Search

Recent studies using short-term manual sampling of sewage followed by off-line laboratory gas chromatography (GC) measurement have shown that a substantial amount of dissolved methane is produced in sewer systems. However, only limited data has been acquired to date due to the low frequency and short span of this method, which cannot capture the dynamic variations of in-sewer dissolved methane concentrations. In this study, a newly developed online measuring device was used to monitor dissolved methane concentrations at the end of a rising main sewer network, over two periods of three weeks each, in summer and early winter, respectively. This device uses an online gas-phase methane sensor to measure methane under equilibrium conditions after being stripped from the sewage. The data are then converted to liquid-phase methane concentrations according to Henry's Law. The detection limit and range are suitable for sewer application and can be adjusted by varying the ratio of liquid-to-gas phase volume settings. The measurement presented good linearity (R² > 0.95) during field application, when compared to off-line measurements. The overall data set showed a wide variation in dissolved methane concentration of 5-15 mg/L in summer and 3.5-12 mg/L in winter, resulting in a significant average daily production of 24.6 and 19.0 kg-CH₄/d, respectively, from the network with a daily average sewage flow of 2840 m³/day. The dissolved methane concentration demonstrated a clear diurnal pattern coinciding with flow and sulfide fluctuation, implying a relationship with the wastewater hydraulic retention time (HRT). The total dissolved sulfide (TDS) concentration in sewers can be determined simultaneously with the same principle.

Intermittent dosing of free nitrous acid (FNA), with or without the simultaneous dosing of hydrogen peroxide, is a new strategy developed recently for the control of sulfide production in sewers. Six-month field trials have been carried out in a rising main sewer in Australia (150 mm in diameter and 1080 m in length) to evaluate the performance of the strategy that was previously demonstrated in laboratory studies. In each trial, FNA was dosed at a pumping station for a period of 8 or 24 h, some with simultaneous hydrogen peroxide dosing. The sulfide control effectiveness was monitored by measuring, on-line, the dissolved sulfide concentration at a downstream location of the pipeline (828 m from the pumping station) and the gaseous H2S concentration at the discharge manhole. Effective sulfide control was achieved in all nine consecutive trials, with sulfide production reduced by more than 80% in 10 days following each dose. Later trials achieved better control efficiency than the first few trials possibly due to the disrupting effects of FNA on sewer biofilms. This suggests that an initial strong dose (more chemical consumption) followed by maintenance dosing (less chemical consumption) could be a very cost-effective way to achieve consistent control efficiency. It was also found that heavy rainfall slowed the recovery of sulfide production after dosing, likely due to the dilution effects and reduced retention time. Overall, intermittent dose of FNA or FNA in combination with H2O2 was successfully demonstrated to be a cost-effective method for sulfide control in rising main sewers., (Copyright © 2013 Elsevier Ltd. All rights reserved.)