport (ROUTE) description for broadcast useand Dynamic Adaptive Streaming over HTTP (DASH) for broadband use. To achieve seamless convergence between broadcast and broadband, transmission and reception systems based on ATSC 3.0 are hardware-developed and their implementation details are described. The proposed IP-based convergence use case of ATSC 3.0 broadcast and broadband is verified in a real-field environment using a public cellular network. [ABSTRACT FROM AUTHOR]

This paper presents implementation and memory use aspects for layered division multiplexing (LDM) technology defined in the next generation terrestrial broadcast standard, called advanced television systems committee (ATSC) 3.0. As LDM becomes a new method that combines multiple broadcast contents, its practical considerations on transmitter and receiver implementations as well as memory usages are described in this paper. When multiple physical layer pipes are used, the feasibility of the implementation and memory use aspects are discussed, and the performance analysis in comparison with other multiplexing techniques that ATSC 3.0 offers is shown. [ABSTRACT FROM AUTHOR]

This paper presents the advanced television systems committee (ATSC) 3.0 physical layer system performances with different modulation and channel coding combinations. Numerous computer simulations, laboratory tests, and field trials are conducted under additive white Gaussian noise, RC20, and RL20 channels. Analysis of the results shows that the measured values in laboratory and field are less than 1 dB away from computer simulation results. This confirms that the ATSC 3.0 physical layer is capable of providing services ranging from ultra-robust reception (negative SNR operation with QPSK and 2/15 low density parity check (LDPC) code) to very high-throughput (over 50 Mb/s with 4096-non-uniform constellation and 13/15 LDPC code) in real field environments. [ABSTRACT FROM AUTHOR]

In the ATSC 3.0 PHY layer standard, a transmitter identification (TxID) signal is defined in order to provide the identification of an ATSC 3.0 transmitter. TxID signal can also be used to find the co-channel and adjacent interference signals, to assist accurate location finding calculation, and to obtain the channel estimation for each transmitter, which can help local service (e.g., targeted advertisement) reception, as well as for emergency alert. For efficient use of spectrum and quality of service improvement, single frequency network (SFN) where all transmitters share a single RF channel is often implemented. The recently developed ATSC 3.0 physical layer standard has been designed to support SFN. For efficient designing, fine-tuning and operating an SFN, it is crucial to identify each transmitter, as well as to adjust transmitting power and emission time of each transmitter. This paper presents TxID for ATSC 3.0, and analyzes its detection performance under very low signal to noise ratio environments and other applications, such as location finding, and channel estimation etc. for each SFN transmitter. [ABSTRACT FROM AUTHOR]

In this paper, we present multiple service configurations based on layered division multiplexing (LDM), which is adopted as a baseline technology of the Advanced Television Systems Committee 3.0 standard. Based on a two-layer LDM technology, a variety of multiple-physical layer pipe (PLP) configurations as well as physical layer framing is introduced depending on the choices of service scenario, time interleaving, and cell addressing. A performance analysis is provided when three different broadcasting services—robust audio, indoor/mobile, and high data rate services—are delivered through different PLPs when a number of broadcasting service scenarios is presented. [ABSTRACT FROM AUTHOR]