Search

When processing difficult-to-cut materials, conventional turning (CT) typically suffers from the problems of large cutting force, difficult chip removal, and serious tool wear, resulting in deteriorated processing quality, reduced processing efficiency, and increased processing costs. In addition, special-purpose machine tools used for ultrasonic machining exhibit disadvantages, such as narrow application scope, high manufacturing cost, and poor universality; thus, they are not conducive to being popular in actual production and processing. Accordingly, this study analyzed the characteristics of ultrasonic wave, the mechanism of ultrasonic vibration-assisted turning (UAT), and the formation of a machined surface in UAT. Moreover, the machining system of UAT was established. This system applied an ultrasonic wave vibration device to an engine lathe to meet the requirements of vibration cutting in actual production. Simultaneously, Inconel 718, a typical and widely used difficult-to-cut material, was selected for the experimental study. The machining effect of UAT was analyzed in detail, including surface roughness, surface topography, and chip shape. Results indicated that ultrasonic amplitude, cutting speed, depth of cut, and feed rate exert considerable influences on the machining effect. UAT can achieve this effect, which is difficult to realize via CT, under the condition of a reasonable selection of technological parameters. This research can provide theoretical support and experimental basis for the development and practical application of UAT. [ABSTRACT FROM AUTHOR]

This research study focuses on the experimental analysis of the three-dimensional (3D) surface topography and surface roughness of the workpiece machined with ultrasonic vibration assisted turning (UAT) in comparison to conventional turning (CT). For the challenge that machining difficulties of 304 austenitic stainless steel (ASS 304) and high demands for the machined surface quality and machining precision represent, starting with cutting principle and processing technology, the ultrasonic vibration method is employed to scheme out a machining system of ultrasonic vibration assisted turning (MS-UAT). The experiments for turning the workpiece of ASS 304 are conducted with and without ultrasonic vibration using the designed MS-UAT, and then the 3D morphology evaluation parameters Sa and Sq are applied to characterize and analyse the machined surface. The experimental results obtained demonstrate that the process parameters in UAT of ASS 304 have obvious effect on the 3D surface topography and surface roughness of machined workpiece, and the appropriate choice of various process parameters, including ultrasonic amplitude, feed rate, depth of cut, and cutting speed, can enhance the machined surface quality efficiently to make the machining effect of UAT much better than that of CT. [ABSTRACT FROM AUTHOR]