Search

High step-down dc/dc converters are widely utilized in telecom and modern industrial applications. Due to the high step-down ratio, conventional Buck converter cannot provide satisfactory performance. To solve this problem, quite a few new topologies have been proposed to improve the performance of high step-down dc/dc converters, such as series-capacitor Buck (SC-Buck) converter, 3-level Buck converters, tapped inductor Buck converters, and LLC resonant converters. In this paper, the twice step-down benefit of SC-Buck converter and the zero-voltage switching benefit of series-capacitor tapped Buck (SC-TaB) converter are combined together to propose a new topology: interleaved series-capacitor tapped Buck (ISC-TaB) converter. To analyze the performance of the proposed ISC-TaB converter, the operation principles are discussed and the voltage conversion ratio is derived. In addition, to guide the design procedure and optimization, the current waveforms and voltage waveforms of the proposed ISC-TaB are derived. In order to verify the performance of the proposed ISC-TaB, hardware prototype of the proposed ISC-TaB converter and conventional two-phase series-capacitor tapped Buck converter (2ph-TaB) are designed and tested. The application is targeted at telecom with 48-V input and 3.3 V/20 A output. The test results are compared between these two converters. A peak efficiency of 95.6% is achieved on the proposed ISC-TaB and the efficiency of the ISC-TaB over all load range is at least 1% higher than that of 2ph-TaB. [ABSTRACT FROM AUTHOR]

This paper introduces a MultiTrack power conversion architecture that represents a new way of combining switched-capacitor circuits and magnetics. The MultiTrack architecture takes advantages of the distributed power processing concept and a hybrid switched-capacitor/magnetics circuit structure. It reduces the voltage ratings on devices, reduces the voltage regulation stress of the system, improves the component utilization, and reduces the sizes of passive components. This architecture is suitable to dc–dc and grid-interface applications that require both isolation and wide voltage conversion range. An 18–80 V input, 5 V, 15 A output, 800 kHz, 0.93 in $^2$ (1/16 brick equivalent) isolated dc–dc converter has been built and tested to verify the effectiveness of this architecture. By employing the MultiTrack architecture, utilizing GaN switches, and operating at higher frequencies, the prototype converter achieves a power density of 457.3 W/in$^3$ and a peak efficiency of 91.3%. Its power density is 3$\times$ higher than the state-of-the-art commercial converters with comparable efficiency across the wide operation range. [ABSTRACT FROM AUTHOR]